Problem 07.114 - Determine the normal stress and shearing stress in the weld of a steel pressure tank. The steel pressure tank shown has a 38-in. inner diameter and a 0.375-in. wall thickness. It is given that the butt-welded seams form an angle = 50° with the longitudinal axis of the tank and that the gage pressure in the tank is 200 psi.

Q: pipe is hung from a barge, is lowered, new sections a stem enables a good degre- an other laving…

A: height of the pipe, h = 2000 mrmin = 400 mdiameter of the pie, d = 24 inch = 240.0254 = 0.6096 mt=…

Q: Deep sea pipelines are used to transport oil and gas across large distances, at depths greater than…

A: Height of the pipe, h = 2000 mrmin = 400 mDiameter of the pipe, d = 24 inch = 240.0254 = 0.6096 mt=…

Q: A steel tubing has a 1.5-in outside diameter and a 1.210-in inside diameter. It is made of AISI 1020…

A:

Q: A cylindrical pressure tank is fabricated by butt-welding 19 mm-thick plate with spiral seam shown…

A: For solution refer below images.

Q: as is subjected to a static eccentric force of F=25 kN in the plane of the welds. The allowable…

A: Given:- l1=350mm l2=200m d1=37.5mm d2=75mm

Q: Page 5 of 6 4. (20 points) Determine the normal and shear stresses at point A on the cross-section…

A:

Q: Problem 9.38 The steel pipe in (Eigure 1) has an inner diameter of 4.38 in, and an outer diameter of…

A:

Q: Required information Problem 08.041-Determine the principal stresses for the circular cross section…

A:

Q: A thin-walled pressure vessel is made of steel with a thickness of 2 mm and an internal diameter of…

A: According to the given data P=10MPa d=300mm t=2mm We need to find The hoop stress andLongitudinal…

Q: 2 m 10 m

A: As this question is multipart, I will be solving only one question. Diameter of the cylinder is 2…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.