5. Assuming your solute has good solubility properties in your recrystallization solvent, what is a common cause of low percent recovery in recrystallization? a. too much recrystallization solvent   b. too much solute used compared to amount of solvent

Q: Which of these would NOT increase the rate of dissolving? shaking/stirring the mixture causing an…

A: The rate of dissolution of any substance depends upon the following factors; I) Stirring II) Surface…

Q: d. higher freezing point and a lower vapor pressure and boiling point.  3. Which of the following…

A: According to the answering guidelines, I'm posting the solution for the first 3 question. Kindly…

Q: In general, the solubility of solids increases with increasing solvent temperature. A. True B.…

A: Solubility is defined as the amount of substance that will dissolve in a given amount of a solvent…

Q: What property determines solubility? A. mass B. geometry C. polarity D. volume

A: we have to determine the property that determines solubility

Q: 507 A1u LE 68665 16 43\ E 17. Define the following terms: a. recrystallization b. saturated solution…

A: Answer

Q: To suspend colloid particles in a colloid, you could use a(n) a. emulsifying agent b. dispersing…

A: A colloidal mixture is a type in which the solute particles are in the range of 1 to 1000 nanometers…

Q: How could you increase the rate at which a gaseous solute dissolves? A. Stir the solution B.…

A: If a Gaseous solute dissolves in liquid mixture or solvent then solubility of solution can be…

Q: 1 What mass of solid radium sulfate (the most insoluble compound known) will remain when 10 L of a…

A: The answer to the following question is-

Q: a.solution b.suspension c.colloid

A: The emulsion is a type of two immiscible liquid such as oil and water. The emulsion is a…

Q: Jenny mixes up a batch of pancake batter, then stirs in some chocolate chips. As she is waiting for…

A: Introduction:  Solution is a type of mixture in which the solute completely mixes in the solvent…

Q: 12. Which type of interaction is formed when lonic solutes undergo dissolution in water? A. Hydrogen…

A: Note : Since you have posted multiple questions, we are entitled to answer the first only. Please…

Q: The concentration of KBr in a solution prepared by dissolving 2.05 g of KBr in 897 g of water is…

A: The concentration (molality) of KBr in a solution is to be calculated.

Q: 2.Boils at temperature higher than the boiling point of pure solvent A.Vapor Pressure B. Boiling…

A:

Q: Which is not required in recrystallization? a. solution is filtered at high temperature b.…

A: Remember this point, recrystallization is used for purify the crude sample of compound so that all…

Q: In a marshmallow, small air pockets are suspended in a sugary matrix. In this colloid, the sugary…

A:

Q: 9. Separation of two substances by recrystallization depends upon their differences in a.…

A: To explain: Separation of two substances by recrystallization depends upon their differences in…

Q: B. Complete table 1. Write down your observations Substance/Sample References for Solubility in…

A: To fill in the observations in the table:

Q: 6. In a recrystallization, why is it important to dissolve the solute in boiling solvent instead of…

A: The correct answer is (a) To melt the solute.   In a recrystallization, the goal is to dissolve a…

Q: Question 10 A dissolved solute returns to its solid state. What is this process called? A deposition…

A: Solution 10) : Recrystallization is a purification technique for solid compounds. To perform…

Q: How many milliliters of a 17% w/v concentrate of benzalkonium chloride should be used in preparing…

A:

Q: why does polar liquid solvent cannot dissolve non-polar liquid  solute? Select one: a. like…

A: The polar compounds have polar bonds and non-polar compounds have non-polar bonds.

Q: 1. Dissolve A. Causes more gaseous solvent to be forced into a liquid. B. Increases solubility by…

A: Since you have posted a question with multiple sub-parts,we will solve first three sub-parts for…

Q: Which is not true for peptization of colloids? A. Coagulated colloids revert to its original…

A: Peptization is the process in which precipitate is  convert into colloidal solution.

Q: Factors Affecting Solubility To each of two test tubes containing 10 mL of water, add small amount…

A:

Q: Which is NOT TRUE about colligative properties? A. Properties of solutions that depend only on…

A: The properties of the liquid solutions which depend only on the number of particles of solute…

Q: What is the theory behind recrystallization purifying a solid?

A:

Q: The solute like component of a colloid

A: The size of the particles between 1nm - 1000nm in solution is generally called as colloidal…

Q: recrystallization

A:

Q: If an aqueous system cannot be filtered but exhibits the Tyndall effect, it is considered a(n):…

A: When the beam of light is incident on collide particles they scatter the beam of light and this…

Q: The process that drives dialysis is dependent on a. the dispersing medium b. vapor pressure c. the…

A: Dialysis is a process in which the the solute particles present in the solution is removed from the…

Q: Which of the following will increase the rate at which a solute dissolves? A. breaking up or…

A: The rate at which solute dissolved is increased by  1. stirring 2. increasing the temperature 3.…

Q: Adding a nonvolatile solute to a liquid will A. elevate both the freezing point and the boiling…

A: Freezing point of solvent is greater than freezing point of solutions. Whereas boiling point of…

Q: In sample preparation, __________sample must be reduced in size to obtain the laboratory scale.…

A: The bulk sample is a large sample that is representative of the lot. The bulk sample is prepared in…

Q: 1. Solubility Test Table 1. Results for the solubility test. OBSERVATION* INFERENCE SAMPLE Ethyl…

A: Solubility refers to dissolution of a substance in another so as to form a homogenous solution. It…