Q1: A. What is the Ruling gradient (intial slope) Sd ? B Elevation 763 So Elevation 100 m 20000 m 500 m 500 m 1000m R2= 1500 m R1= 800 m R3=700 m Lr = 300 m Lr = 700 m Lr = 1000 m Lt = 500 m Q1: B. What are the necessary slopes in each section Q1: Dangerous slopes Q1: Necessary brake force

Q: Q1// Complete the leveling table given below. If an even upward gradient of lin 20 starts at station…

A:

Q: A rectangular channel (n=0.011) 18m wide is to carry water at a flow rate of 35 m3/s. The slope of…

A:

Q: 0. Estimate the value of Sf if the value of bed lope is 1 in 800 and and ddx = 10-3m. 0015

A: To find : Value of sf Given: dE/dx=10-3

Q: Calculate the cost required to construct a premix layer having bulk specific gravity of 2.239 and…

A: Solution: Given: width = 7m  length = 2 km Thickness = 46 mm Bulk specific gravity = 2.239 material…

Q: For the following data, compute the horizontal distances from the recorded slope lengths AB. You…

A:

Q: Mannings

A: We have equation :V=1.49nR23S

Q: Briefly explain the meaning of FS = 1.0 for sand followed by the infinite slope analysis.

A:

Q: 5.10 How can slope affect soil development?

A: Given data  Slope Soil development

Q: PROBLEM 2: Find the required slope of the channel bottom when water flowing at the rate of 5.82…

A:

Q: 1. Calculate the plastic modulus of this section about y-y axis.

A:

Q: Determine the volume of the embankment

A: Slope: - It is defined as the ratio of vertical change to horizontal change in a given distance.

Q: Why does Newton's method consistently outperform gradient descent?

A: Newton's method and gradient descent method are used in numerical optimization Required: To explain…

Q: 2. Solve the equations Ax = b where 1.44 -0.36 5.52 0.00 0.04 -0.36 10.33 -7.78 0.00 -2.15 A = b =…

A:

Q: versus n for each of the five variables. What do the results suggest about the importance of the…

A:

Q: nstructions: Solve the following problems completely using Virtual Work Method. 15 kN/m Problem 2…

A:

Q: Problem 3: A house with 932 kN weight is built on a steep slope defined by points A, B, and C. To…

A: Write the weight in vector form. W→=-932k^ Here, k^ represents the unit vector in the z-direction.…

Q: A trapezoidal channel is to be designed to carry 280m3/minute of water. Determine the cross –…

A:

Q: Water flows in the channel shown in the figure below at a rate of 90 ft³/s. Determine the minimum…

A: Given  Q= 90 ft3 /s  n= 0.014

Q: 13.20 The slope shown in Figure 13.53 has recently failed. A geotechnical investigation indicates…

A: To back-calculate the value   using the Swedish slip circle method without a diagram or table, we…

Q: A stone has initial velocity of 200 fps up to the right at a slope of 4 to 3. The components of…

A: Radius of curvature at start of the path is calculated by :    R = u2gcosθ  Given initial velocity u…

Q: Between the ground points, A and B, is 39.50 m and the horizontal distances between the two points…

A: NOTE: as per our guidelines we are supposed to answer only 3 sub parts. Please repost others…

Q: 2. A slope based on a relationship between water depth and critical depth is called a) Hydraulic…

A: To find : What is known as slope based on relation between water depth and critical depth

Q: (ii) The readings given below were made with a tacheometer theodolite having a multiplying constant…

A: Answer  Given data The elevation of station A = 100.00 m  The height of instrument (HI) = 1.35 m…

Q: to derive the safety factor formula for infinite slope stability

A:

Q: P kN/m B C L L 2 5)(Lx^2)+(P/48)(Lx^3) 5)(Lx^2)+(P/48)(L^3) |(Lx^2)+(P/48)(x^3)

A:

Q: Which of the following is the quantity of earthwork for one hundred meters of length for portion of…

A: Length L=100m Width=10m

Q: he stabilization of roads is not done in Subgrade Base Subbase Surface Layer

A: The stabilization of roads is not done in surface layer.

Q: Figure No. 5 Given q = 100 N/m, P = 60 N and Mo = 1000 N.m. L1 = Sm, L2 = 2m, and L3 = 2m M

A:

Q: Calculate the factor of safety for the proposed slope failure surface shown. The radius of the…

A: The factor of Safety: The factor of safety is the determination of the safety of the structure. The…

Q: Question What is the value of gradient of the line RS, if the horizontal distance between the two…

A: Given data,  Distance between R&S = 200 m RL at R = 103 m RL at S = 99 m

Q: Compute for the Bend Allowance and K-factor. 1. 213.06 Leg Length 1 84.11 R30 BA - Leg Length 2

A:

Q: SITUATION 4 If downward seepage occurs on the same slope from Situation 3, determine H. Specific…

A:

Q: Evaluate the FoS for the below slope, when it is underlain by a hard stratum as shown below: 1:2 H-8…

A:

Q: nooth, concrete-lined, symmetrical channel shown in the Video and in the figure below carries water…

A:

Q: An infinite slope having a slope angle of 0= 15° is constructed from a granular soil. The soil has a…

A: Given: The slope angle is 15o. The saturated unit weight is 19.5 kN/m3. The internal friction angle…

Q: What are the Types of Slope Movements? Name them.

A: Slope movement: Slope movement also known as mass wasting or mass movement, is the process of…

Q: Wo A B.

A:

Q: Current Attempt in Progress Water flows in the channel shown in the figure below at a rate of 90…

A:

Q: HW-2-: Compute the area of cross-section if the formation width is 12 m, side slopes are 1 to 1,…

A: Given data:- The given formation width, b=12 m The side slopes =1 to 1 The average height, (h)=5 m…

Q: In soil slope stability analysis if the maximum driving shear stress is 253kN/m² and maximum…

A: Given: The maximum driving shear stress is 253 kN/m2. The maximum resisting shear stress is 221…

Q: The line loads q1 = 200 KN/m and q2 = 500 KN/m are applied as shown, determine the A6z at point A at…

A: We will take vertical component of loading.

Q: A mountainous area was planned to be surveyed as shown below. The difference in elevation of line NO…

A: W = 394 g = 0.394 Kg

Q: PROBLEM NUMBER 3: The horizontal bar shown (Length = 15.0 feet) restson smooth indlines. Computethe…

A:

Q: 10. A beam, having a effective depth of 450 mm, base of 300 mm, and As of 2000 sq. mm. Have the…

A:

Q: نقطتان (2) * If the formation level at zero chainage is 150 metres and there is rising gradient of 1…

A: