Problem 3.3. A solid brass rod AB and a solid aluminum rod BC are connected together by a coupler at B, as shown in Figure ( problem 3.3).The diameters of the two segments are di=60 mm and d =50 mm, respectively. Determine the axial stresses o, (in rod AB) and o2 (in rod BC). 1 (1) B (2) 150 kN 50 kN Figure (problem 3.3)

Problem 3.3. A solid brass rod AB and a solid aluminum rod BC are connected together by a coupler at B, as shown in Figure ( problem 3.3).The diameters of the two segments are di=60 mm and d =50 mm, respectively. Determine the axial stresses o, (in rod AB) and o2 (in rod BC). 1 (1) B (2) 150 kN 50 kN Figure (problem 3.3)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

QUESTION 2) The shaft, first two meters length has a solid cross-section with a diameter of 6 cm and the last one meter length has a hollow cross-section with a inner diameter 5 cm and outer diameter of 6 cm is shown in the figure. If the allowable shear strength tu-35 MPa and shear modulus G=200 GPa, determine the allow magnitude of the torsional moment M for a safe structural system. M M бст IScm B C D lm Im 1m
A beam shown in Figure 7.7 is made of T beam, determine maximum shearing stress develop due to various type of loading. w- 3kN/m A B 2.0m 2.0m 2.0m
Bar A has diameter 'd' and bar B has diameter '2d'. Both are of the same length and are of the same material. If they are subjected to same axial load P, the ratio of extension of bar A to B is (B) 2 (A) 4 (C) 0.5 (D) 0.25
A simple pin-connected truss is loaded and supported as shown in the figure shown. All members of the truss are aluminum pipes that have an outside diameter of 60 mm and a wall thickness of 4 mm. Determine the normal stress in truss AC in MPa. 1.5 m O 62.5 63.9 O 71.2 66.4 1.0 m B 3.3 m 15 kN 12 kN
Problem 6 For the structure shown in the figure, determine the normal and shear stresses at point A on the cross section of the pipe. at section a-a. mun 40 mm 300 mm 300 mm
4. Two solid shafts of different materials are rigidly fastened together and attached to rigid supports as shown in the figure together with the given section properties. The torque of 1000 N-m is applied at the junction of the two segments. Compute the maximum shearing stress developed in the assembly. Answer: TĄ = 5.57 MPa Ts = 22.0 MPa 3 m 1.5 m Ta Aluminum Steel 75 mm dia. T=1.0 kN•m Ga- 28 GN/m²? 50 mm dia G, - 83 GN/m?
6.