Prob. 8–87

Q: B around the smooth peg at E, a vertical cable at e at D. Determine the weight of the heaviest bar e…

A:

Q: Blocks A and B have masses of 10 kg and 20 kg respectively. The coefficient of static friction…

A:

Q: 2. An open cylindrical tank 0.3m in diam and 0.8m high is filled w/ water. At what angular speed in…

A: GIven: Dia of cylindrical tank d= 0.3 m height of cylindrical tank H= 0.8 m Spilled volume V= 40…

Q: A tower crane is located on the top of a multi-storey building under construction. The steel lifting…

A: Answer We are given Cross section area of cable (A) = 200 mm2  Length of cable (x) = 350 m Load on…

Q: The uniform 20-pound ladder is balanced on the rough floor with ms = 0.8 static friction coefficient…

A:

Q: A concrete beam AB of span 16 m is post-tensioned by a cable which is concentric at supports A and B…

A: Step 1: Step 2: Step 3: Step 4:

Q: Crates A and B weigh 350 lb and 100 lb, respectively. They are connected together with a cable and…

A: Given : Weight of crate A = 350 lb and Crate B = 100 lb  Coefficient of friction between crate and…

Q: 3. What maximum torque (in kN-m) can be applied to a 120-mm- diameter solid shaft if the allowable…

A: The solutions of the given multiple choice questions are given below

Q: H.W Determine the distance s to which the 90-kg painter can climb without causing the 4-m ladder to…

A: Given:- The mass of the painter = 90 kg The length of the ladder = 4 m  The mass of the ladder = 15…

Q: 5. Determine the distance s to which the 70 kg painter can climb without causing the 4 m ladder to…

A:

Q: In the hinged system whose loading condition is given in the figure, in which option are the joint…

A:

Q: Equation of Torsion Question 3: A solid steel shaft is to transmit a torque of 10 kN-m. If the…

A: Torque: Torque is the twisting moment caused in the shaft due to the applied load on the shaft. The…

Q: Q2(a) The overhanging beam shown in Figure Q2(a) has three concentrated loads. If the beam is having…

A:

Q: SITUATION. An 8-m long ladder weighing 900 N is shown in the figure. It is required to determine the…

A:

Q: I tried to solve the problem using your solution and got a different answer. Also where is the angle…

A: To Identify the difference in the solutions

Q: Determine the magnitude of the resultant force. Express your answer to three significant figures and…

A:

Q: Homework: A single lane simply supported concrete beam bridge with a span of L=10 m, the highway…

A: Given:- The length of the bridge span = L = 10 m  The grade of the highway = Grade III The density…

Q: Problem 1. Determine the minimum horizontal force P required to keep the crate from sliding down the…

A: Given:- The mass of the crate = 50 kg The coefficient of friction between the crate and the incline…

Q: Based on the external force P that pushes the wedge B towards the wall, what is the direction of the…

A: Drawing FBD:

Q: The boom of a crane, shown in figure, is constructed of steel, E = 210 GPa. The cross section is…

A: Buckling load: The load under which sudden change in the shape of the structure-like deformation is…

Q: PROBLEM NO. 3 A uniform bar AB is resting in a horizontal position on smooth inclines as shown…

A:

Q: D What load "W" can the seat safely carry? 2 If W = 1500 N, what is the reaction at C. 3 If W = 1500…

A: Tensile load is the capacity of a seat to withstand a pulling force. It is usually measured in units…

Q: A car weighing 114 kN when fully loaded is pulled slowly up a steep inclined track by a steel cable…

A: Given data in question  Load Angle Area To find out  Tensile stress Angle

Q: An elevated water tank weighs 3000kN when filled with water, the centroid of the mass being at a…

A: weight of the tank = 3000 kNhorizontal spring factor for the tank tower =15 kN/mmperiod = 2.0 sec…

Q: A heavy cable with a mass of 12 kg/m passes over the two fixed pipes 300 m apart on the same level.…

A: Introduction- The bridge deck is supported by cables from one or more towers on a cable-stayed…

Q: What is the internal normal force acting on a vertical cross-section passing through the bar between…

A:

Q: (c) Shown in Figure 5, the drop gate at the end of the truck has a mass of 0.5 Mg at point G. It is…

A: Truck acceleration=4.7 m/s2, Mass at point G=0.5 Mg, Increased size of the gate=30%.

Q: Situation A: A beam is attached to a wire on the one end and is rested to an inclined plane on the…

A: Absolutely, here's a brief answer to the beam situation neglecting friction (questions 17 &…

Q: 4. A ladder leans against a smooth wall at 50° from horizontal. The ladder weighs 200N and its…

A:

Q: Problem 13.21 The 450-kg mine car is hoisted up the incline using the cable and motor M. For a short…

A:

Q: A 50 kg fisherman sits at the center of the boat rented in a private resort, which has a uniform…

A: given data ,1lb=0.453kg50kg=110.37lb1ft=0.3048m3m=9.8425ftsee the image for complete…

Q: 1. 2. 3. X 2 -2.5 m3.5 m- 2.5 m D 3 m -3 m- A E m P = 8000 N B C 1.0 m Determine the tensile force…

A: To find tension in cable AD,CE

Q: The 450-kg mine car is hoisted up the incline using the cable and motor M. For a short time, the…

A: Given :

Q: Consider the given beam below. Determine the following: 1. Vertical reaction at the hinge support…

A: Given data:-

Q: SITUATION 10 kN/m -5.0 m- -8.0 m- M1, M2, M3 are moment at supports from left to right.

A:

Q: Level 1 Level 0 Main Beam K= 6 x105 mm³ 7000 mm 300 Main Beam K= 6 x105 mm²³ Secondary Beam K= 9 x…

A: The objective of the question is to determine the effective heights and the slenderness ratios of…

Q: PROBLEM 3. An objeet with mass mi-5.00 kg rests on a frictionless horizontal table and is connected…

A: Let us find the force on each body, mass M2 is having upward tension(T) is pull up and m2g is…

Q: 20 KN 25 KN-m A 25 cm -> 0.25 m D B 15 cm→ 0.15m 2m 2m 4m

A: Note: Hi! Thank you for the question, As per the honour code, we are allowed to answer three…

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.