Problem 2: Ajet of water moving at 20 m/s impinges on a symmetrical curved vane shaped to deflect the jet through 120° (that is the vane angles e and are each equal to 30°). If the vane is moving at 5 m/s, find the angle of the jet so that there is no shock at inlet. Also determine the absolute velocity of exist in magnitude and direction, and the work done.

Problem 2: Ajet of water moving at 20 m/s impinges on a symmetrical curved vane shaped to deflect the jet through 120° (that is the vane angles e and are each equal to 30°). If the vane is moving at 5 m/s, find the angle of the jet so that there is no shock at inlet. Also determine the absolute velocity of exist in magnitude and direction, and the work done.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Q7- Air flowing with a Mach number of 2 with a pressure of 80 kPa and a temperature of 30 °C passes over a component of an aircraft that can be modeled as a wedge with an included angle of 8° that is aligned with the flow, the flow is turned through an angle of 4 leading to the generation of an oblique shock wave. Find the pressure acting on the surface of the wedge. M 2 P = 80 kPa T = 30°C
Water flows through a venturi as shown in the figure at a flow rate of Q=1.3L/s. The inlet and throat diameters of the venturi meter are (D = 3.0 cm andd = 2.5 cm) respectively. The height of water column in the manometers L1 and L3 are 65 and 53 cm respectively. %3D What is the experimental dynamic head at the throat-{section2} (in m)? L3
Two identical balls can move freely on a horizontal surface. When the balls collide, ball A has a velocity of 10 m/s and ball B is at rest. The coefficient of restitution between the two balls is 1 and the angle 8 = 25°. Assuming no friction, determine: a) the velocity of ball A after the impact. Include both magnitude and direction. b) the velocity of ball B after the impact. Include both magnitude and direction.
Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level inside the tank remains constant at 3m and the pressure at the top of the tank is 30KPA. If the jet strikes the ground horizontally by 4.5m and below the vena contracta by 1m, determine the coefficient of velocity. Hide answer choices A 0.982 B) 0.871 No Answer among the choices D 0.938 0.914
The velocity vector of a flow field is given as; V=-i++ 5 k where a is a constant. a) Determine whether the flow is incompressible or not. Explain. b) Determine whether the flow is steady or not. Explain. c) Determine the numerical value of a, if the vorticity vector is Q = 0.5 k d) Obtain the convective acceleration vector. e) Determine whether the flow is uniform or not. Explain. f) Determine the equation of streamlines of the flow on the x-y plane.
75 mm 75 mm 150 mm d 150 mm d Water 3 m 0.63 m Hg Problem 4.67 Probie 4.67. Calculate the velocity head in the 75 mm constriction.
1- Water flows through a horizontal pipe at a rate of 9.1 L/s. The pipe consists of two sections of diameters 10.16 cm and 5.08 cm with a smooth reducing section. The pressure difference between the two pipe sections is measured by a mercury manometer. Neglecting frictional effects, (a) determine the differential height of mercury between the two pipe sections. (b) How would the reading change if the manometer on the 2in pipe is replaced by a pitot tube? 10.16 5.08 h
Q4: A tank of water empties by gravity through a horizontal pipe into another tank in figure (1) .There is a sudden enlargement in the pipe as shown.At a certain time the difference in levels is 3m.Each pipe is 5m long and has a friction coefficient Cf-0.007 The inlet loss constant is K=0.5 and bore diameter in point A 20mm ,and bore diameter in point B 60mm.Calculate this point. the volume flow rate at Calculate the volume flow rate at this point. (1) 20 mm bore diameter 3 m 60 mm bore diameter (2)
Required information A 90° elbow in a horizontal pipe is used to direct water flow upward at a rate mof 35 kg/s. The diameter of the entire elbow is 10 cm. The elbow discharges water into the atmosphere, and thus the pressure at the exit is the local atmospheric pressure. The elevation difference between the centers of the exit and the inlet of the elbow is 50 cm. The weight of the elbow and the water in it is considered to be negligible. Take the density of water to be 1000 kg/m³ and the momentum-flux correction factor to be 1.03 at both the inlet and the outlet. 50 cm Water m kg/s DATUM: Assume positive up and to the right Determine the anchoring force needed to hold the elbow in place. N. PALLE The anchoring force needed to hold the elbow in place is The resultant direction of the force is
4. An open vessel 0.46-m in diameter, 0.60-m high and full of with water is rotated about its axis at such velocity that the water surface 100-mm from the axis makes an angle of 40 degrees with the horizontal. a. How many liters of water are lost? b. Compute the speed of rotation in rad/ sec.