POST-LABORATORY QUESTIONS Due after Laboratory Experiment 1. While performing the Dumas experiment, if the outside of the flask were not completely dry (Part I), how would this affect the calculated molar mass of the unknown volatile liquid? Would it be higher or lower? Explain. 2. While determining the pressure during the Dumas experiment, if the barometric pressure reported were lower than the actual vapor pressure (Part I), how would this error affect the calculated molar mass of the unknown volatile liquid? Explain.

POST-LABORATORY QUESTIONS Due after Laboratory Experiment 1. While performing the Dumas experiment, if the outside of the flask were not completely dry (Part I), how would this affect the calculated molar mass of the unknown volatile liquid? Would it be higher or lower? Explain. 2. While determining the pressure during the Dumas experiment, if the barometric pressure reported were lower than the actual vapor pressure (Part I), how would this error affect the calculated molar mass of the unknown volatile liquid? Explain.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

The liquids to be studied in this experiment are water and aqueous solutions of CTAB. CTAB solutions should be measured at concentrations of 10-5, 10 - 4, 3x 10-4, 8 x10-4, 2 x10-34 x 10-3 M and 10-2 M. Prepare a table with the calculated mass of CTAB required to make up the two most concentrated solutions and a separate table with the mass of concentrated solution required to prepare the dilute solutions. (Assume that you are using, 1000 ml volumetric flasks for the most dilute solutions and 500 ml volumetric flasks for the remainder)
In this lab, you used rotary evaporation to remove the neutral organic solvent. Rotary evaporation is an example of a distillation except under conditions of a reduced pressure atmosphere. What effect does a reduction in atmospheric pressure have on the observed boiling point? Explain your answer.
If this lab's procedure were carried out using 20.51 mL each of 0.249 M K2CrO4 and 0.159 M Pb(NO3)2. How many mmol of K2CrO4 were used in this reaction? Report your answer with 3 significant figures.
What is wrong with this setup? buret acid of unknown concentration base of known concentration stopcock The buret needs to be filled with more base The tip of the buret is not placed inside of the flask The buret is not supported by clamp Nothing is wrong with this
Based on the melting point of your impure solid, you look at the given samples and believe you havecompound A. Compound A is recrystallized using a mixed solvent system of ethanol and water. You add1 ml of hot ethanol to your sample and it doesn’t completely dissolve. You continue to add hot ethanolbut there isn’t any change. Some solid remains. What should you do next?
When conducting a recrystallization what should generally be true when comparing the compounds melting point compared to the boiling point of the solvent? Explain why this is so.