PROBLEM 4: For the 50-mm-diameter siphon drawing oil (sp gr = 0.82) from the oil reservoir, the head loss from point 1 to point 2 is 1.50 m and from point 2 to point 3 is 2.40 m. Find the (a) discharge of oil from the siphon and, (b) the oil pressure at point 2. 2.00 m 50-mm-diameter siphon Oil (sp gr- 0.82) 5.00 m

Q: If oil has kinematic viscosity 4 x 105 m2/s, and specific gravity is 0.9, flows from the upper to…

A:

Q: What is the critical depth in a rectangular channel with 2.3 m width and 0.91 m2/s discharge per…

A: What is the critical depth in a rectangular channel and calculate minimum specific energy?

Q: A pump out test is carried out in a perforated well of 30 cm in diameter, extending into an…

A:

Q: Assume a chemical solvent, which is denser than water is spilled into the reservoir. How many days…

A: Given:- The thickness of the silty sand stratum = 3.2 m  The hydraulic conductivity of the stratum =…

Q: 1.  For the flow net shown in the figure below, if the datum is selected at the downstream water…

A:

Q: 19. A pump delivers a discharge to head of 30 m. Given, suction lift = 5.58 m, atmospheric head =…

A:

Q: A confined aquifer has a thickness of 30m (m) and is fully penetrated by well where the aquifer is…

A: The thickness of the aquifer(b) =30 m.The pumped rate of the aquifer (q) = 500 liter/sec =0.5m3/sThe…

Q: Glycerin at 20 °C flows upward in a vertical 75-mm-diameter pipe with a centerline velocity of 3.8…

A: i hope its helpfull.thank you.

Groundwater Flow

The term groundwater refers to the water which is found beneath the earth's surface. Pores present in the soil and rocks with fractures make a passage for rainwater to enter the earth's surface and deposit as groundwater. The flow nature and direction of groundwater under the earth's surface directly impacts the strength and compressibility of the soil, which reflects its ability to support structural loads.