Q-8 The tension member of a roof truss consists of two unequal angles 70 x 45 x 8 with the longer legs connected by 16 mm diameter rivets. If angles are one on either side of gusset plate, then safe tension for the member will be (assuming permissible stress in tension = 150 Mpa and sectional area of angle 858 mm²).

Q-8 The tension member of a roof truss consists of two unequal angles 70 x 45 x 8 with the longer legs connected by 16 mm diameter rivets. If angles are one on either side of gusset plate, then safe tension for the member will be (assuming permissible stress in tension = 150 Mpa and sectional area of angle 858 mm²).

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Trusses 1. Find the stresses of FAB. FAC., FBC & FBD- 20 k 15 k D 60° 60 60° 5' 10 10 Ra Rb
2. Calculate the internal forces in the bar GF and GD in a roof truss as shown below. For each bar, indicate if the internal force is tensile or compressive. Use the section method (snittmetoden). Point A has simple support and D has roller support.
S T R U C T U R A L T H E O R Y
3) Determine the Force in each member of the truss shown in the Figure. (Use the Method of Joints.) D B gl 12' H E 300lb 300lb goolb 9' 9'
Given is a truss structure: Where: Working shear stress for the rivets is 70 MPa Working bearing stress due to rivets is 140 Mpa Thickness of the member is 5 mm Thickness of the Gusset plate is 6 mm Rivet diameter is 15 mm Determine the no. of rivets to fasten the member BD 80 kN 120 kN B. 3 m E 200 kN 4 Panels @ 4 m = 16 m
List all zero-force members of the truss. 1m 2m 2m 2m 2m H 6 m K I D G E C M B L O N e P R 1 kN 2 KN 1kN
Plz
Consider the 21-member truss shown; determine the zero-force members and force in each member then state if they are in tension or compression.(Support on point B and C are pinned and roller, respectively)
Determine the smallest safe cross-sectional areas of members CD, CI and CHfor the truss shown. The allowablestress are 100 MPa in tension and 80 MPa in compression. Indicate tension or compression.(Draw the required FBD and answer in ??2).
From the Given Truss Shown: P= 31 KN M=128 KN Calculate the Force Carried by member Gl. If the member is compression put negative (-) sign. PKNJ h=8m B A PKN D PKN MkN MKN MKN PKN I H -6 panels @ 5 m 30 m PKN
Help