Please write all the formulas clearly foreach case first, then solve the questionby hand on paper and send a clearphoto of the solution. Thanks a lotA three-phase bridge-inverter is fed from a d.c. source of 200 V. If theload is star-connected of 10 02/phase pure resistance, determine the RMSload current, the required RMS current rating of the thyristors and the loadpower for (i) 120° firing, and (ii) 180° firing.[Ans (i) 120° firing IL (rms) = 8.16 A, IT(rms) = 9.8 A. Load power = 2000 W.(ii) 180° firing IL (rms) = 9.43 A, IT (rms) = 6.67 A. Load power = 2667 W.]

Step 1: Step 2: Step 3: Step 4:

Answered: Please write all the formulas clearly…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Similar questions

Half wave rectifier.
2
(b) A three-phase uncontrolled bridge rectifier is connected to an AC supply of 415V through a delta-star transformer as shown in the Figure. The load consists of large inductance to render a level load current of 60A at 300V. Assuming voltage drop across the power device to be 0.7V, compute the following: i) Rms value of secondary phase voltage and current; ii) Rms value of primary phase voltage and current3; iii) Transformer power rating in kVA and transformation ratio; iv) Device ratings. 本の。本の本の Load 本の。本。本の。 Figure
Q1. a) An SCR based AC power controller circuit is given in Figure 1. The circuit connects a 240V 50Hz AC source vi to a resistive load with resistance of 100. If the delay angle is a-15°, draw the waveforms of the load voltage Vo, and the voltage across SCR2. Calculate the power supplied to the load. + Vi Va + 2 SCR2 H₁₁ SCR₁ Figure 1 SCR based AC power control circuit Va + 2 io b) Figure 2 is a single phase 2-level voltage source converter (VSC) with a DC voltage Vd-200V. A PWM scheme, by comparing a reference value with a 10kHz triangle waveform, is used to control the switches S₁ and S2. The modulation index of the PWM is m=0.8. With the aid of graphs explain how pulse signals for the switches are generated, sketch the output voltage Vo, determine the duty cycle, and calculate the average output voltage. + Vo + Vo √ ₂ == Figure 2 A single phase VSC
22. The voltage applied to the h.v. side of a trans- former during short-circuit test is 2% of its rated of voltage. The core loss will be........percent the rated core loss. (a) 4 (b) 0.4 (c) 0.25 (d) 0.04

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning