Prepare a nice bar chart comparing the average compressive and tensile strength of each mix.Plot the average value along with a 95% confidence interval of this average value.Please show using excel. Mix 1Mass (g) Compress (psi) Tensile (psi)192.8189.4189.6181.4188.2Mass (g)171.0177.3175.2177.3176.3857814688777Mix 2Compress (psi)667649792673750675738170.5165.6193.1144.1163.3Mix 3Mass (g) Compress (psi) Tensile (psi)183.8175.9175.8182.0176.2633773690Tensile (psi)160.7159.5124.1145.1139.2191.4181.0119.8 Mix 4Mass (g) Compress (psi) Tensile (psi)188.0183.8194.5182.8183.1Mass (g)168.8187.8174.4184.6171.51057114213341336973Mix 5Compress (psi)1047109510281189591214.7175.8208.4196.9163.9Tensile (psi)200.2212.4215.3257.0210.2

We are required to draw a bar chart for comparing the average compressive and tensile strength of…

Answered: Prepare a nice bar chart comparing the…

Prepare a nice bar chart comparing the average compressive and tensile strength of each mix. Plot the average value along with a 95% confidence interval of this average value.

MATLAB: An Introduction with Applications

6th Edition

ISBN:9781119256830

Author:Amos Gilat

Publisher:Amos Gilat

Chapter1: Starting With Matlab

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

DO NOT USE MICROSOFT EXCEL. Provide a step-by-step solution with NORMAL CURVE. Please write legibly. A study was conducted to see if increasing the substrate concentration has an appreciable effect on the velocity of a chemical reaction. With a substrate concentration of 1.5 moles per liter, the reaction was run 15 times, with an average velocity of 7.5 micromoles per 30 minutes and a standard deviation of 1.5. With a substrate concentration of 2.0 moles per liter, 12 runs were made, yielding an average velocity of 8.8 micromoles per 30 minutes and a sample standard deviation of 1.2. Is there any reason to believe that this increase in substrate concentration causes an increase in the mean velocity of the reaction of more than 0.5 micromole per 30 minutes? Use a 0.01 level of significance and assume the populations to be approximately normally distributed with equal variances.
Please solve for p value ,determine weather to reject hypothesis and state the conclusion for enough evidence
PLEASE ANSWER ALL THE PARTS OF THE QUESTION ( THIS IS NOT A GRADED ASSIGNMENT)
The body weight of a healthy 3-month old colt should be about µ = test the claim that the weight of a wild Nevada colt (3-months old) is more than 60 kg. 60kg Suppose you want to State in words what a Type I Error is. State the mean weight of a wild Nevada (3-month old) colt is less than 60 Kg when in fact the mean weight of a wild Nevada colt (3-month old) is more than or equal to 60 kg. State the mean weight of a wild Nevada (3-month old) colt is more than 60 Kg when in fact the mean weight of a wild Nevada colt (3-month old) is less than or equal to 60 kg. State the mean weight of a wild Nevada (3-month old) colt is equal to 60 Kg when in fact the mean weight of a wild Nevada colt (3-month old) is not equal to 60 kg. State the mean weight of a wild Nevada (3-month old) colt is less than or equal to 60 Kg when in fact the mean weight of a wild Nevada colt (3-month old) is more than 60 kg.
The NTSB wants to estimate the difference between the average stopping distance for a car traveling 40 MPH on wet versus dry pavement. Ten vehicles were used for the study where each vehicle was driven at 40 MPH and came to a sudden stop on both wet pavement and dry pavement. The stopping distance was measured (feet) for each pavement condition and the data is shown below followed by Minitab output with the CI. Estimation for Paired Difference Mean StDev SE Mean 95% CI forμ_difference 34.700 2.452 0.775 (32.946, 36.454) b. What assumption is needed for this CI to be valid?
Data from 500 random tornados was collected and the length in miles that the tornado was touching the ground was recorded. We want to test the claim that the mean tornado length is greater than 2.5 miles using a .05 significance level. Using the traditional method if the test statictic is .759, x hat = 2.72424 and s= .2956. Tell why you made the decision you did.
Please give full solutions thanks!