Q/ A wastewater treatment use an activated sludge process for secondary treatment of 10000 m/day for municipal wastewater. After primary clarification, The BOD is 150 mg/L, and it is desired to have not more than 7 mg/L of soluble BOD in the effluent. The mixed liquor has a concentration of 3000 mg/L and underflow solids concentration is 12,000 mg /L from the secondary clarifier. The kinetic constants from a bench scale treatability study are Y=0.5 and K=0.05 day'. Assume the cell residence time is 10 days. Determine: a. The volume of the activated sludge tank & the hydraulic residence time. b. The sludge production rate & the sludge wasting flow rate. c. The sludge recycle ratio and recycle flow rate. d. The organic loading rate.

Q/ A wastewater treatment use an activated sludge process for secondary treatment of 10000 m/day for municipal wastewater. After primary clarification, The BOD is 150 mg/L, and it is desired to have not more than 7 mg/L of soluble BOD in the effluent. The mixed liquor has a concentration of 3000 mg/L and underflow solids concentration is 12,000 mg /L from the secondary clarifier. The kinetic constants from a bench scale treatability study are Y=0.5 and K=0.05 day'. Assume the cell residence time is 10 days. Determine: a. The volume of the activated sludge tank & the hydraulic residence time. b. The sludge production rate & the sludge wasting flow rate. c. The sludge recycle ratio and recycle flow rate. d. The organic loading rate.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: For a spiral membrane filtration system, the membrane was fabricated by adding additional shims to…

A: step 1-

Q: P.C. V, X, S S.C. Qs Xg, Sp Act. Sludge Basin RAS Q, S, Xp WAS Qw, Sun Xw

A: 1. V=5222 m3 2. Qw=121.8 m3/day 3. Qe=25798.2 m3/day 4. t=4.8 hours

Q: Raw primary sludge at a solids concentration of 4% is mixed with waste activated sludge at a solids…

Q: wet sludge contains 3% solid by weight is pumped to a filter belt press at the rate of…

A: wet sludge contains 3% solidFilter rate = 170,000 lb/dayTo calculate the amount of nitrogen (lb/day)…

Q: A completely mixed activated sludge plant treats wastewater at a rate of 2,565 m³/d. The influent…

Q: The 550-bed Atlanta Hospital has a small, activated sludge plant to treat wastewater from the…

A: Given, V = 10 m x 10 m x 5 m N = 550 q = 1.50 m3 per day per bed To find : Aeration time

Q: A completely mixed activated sludge process is being designed for a wastewater flow of 3 MGD using…

A: Q=3 MGD Influent soluble BOD=180 mg/L Effluent soluble BOD=10 mg/L The mean cell residence time () =…

Q: problem 4: A wastewater treatment plant with an average daily flow of 0.25 m³/s must meet 30 mg/L of…

A: Part e) is not in your question but if you want it then only write otherwise leave that.

Q: In activated sludge system, SRT is governed by

A: Activated sludge system:

Q: 2. The suspended solids content is determined earned by fittering a portion of sample them a…

Q: There is a sewage sludge with volume containing a certain moisture content p, (percent). What will…

Q: In a biological wastewater treatment system, which of the following conditions could be considered…

A: Anoxic conditions refer to which conditions in molecular oxygen is absent, which means electron…

Q: 6. A tertiary treatment plant treats a municipal secondary effluent and is to employ fixed-bed…

A: Reference : Environmental Engineering, Waste water treatment plant. Given : Flow, COD, Contact time…

Q: A secondary treatment using a mixed water activated sludge system, have the flow rate of…

A: simple activated sludge process diagram and their simple formula

Q: (a) What is the maximum contaminant concentration that is expected at a location 2 km downstream of…

A: a) - Discharge(Q) = 2m3/s B= 5m D= 1m Velocity = QB*D V= 25*1 = 0.4m/s Time taken to travel…

Concept explainers

Integrated Solid Waste Management

Integrated Solid Waste Management (ISWM) is a thorough waste suppression, compost, removal and recycling Program. An effective ISWM system considers how to suppress, manage and recycle solid waste in a manner that is most efficiently to protect human health and the surrounding. ISWM system requires evaluation of public wants and demands and then selecting and merging the most effective waste management activities for the proposed demands. The main ISWM activities for solid waste management are Waste prevention, Recycling and Composting, and Combustion and Removal and waste collection in a properly planned, constructed, managed and mitigated landfill areas. Each of these requires careful designing, financing, accumulation, and delivery of activities.

Question

Q/ A wastewater treatment use an activated sludge process for secondary treatment
of 10000 m/day for municipal wastewater. After primary clarification, The BOD
is 150 mg/L, and it is desired to have not more than 7 mg/L of soluble BOD in the
effluent. The mixed liquor has a concentration of 3000 mg/L and underflow solids
concentration is 12,000 mg /L from the secondary clarifier. The kinetic constants
from a bench scale treatability study are Y=0.5 and K=0.05 day". Assume the cell
residence time is 10 days.
Determine:
a. The volume of the activated sludge tank & the hydraulic residence time.
b. The sludge production rate & the sludge wasting flow rate.
c. The sludge recycle ratio and recycle flow rate.
d. The organic loading rate.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 : Data

VIEW

Step 2 : Volume and residence time

VIEW

Step 3 : Production and wasting flow rate

VIEW

Step 4 : Recycle flow rate and ratio

VIEW

Step 5 : Organic loading rate (u)

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The saturation DO concentration of a stream is 9.1 mg/L. At a sewage outfall, the DO of the stream is 8.0 mg/L. The stream has a reaeration constant of 4/day and a deoxygenation rate constant of 0.1/day. The initial ultimate BOD in the mixing zone is 200 mg/L. The time after the discharge at which the water will reach its minimum DO is most nearly a) 1.0 hr b) 1.7 hr c) 21 hr d) 34 hr e) calculate the minimum DO (in mg/L).
The wastewater from a synthetic textile manufacturing plant is discharged to a municipal treatment plant for processing with domestic wastewater. The characteristics of the synthetic textile wastewater are 1500 mg/L BOD, 2000 mg/L SS, 30 mg/L nitrogen, and no phosphorus. The characteristics of the domestic wastewater are 200 mg/L BOD, 240 mg/L SS, 35 mg/L nitrogen, and 7 mg/L phosphorus. Find the BOD, SS of the mixture. The ratio of flow rate is domestic/textile = 4/1
A bio-tower composed of a modular plastic medium of 6 m is used as secondary treatment component in a municipal wastewater treatment plant. Flow from the primary clarifier is 25000 m³/day with 200 mg/1 BOD. The treatability constant is 0.06 per min. To produce an effluent with a soluble BOD of 20 mg/1, the surface area as per Eckenfelder (coefficient related to medium is 0.5) is approximately:
A plug flow and a CFSTR biological reactor are both operating with an influent substrate concentration of 100 and effluent substrate concentration of 90. You also know that q cap =1, Ks = 1000, kd=0.1. which of the following statements is true. Choose one only. a. The PFR will have a much smaller volume than the CFSTR b. The PFR will have a bigger volume than the CFSTR c. The PFR will have the same volume as the CFSTR d. The PFR will be a little smaller than the CFSTR e. The PFR will be a little bigger than the CFSTR
Exercise 4 A treatment plant has the following process diagram. Determine the flow rate expression for each unit. The inflow is Qi. The sludge waste flowrate is Qw. The return flowrate rate is Qr. The mixed liquor return flowrate is Qm. Mixed-liquor return Secondary clarifier Effluent Influent- Anoxic Aerobic Anoxic Aerobic Return activated sludge (e) Bardenpho™ (4-stage) Sludge Exercise 5 Derive the ODE system for above process. There are two species involved in the reaction, as shown below. The process rate for each tank can be simply represented by r1, 12,...15. The gravitational sedimentation is only applied to species X in the clarifier and can be represented by a reaction rate of r5 = 3.5X5. The influent are Xi and S₁. S=X.
The 550-bed Atlanta Hospital has a small, activated sludge plant to treat wastewater from the hospital. The average daily hospital discharge is 1.50 m3 per day per bed, and the average soluble BOD5 after primary settling is 450 mg/L. The aeration tank effective liguid dimensions of 10 m x 10 m x 5 m. The plant operating parameters are as follows: MLVSS - 2,600 mg/L; MLSS - 1.20 (MLVSS); Settling sludge volume after 30 min. = 200 mL/L. The F/M ratio is nearly?
A treatment plant treats water at an average daily flowrate of 2.7 m3/s. The water is chlorinated before it flows into a 15000 m3 reservoir. The water flowing into the reservoir has a chlorine concentration of 3 mg/L. Chlorine decays at a rate of 0.24 h-1. Assume the reservoir is well-mixed and the system is at steady-state condition. (a) Determine the chlorine concentration at the discharge point of the reservoir. (b) The treated water flows from the reservoir into a transmission main. The pipe carrying the water has a diameter of 2 m and flows full. In the transmission main, chlorine decays at a rate of 0.19 h-1. Determine the concentration of chlorine 2 km from the treatment plant.
An anaerobic digester is operated with a hydraulic retention time (HRT) of 25 d and a flow rate of 0.85 m³/d. The influent substrate concentration is 18 g/L and the digestion process is assumed to follow first order kinetics with a Ko value of 0.09 d'¹. Calculate: (a) the liquid volume of the anaerobic digester, V (m³) (b) the effluent substrate concentration, So (g/L)
wet sludge contains 3% solid by weight is pumped to a filter belt press at the rate of 170,000lb/day. the dewatered sludge is 18% by dry weight and the filtrate has total nitrogen concentration of 100 mg/l as nitrogen. assume the belt press has 100% solid capture and specific gravity of the sludge in all forms is 1. Calculate the amount of nitrogen (lb/day) in the filtrate returned? a) 4 b) 9 c) 14 d) 19
A complete mix activated sludge process is to be used for biological treatment. This plant receives 10,000 m³ of wastewater per day with BOD loading of 250 mg/L. The primary treatment efficiency is 25%. Assume the followings: ● ● -4- Plant effluent BOD5 = 12 mg/L Biomass yield = 0.54 kg biomass / kg BOD Endogenous decay rate=0.05 day-¹ Solids Retention Time = 8 days MLVSS concentration in the aeration tank = 2,700 mg/L Waste and recycle solids concentration = 12,000 mg/L Determine the followings: (i). The hydraulic detention time in hours. (ii). The aeration tank volume in cubic meters. ...4/- SULIT EAP582
Wastewater is treated with an activated sludge plug flow reactor, similar to one seen at the Norman Water Reclamation Facility. The BOD5 after primary treatment is 100mg/L and the effluent limit is 5 mg/L BOD5. Use 1.00 h-1 as the maximum specific growth rate constant and typical values for the other biokinetic constants. The biomass concentration in the reactor is 2,500 mg/L MLSS based on a recycle ratio of 1. Calculate the mean cell residence time, in hours for this system
An activated sludge wastewater treatment system was designed and operated in a steadystate under the following conditions:• Reactor volume of 10,000 m3in total;• Sludge concentration (MLSS) of 3200 mg/L in the reactor;• Return sludge concentration at 8000 mg/L (the underflow of the secondary clarifier)• Each day, 400 m3 of underflow sludge (return sludge) was wasted as excesssludge;What is the average Sludge Residence Time (SRT)?