pressure of 5 kPa. If the center of the outlet pipe is 3 m above the center of the inlet pipe and 500 L/sec of water passes a motor or pump. Which of the following most nearly gives the specific gravity of the block?  a. 1.6320  b. 0.6814 c. 0.3196  d. 1.3186

Q: 120 mm diameter siphon draws water from the reservoir. Considering that the elevation differences,…

A: Given data: Diameter of siphon, d=150 mm=0.15 m ⇒Area, A=π4×d2=π4×0.122=0.01131 m2. Atmospheric…

Q: 2. The pre-setting pressure of the relief valve in the system shown in 2 is P3 =2.5MPA, Po =2MPA…

A: Given  P3 = 2.5Mpa P6 = 2Mpa To find Pressure at pump outlet if  1) Solenoid of valve 4 is energized…

Q: Intravenous infusions usually are driven by gravity by hanging the fluid bottle at sufficient height…

A:

Q: 1st: Using the formula t=24(/h3/h2) determine the "A" of tank Caa/2g coefficient of discharge. Note:…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The fluid power associated with a centrifugal pump is determined to be 93.39 Watts, if the…

A:

Q: A 320 mm centrifugal pump rotating at 1500 rpm develops a head of 16.8 m. The discharge is 0.019…

A:

Q: The air fan increases the pressure by-35 60 mmHg and the velocity by 10 m/s. The air density is 1.2…

A: Given data:

Q: Initially tank I and tank II each contains 100 gal of brine, tank I having 200 lb salt and tank II…

A: Write the given data in the problem. V1=100 galm1=200 lbm2=50 lb v˙1=2 gal/min v˙2=3 gal/min    t=50…

Q: A liquid having a sp.gr. of 20 is flowing in a 50 mm diameter pipe. The total head at a given point…

A:

Q: Helium (Molecular Weight = 4) is pumped into a 20-ft3 tank until the pressure is 149.7 psia. When…

A:

Q: 4 ft 2 ft Determine the rate of discharge and gage pressure at point A. А.

A: Given : The diameter of pipe is The free body diagram is,

Q: A pump is installed in a pipe system, where at the suction side 1.0 m below the pump, an open…

A:

Q: A 7-hp (shaft) pump is used to raise water to an elevation of 15 m. If the mechanical efficiency of…

A:

Q: a) At what velocity does the water leave the pipe? b) What is the pressure near the pump?

A: For solution refer below images.

Q: A lorry is carrying 4000 liters of water. It is driven from Kota Kinabalu to Mesilau and it was…

A: Given Data: The initial volume of water in the lorry is, V1=4000 litres. The change in the…

Q: 6) Determine the internal energy of water at 20 psi and 400 F

A:

Q: Determine the pressure difference between pipe A and B for arrangement shown in Fig. P. 1.13.20.

A: It is needed to determine the pressure difference between the two pipes.

Q: Figure shows the schematic representation for the measurement of air (density = 1.2kg/m³) through a…

A: Given data:Density of air, ρa=1.2 kg/m3Density of water, ρw=1000 kg/m3Differential head of water,…

Q: 4.Oil with specific gravity 0.750 is flowing through a 6-in pipe under a pressure of 15.0 psi. If…

A: The given information in the problem is shown in the following attached image:

Q: Find the force required to hold the plug in place. The water discharges freely into the atmosphere…

A: water velocity v=3m/sentry diameter D=0.25mplung diameter d=0.2mto find the force required to hold…

Q: Q3/pond water is supposed to use for fire extinguishment in an institute for an emergency if any…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: For oil flow through a pipe, velocity increases O 1, with decrease in area of cross section O 2.…

A: Option : With decrease in area of cross section

Q: Problem 4 A partly full water tank admits water at 85 N/s weight flow while ejecting water on the…

A:

Q: Oil at specific gravity of 0.761 flows from tank A to tank E as shown. Lost head may be assumed to…

A:

Q: Figure 3.1 shows a water tank with a pressure meter and a valve. When the valve is closed, the…

A: Assumptions i) water flows out to the open atmosphere from the valve outlet. ii) The tank is large…

Q: Convert  a flow of water flowing in a pipe 450 Liters/ hr  into ____________…

A: Given: Volumetric flow rate of water =450liters/hr

Q: What is the rate of flow of water if the actual inside diameter is 1.5 inches and the flow pressure…

A:

Q: A water system of 2 inches (inside diameter) pipe, having a length of 1/4mile, is to be flushed with…

A: Given Data: The inside diameter of the pipe is, d=2 in=2 in×ft12 in=16 ft. The length of the pipe…

Q: Pump cavitation can be prevented by limiting pump location. The calculated net positive suction head…

A:

Q: Venturi meter as shown in Figure 2 has the cross-sectional area of 10 m² and 5 cm² at Point A and…

A:

Q: 5. Write down the Benoulli equation and explain the meaning of each terins 6. Water is flowing…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: A venturi meter has an inlet diameter of 65 mm and a throat diameter of 26 mm. When measuring the…

A:

Q: В4. An orifice meter with orifice area 945 mm2 is inserted in a pipe of area 1890 mm2 The pressure…

A:

Q: An engineering student has been given the assignment of designing a hydraulic holding system for a…

A:

Q: the specific speed for pump

A: Given; In terms of speed of rotations of the impeller N, discharge Q and change in total head H,…

Q: A syringe is used to deliver vaccine against an infectious disease. This particular syringe is not…

A: Given: Leaked flow rate is 5% past the plunger. Flow rate of the vaccine is 270 cm3/min. Velocity of…