Problem I. In a high-rise building construction, a boom is being used to efficiently transport materials from the ground to a certain level in the building. Shown below is a figure of the boom supporting the load P=223KN 100 mm 87.5 mm 2P 12.5 r dio B -10 m- At the right is the support detail at R

Q: (a) Based on the figure, give the minimum and the maximum of the external load, P. (b) Based on the…

A: Double D ring Below shows a Double D ring secured with a Nut and Bolt.

Q: hollow cast iron column with the cross section shown in the image attached is subjected ti a…

A: A vertical point load acting at A of magnitude 100kNTo determine the maximum compressive and tensile…

Q: determine the deflection of the free end of the beam.

A:

Q: 0.1 m 0.3 m O.lm N- アニ0.14m 0.1 m レ -0.2 m-

A:

Q: The steel bar has the original dimensions shown in the figure. If it is subjected to an axial load…

A:

Q: A horizontal bar of negligible mass is hinged at A and assumed to be rigid. It is supported by an…

A:

Q: 1. A solid aluminum shaft 2 in. in diameter is subjected to two torques as shown in the figure.…

A: As per the guidelines only first question should be solved if there is no subparts.

Design of structures using FEA

An arrangement, in which various members are interconnected with their constrained relative motion, the whole arrangement is then known as a structure. The degree of freedom of such a structure is zero. In such a structure, the load can act throughout the length of the structure or at the joints.