PROBLEM 1: Both a gage and a manometer are attached to a tank to measure pressure. Given the reading on the pressure gage, determine the differential height h of the mercury column. (Round off ONLY the final resu to three decimal places. Indicate the unit of your final answer) * - Oil SG = 0.72 45 kPa 75 cm Air Water 30 cm - Mercury SG = 13.6 h

Q: Why is drainage clogging occur?

A: 1)Damaged Pipes-Another major cause of blocked drains is broken pipes. For water to flow freely, it…

Q: AGREEN BUILDING DESIGN FOR A GOVERNMENT CENTER, AND BIBAK DORM" STRENGTH WEAKNESS OPPORTUNITY THREAT…

A:

Q: Define Gas sampling.

A: Gas sampling is a method by which the chemical, thermal, and hydrological properties of a surface or…

Q: How is the inspection plan developed?

A: - Inspection plan is developed to provide information on the testing characteristics to ensure the…

Q: What organization publishes the major fire protection requirement manuals?

A: For any firefighters, it is very important to follow the rules and regulations. Every year many…

Q: a) Explain fire hydrant system. (b) Give an overview of fire safety, risk and control.

A: The Fire Hydrant Protection System is an active fire safety device that is made to combat fires of…

Q: I need a literature review on the topic (Enhancing indoor air quality and safe entertainment in…

A: Introduction The significance of safety and indoor air quality (IAQ) in sports venues has drawn more…

Q: A building has an area of 16656 ft2. What is the minimum number of roof drains required?

A: The area of the building = 16656 ft2 We need to calculate the minimum number of drains required.

Q: Describe about the drainage filter.

A: The drainage filter can be defined as it is made up of granular material either natural or processed…

Q: Define the term vadose zone.

A: Vadose zone is defined as the zone which lies between the water table and top of the ground surface.

Q: Write the five basic project planning steps when setting up a CPM Schedule?

A: Critical path is defined as the path when the duration of activities along this paths adds up to…

Finishing Operations

Finishing operations are the processes that are applied to the workpiece at the end of a manufacturing process, and after completing all other relevant operations that bring the product to its required dimensions. Finishing operations involve polishing, reducing the surface roughness, eliminating wrinkling, and grinding to enhance the surface texture and provide a better surface finish to the workpiece surface.