A dumpy kevel is set up and leveled approximately halfway between two points, C and D. The elevation of point C is 135.00 m above mean sea level and the reading on a rod held at this point is 1.52 m. If the reading on the road held at point D is 2.74 m, determine the difference in elevation between the two points. Also, determine the elevation of point D.

A dumpy kevel is set up and leveled approximately halfway between two points, C and D. The elevation of point C is 135.00 m above mean sea level and the reading on a rod held at this point is 1.52 m. If the reading on the road held at point D is 2.74 m, determine the difference in elevation between the two points. Also, determine the elevation of point D.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem no. 5: A grade of -2.7% grade intersects a grade of +1.6% at Station 12 + 252.10 of elevations 20.21 meters. These two center grade lines are to be connected by a 111-meter symmetrical vertical parabolic curve. 31. Find the distance of the lowest point from PVC. 32. At what station will the cross-drainage pipes be situated? 33. Find the vertical distance between PC and PI. 34. Find the distance between PC and the lowest point. 35. If the overall outside dimensions of the reinforced concrete pipe to be installed is 100 cm, and the top of the culvert is 50 cm below the subgrade, what will be the obvert elevation at the center?
show the plotting and solution
Q7: An open drain carrying a discharge of 4 m3/sec, side slope 1:1.5, permissible velocity 90 m/min, what is the value of longitudinal slope depending on the most economical section if you know that Chezy coefficient is 45? *
Determine the A6z = at a point 3.00 meters from the inclined lineload and 2.5 meters deep. u = 0.35 91 = 300 KN/m 92 = 500 KN/m 40 ° 6.00m 3.00 m Z = 2.50 m
detailed solution pls.
Solve this question
A 600 meter radius curve is introduced between straight portions of a Broad Gauge measuring 1750 mm Railway line intersecting- to form a total deviation of 70 degrees. The speed for determining the equilibrium cant is fixed at 80 kph and the maximum sectional speed is 110 kph while booked speed is 50 kph. The maximum permissible cant and cant deficiency are 165 mm. and 100 mm. respectively. On Broad Gauge Cant Excess should not be allowed to exceed 75mm. Calculate the Length of transition in meters ( largest value) using the following equations stated below: (a) L= 0.008 C, X V (b) L= 0.008 C, X V, (c) L=0.72 C Where : L = the length of transition in metres. V = maximum pemissble speed in kmph. C, = cant deficiency in millimetres. C, = actual superelevation on curve in millimetres Centrifugal Force Resultant Foree Weight Superelevation
The two drifts shown in figure below are to be connected. Find the distance, the bearing of the centre line, the angle right at each end, and the grade of the connection. The elevations refer to the track as shown in figure 249 O 250 S 75° W 261 N 7900 260 0 N 80º E E 10700 Elev. 4500m N 6700 E 8500 Elev. 3700m
How deep will water flow in a 90° V-shaped flume, n = 0.013, laid on a grade of 0.00040 if it is to carry 2.55 m /s? a. 0.921 b. 0.534 c. 1.57 d. 2.05
(i) Define critical path. (ii) What is direct cost slope? O (iii) Explain FLOAT and slack.
6. Three points A, B, C are marked on the centerline of a roadway. Line AB has an upward slope of 3.6% while BC has a downward slope of 2.5%. The horizontal distance AB is 75m and BC is 105m. Determine the difference in elevation between points A and C. a. 1.75m b. 0.70m c. 0.25m d. 1.10m PLS INCLUDE SOLUTION
Can you please solve this