PROBLEM NO. 9 A manufacturer of a certain type of large machine wishes to buy rivets from one of two manufacturers. It is important that the breaking strength of each rivet exceed 10,000 psi. Two manufacturers (A and B) offer this type of rivet and both have rivets whose breaking strength is normally distributed. The mean breaking strengths for manufacturers A and B are 14,000 psi and 13,000 psi, respectively. The standard deviations are 2000 psi and 1000 psi, respectively. Which manufacturer will produce, on the average, the fewest number of defective rivets?

PROBLEM NO. 9 A manufacturer of a certain type of large machine wishes to buy rivets from one of two manufacturers. It is important that the breaking strength of each rivet exceed 10,000 psi. Two manufacturers (A and B) offer this type of rivet and both have rivets whose breaking strength is normally distributed. The mean breaking strengths for manufacturers A and B are 14,000 psi and 13,000 psi, respectively. The standard deviations are 2000 psi and 1000 psi, respectively. Which manufacturer will produce, on the average, the fewest number of defective rivets?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

7. ASTM suggests a tolerance of ... percent to allow the variation in strength as a test of water. A. 12 B. 8 C. 10 D. 15 E. 16 F. None of them
9
ngineering / Civil Engineering / Q&A Library/1 a. a. During a tensile test on a speci... 1 a. During a tensile test on a specimen the following results were obtaineo Load (kN) 15 30 40 50 55 60 Extension 1.03 2.00 2.73 3.42 3.80 4.10 (mm) Diameter at fracture -16.5mm Diameter of gauge length =19mm Gauge length = 150mm Load at fracture - R0KN Gauge length at fracture = 170mm Ultimate load-120kN Plot the load/extension graph to an appropriate scale. Hence determine the i. Modulus of elasticity ii. Percentage elongation iii. Percentage reduction in area iv. The nominal stress at fracture
Please help solve these for my final preparation.
Give me right solution according to the question. Note: If any data missing please assume that data
Kindly give me right solution. Don't copy from other experts solution.
I need answer within 20 minutes please please with my best wishes
Asapp.
PLEASE ANSWER LETTER B THANK YOU!
A plastic cube with a 100 mm X 100 mm X 100 mm. is placed in a pressurechamber and subjected to a pressure of 100 MPa. If the modulus of elasticityis 7 GPa and Poisson’s ratio is 0.39, what will be the decrease in each side ofthe block, assuming that the material remains within the linear elastic region?What will be the decrease in the volume of the cube?
Read the question carefully and give me right solution with clear calculations. Don't copy from other experts solution.
Civil