Intravenous infusions usually are driven by gravity by hanging the fluid bottle at sufficient height to counteract the blood pressure in the vein and to force the fluid into the body. See the schematic bellow. The higher the bottle is raised, the higher the flow rate of the fluid will be. a) If it is observed that the fluid and the blood pressures balance each other when the bottle is 1.2 meters above the arm level, the gage pressure of the blood will be.. .kPag. b) If the gage pressure of the fluid at the arm level needs to be 20 kPag for sufficient flow rate, the bottle must be placed at the height of.. . .. .meters. Please note: The density of the fluid is 1020 kg/cubic meters. Acceleration of gravity is 9.81 meters/squared second. -IV bottle 1.2m

Intravenous infusions usually are driven by gravity by hanging the fluid bottle at sufficient height to counteract the blood pressure in the vein and to force the fluid into the body. See the schematic bellow. The higher the bottle is raised, the higher the flow rate of the fluid will be. a) If it is observed that the fluid and the blood pressures balance each other when the bottle is 1.2 meters above the arm level, the gage pressure of the blood will be.. .kPag. b) If the gage pressure of the fluid at the arm level needs to be 20 kPag for sufficient flow rate, the bottle must be placed at the height of.. . .. .meters. Please note: The density of the fluid is 1020 kg/cubic meters. Acceleration of gravity is 9.81 meters/squared second. -IV bottle 1.2m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: (Answer: m = 2.578 kg/s) 8) A venturi meter measures the flow of water in a 75 mm diameter pipe. The…

Q: Initially, the gas pressure is less than the outside atmospheric pressure. When valve 1 is opened,…

A: Initially, the gas pressure is less than the outside atmospheric pressure.Case1-When valve 1 is…

Q: 120 mm diameter siphon draws water from the reservoir. Considering that the elevation differences,…

A: Given data: Diameter of siphon, d=150 mm=0.15 m ⇒Area, A=π4×d2=π4×0.122=0.01131 m2. Atmospheric…

Q: Blood is flowing through point P (Figure 2.5), which is connected to a catheter tip manometer…

Q: A leaky 8 lb bucket is lifted from the ground into the air by pulling in 20 ft of rope at a constant…

Q: When an incompressible fluid moves through a smaller cross-sectional area, the volume flow rate is…

Q: 7. A cylindrical capsule can move inside a long vertical cylindrical tube filled with a viscous…

A: Part1 Case 1; There is cylindrical…

Q: . An open cylindrical tank 1 meter diameter contains water to a depth of 3.56m. If the tank is…

Q: ows through an air duct which expands in the flow direction then which of the following statements…

A: Option (b) is correct.

Q: In figure below, water enters at point A and leaves at point C. The process is steady state. The…

A: Draw the free body diagram for the fluid and the pipe at joint A as:

Q: 8.3. In Prob. 8.2, if the pressure is increasing in the direction of the flow at a rate of 0.10…

A: Approach to solving the question:To determine the velocity U given that the pressure is increasing…

Concept explainers

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.

Question

100%

Intravenous infusions usually are driven by gravity by hanging the fluid bottle at sufficient
height to counteract the blood pressure in the vein and to force the fluid into the body. See the
schematic bellow. The higher the bottle is raised, the higher the flow rate of the fluid will be.
a) If it is observed that the fluid and the blood pressures balance each other when the bottle
is 1.2 meters above the arm level, the gage pressure of the blood will
be.. .kPag.
b) If the gage pressure of the fluid at the arm level needs to be 20 kPag for sufficient flow
rate, the bottle must be placed at the height of.....
.meters.
Please note: The density of the fluid is 1020 kg/cubic meters.
Acceleration of gravity is 9.81 meters/squared second.
-IV bottle
1.2m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

6.
Q2/: As shown in the figure, the Assumptions of the flow through the venturi is steady, incompressible, irrational with negligible frictional effects , the effect of air column on the pressure change is negligible, the pressure can be assumed to be uniform at a given cross-section of the venturi meter and the flow is horizontal . Air is flowing through a venturi meter whose diameter is 2.6 in at the entrance part (location 1) and 1.8 in at the throat (location 2). The gage pressure is measured to be 12.2 psia at the entrance and 11.8 psia at the throat. Neglecting frictional effects, take the air density to be 0.075 lbm/ft. 1. Show that the volume flow rate can be expressed as: 2(P P2) | = A, p(1 – AŽIA}) 2. Find the flow rate of the air? 12.2 psia 11.8 psia Air 2.6 in 1.8 in
5. An arteriole has a flow rate of 2 cm³/min. Which would increase the flow rate the most, increasing the pressure by a factor of 4, increasing the radius by a factor of 2 or decreasing the viscosity of the blood by a factor of 4? Show calculations.
b10
A vertical cylindrical container contains 5840 gallons of gasoline and is 1.53 m in radius. Due to evaporation within the tank, the pressure on the top of the fluid is 2.5 times normal atmospheric pressure. The density of gasoline is 737 kg/m3. a. What is the pressure at the bottom of the tank? b. If a nozzle at the bottom of the tank is used to let fuel out, with what velocity would the gasoline exit the hole? c. If a nozzle at the bottom of the tank is used to let fuel out, what volume flow rate will result if the diameter of the hole is 1.2 cm? d. At what initial rate will the height of the fuel level in the tank drop as fuel is removed?
2. Some of the first power-generating wind turbines were small, having blades with a radius of 8.00 meters. Currently, the largest wind turbine has a radius of 164 meters. Because the small wind turbines are closer to the ground, they often experience smaller wind speeds. Given the information below, how many small wind turbines would be needed to produce the same power output as one large wind turbine? For both wind turbines, assume the air density is 1.23 kg m³. Small Wind Turbine Large Wind Turbine Wind turbine blade radius 8.00 m 164 m Wind turbine efficiency 35% 45% Wind speed 3.50 m s1 5.50 m s1
You and a friend plan to throw one end of a hose over a tall fence to siphon water from your side to the other side. Your friend says it doesn't matter how high the fence is, it will always work as long as your end of the hose is higher than the other side. However, you remind him that isn't actually true. What is the potential problem and about how high can the fence be (in meters) before it becomes an issue?
PROBLEM 2 Consider a firefighter who is standing on a ladder and spraying water with a hose into Chief Inspector Jacques Clouseau's (Figure 3a) third-story apartment. A diagram of the hose/nozzle used by the firefighter is shown in Figure 3b. Assume the nozzle has little effect on the flow in the hose and water in the hose/nozzle is incompressible. The temperature of the water in the hose is 15 °C. (a) Chief Inspector Jacques Clouseau investigating the cause of the fire in his apartment. water hose diameter=10cm outlet diameter=5cm Figure 3 个个个 outlet velocity=6ms¹ (b) Fire hose/nozzle used to extinguish the fire in Inspector Clouseau's apartment.