How many liters per second of water must the pump shown supply when the flow needed in the 915-mm diameter pipe is 1.314 cu.m./sec. Assume f=0.017 for all pipes.

Q: 10. What hose I.D. would be required to deliver 50 gal/min , assuming no friction losses at a…

A: GivenQ=50gal/min=0.189271 m3/minQ=3.1545×10-3  m3/sV=8.5ft/sec=2.5908 m/s

Q: nd the diameter of the pipe in mm. The discharge of the pipe is  20 lit/sec with the velocity of…

A: Given data: Discharge of the pipe (Q) = 20 lit/s Velocity of the water (v) = 4.75 m/s Need to…

Q: Compute points on the velocity profile from the pipe wall to the centerline of a 3/4-in Type K…

A: Given: The diameter of the pipe, d = 3/4 in The volume flow rate, Q = 0.5 gal/min The temperature of…

Q: From pump 1.0 m 1.5 m a. Using a vertical bar chart, plot the pressure drop (i.e. P₁-P₂) for these…

A:

Q: Eight cubic feet of water flow per second downward through this pipe line. When the upper pressure…

A:

Q: if the velocity of a liquid is 1.65 ft / s in a 12-inch diameter conduit. What is the velocity in a…

A:

Q: The figure below shows a fluid flow system that is designed to pump water at 20 °C from a lower…

A: Given:Water temperature, T=20oCLength of Suction pipe, Ls=20 mSuction pipe=312" schedule 40…

Q: The pressure through a section of pipe is 21 PSI and the velocity of the fluid is 1 ft/sec. If the…

A: given data; pressure at section 1st (P1)=21PSI=144789.903pavelocity at section…

Q: The pressure through a section of pipe is 23 PSI and the velocity of the fluid is 3 ft/sec. If the…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.