Q1/ The angle shown in figure down are measured with a total station. Theobserved values, with weights, are listed as follows:AngleObserved valueWeight44° 50' 44"11246° 10' 25"31345° 55' 12"31443° 04' 03"31548° 32' 45"31642° 27' 42"115Use the method of least square (condition method) to determine adjusted valuefor these angles.

The method "least squares" is a kind of mathematical analysis of regression which determine the best…

Q1/ The angle shown in figure down are measured with a total station. The observed values, with weights, are listed as follows: Angle Observed value Weight 44° 50' 44" 1 13 12 46° 10' 25" 3 13 45° 55' 12" 3 14 43° 04' 03" 15 48° 32' 45" 14 l6 42° 27' 42" 1 15 Use the method of least square (condition method) to determine adjusted value for these angles.

Q1/ The angle shown in figure down are measured with a total station. The observed values, with weights, are listed as follows: Angle Observed value Weight 44° 50' 44" 1 13 12 46° 10' 25" 3 13 45° 55' 12" 3 14 43° 04' 03" 15 48° 32' 45" 14 l6 42° 27' 42" 1 15 Use the method of least square (condition method) to determine adjusted value for these angles.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

I need a quick solution within 10 minutes With my best wishesTon.
In levelling across a wide river on pampanga, a reciprocal level readings were taken between point b and c as shown in tabulation. Compute the difference in elevation between B and C with instrument set up near B.
A transit with a stadia interval factor of 100.12 was set at C on the line between points A and B, the following stadia readings were observed. (draw the Instrument set up) Stadia Hair Readings (m) Rod Position Vertical Angle Upper (a) Middle (c) Lower (b) Rod Held at A - 50 17 1.318 1.148 0.978 Rod Held at B + 20 21' 2.048 1.882 1.355 If the stadia constant is 0.29 m determine the following: A. Length of line AB (horizontal). ANSWER: B. If the elevation at B is 76.751m what is the elevation at A. ANSWER:
1. A tachometric surveying was performed by a surveyor. The transit used has a stadia interval factor of 90.98 and stadia constant of 0.16m the instrument was set at station O on the line between station C and E. The following stadia readings were taken Position of staff Vertical angle 7-18°37'02" 6°15'58" Station C Station E upper 1.432m 2.825m Stadia hair reading center 1.195m 2.049m Determine the horizontal and vertical distance between C and E lower 0.957m 1.274m
A pipeline transporting natural gas is to be laid out on the side of a hill (from pt. A to pt. B) as shown in the figure. Trigonometric leveling was performed where a transit (with a stadia factor of 100.8 and stadia constant of 0.38) was set at pt. C somewhere between pts. A and B. The following readings were observed. Vertical Angle Hair Readings (m) Upper Middle Lower Rod at A + 15° 25' 1.972 1.854 1.732 Rod at B - 9° 07' 1.330 1.175 1.010 A Inclined Pipe В How long is the inclined section of the pipe? Determine the material cost of the inclined pipe to be installed if the material costs P 5,000/meter.
2/A- The following data were obtained by stadia observation: zenith angle = 81° 50', s = 2.50 ft. The stadia interval factor is known to be 0.75 and K = 1 ft. Calculate H and V. 02/B- The following table gives the Departure Latitud
1) 2 points B & C were observed from point A where the instrument was set up at a height of 1.25m. Points B & C are ahead of point A. The surveyor used an internally focusing telescope with a stadia interval factor of 100. The table below shows the data recorded as observed for points B & C. Answer the following. (Show complete figures and solutions) a) What is the stadia constant of the instrument? b) What is the slope distance between the telescope at point A and the rod reading at point B? c) What is the difference in elevation between point B & C? d) What is the slope distance between the ground surface at point B and the ground surface at C? e) What is the elevation of point C if point A is at an elevation of +0316.15m above mean sea level? - 1 attachment Vertical Stadia Hair Readings ROD/Point Angle Upper Middle Lower В -25°15' 2.316 1.877 1.438 -45°57' 3.333 2.011 0.689
Note:hand written solution should be avoided.
i need the answer quickly
b) Ten measurements of an angle are given in Table 1. Compute the mean of the angle x, the standard error of a single measurement, and the standard error of the mean. Table 1 Observation No. Measured angle 1 31° 02' 29.3" 31° 02' 24.0" 3 31° 02' 27.9" 4 31° 02' 26.8" 5 31° 02' 26.1" 31° 02' 25.9" 7 31° 02' 26.1" 8. 31° 02' 27.8" 9. 31° 02' 27.2" 10 31° 02' 28.0"
surveying errors and mistakes
D= Distance V= Vertical Dist S= Sight Distance Topic: Tacheometric Surveying Pls answer in COMPLETE solution. DIAGRAM/ILLUSTRATION of the solution is a must, for better understanding. 3 dec places all answers.