Please do not give solution in image format thanku The desired final population of a microbial population is a probability of 0.00058. If the initial population is 5 x10^4 and the survival of the population is described by a D(subscript)121=1.5 min,and a z=11C,estimate the time required to reach the desired probability at 110C.

Please do not give solution in image format thanku The desired final population of a microbial population is a probability of 0.00058. If the initial population is 5 x10^4 and the survival of the population is described by a D(subscript)121=1.5 min,and a z=11C,estimate the time required to reach the desired probability at 110C.

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter10: Reconstitution Of Powdered Drugs

Section: Chapter Questions

Problem 8.5P

See similar textbooks

Similar questions

SEPARATION OF COMPONENTS BY CENTRIFUGATION Consider the following subcellular components and their corresponding sedimentation rates. Table 3. Sedimentation rates of four subcellular components for isolation. CENTRIFUGAL FORCE (xg) SUBCELLULAR COMPONENT CDCP 14896 AJRA 967 AGC 382 JCKSP 2378 Two centrifuge machines are available in your laboratory. Centrifuge A has a rotor diameter of 14 cm and a maximum speed of 3500 rpm while centrifuge B has a rotor diameter of 18 cm and a maximum speed of 14500 rpm. Construct a separation scheme of the four subcellular components considering the following parameters: The four components are separated into pellet/supernatant I and pellet/supernatant II. Only two centrifugation steps are performed; specify the centrifugal speeds (in rpm) per step. Show relevant calculations. Both centrifuge machines must be used in the procedure. Components of each fraction are indicated.
You have an order for 1 gram of Cefazolin in D5W 100 ml. You have added 5 ml of sterile water to the 1 gram vial to reconstitute powder. However the recommended manufacturer’s diluent amount is 10 ml of sterile water for a final concentration of 100 mg/ml. How would reconstituting the vial with 5 mls affect the concentration and the final calculated dose. Please answer with explanation ASAP. I will really upvote. Thanks
E. coli has a doubling time of 0.345 hours at 37 0C. Starting with 1 milligram of cells, assuming a lag phase of 30 minutes and a stationary phase of 30 minutes, what number of cells would you expect at the end of 13h, assuming that besides the lag and stationary phases the culture is continuously in exponential phase. Assume that ln (2) = 0.69 and that the mass of a single cell is 10^(-12) g.
The phenol concentration of wastewater was determined from three (3) parallel determinations, giving a mean of 0.513 μg L-1 and a standard deviation of 0.05 μg L-1. Decide at a risk level of 5% (or a confidence level of 95%) whether a reference value of 0.520 μg L-1 is statistically different.
You are required to compound Aminophylline Suppositories for a patient: the density of Cocoa butter is 0.9 g/mL, the suppository mold volume is 2 mL, Aminoplylline has a Density Displacement Factor of 1.1 and each suppository should contain 200 mg Aminophylline. What is the calculated weight of ONE Aminophylline-loaded suppository?
Which of the following types of data produce curves similar in shape to the graph? Select all that apply 1.Bacterial growth in a culture 2.A normal distribution of height in a population of students 3.Exponential population growth 4.Haemoglobin binding of oxygen 5.Log transformations of drug dose curves 6.Osmotic fragility of red blood cells 7.A standard curve for an enyme assay
There are many ways you can accomplish a 1000-fold dilution. Propose 3 different serial dilution methods that will accomplish a dilution with a 1:1000 dilution factor.
A culture of S. cerevisea has an overnight OD of 2.3 (1.0 OD is approx 1.0x107 cells/ml) You will be plating 100µl onto agar and want the final count of colonies on the plate to be around 300 colonies. How much of the 2.3 OD culture must you use to get a 500µl subdilution (with sterile water), so that you have diluted enough to get approx 300 colonies per 100ul
N. benthamiana will be infiltrated with a solution containing OD600=0.3 of each experimental Agro containing construct and OD600=0.1 of p19. Calculate the volume of cultures (V construct; V p19) needed according to the formulas: V construct = V final × 0.3/OD600; V p19 = V final × 0.1/OD600. One mL of infiltrate is often enough to complete a small experiment. How to plan your final volume accordingly?
Imagine you have been given a liquid culture of yeast with a starting concentration of 3.67 x 10' cells/ml and are asked to carry out the sample dilution process shown in the figure below. 100μl 100μl 100μl 100μl 100μl 0.9ml 0.9ml 0.9ml H2O H₂O 6.9ml 0.9ml H₂O H₂O H₂O Original 10-1 102 10-3 104 Culture 105 100μl 100μl 100μl Plate A Plate B Plate C a. How many colonies should have been present on Plate A in this example? - Answers must be whole numbers as partial colonies are not expected. b. Imagine you carried out the same dilution scheme shown in the figure above, but now, you do not know the concentration of the original culture. If you counted 163 colonies on Plate B, what is the concentration of cells/ml in the original culture?
8. A. Use Excel (or another graphing program) to draw the growth curve, In (X/X.) vs time, for bacteria grown in a 20 L suspension cell culture, given the following data: - initial concentration: 0.120 gdw cells/L Also report: - lag time: 1.5 hours - mass doubling time during exponential growth: 250 minutes - duration of exponential growth phase: 1 day (24 hours) - negligible time in the deceleration phase - 13 hours in the endogenous metabolism phase with no change in cell concentration - cell death rate with k = 0.0178 min -¹. B. What is the specific growth rate, µ? C. What is the maximum concentration of cells in the reactor? (gdw cells/L) and when does this occur? D. Other than time zero or the end of lag phase, at what time is the concentration of living cells in the reactor equal to the initial concentration of 0.120 gdw/L?
A 0.00001 dilution is performed on a culture of bacteria in order to perform viable plate counts. From the dilution, *0.1 mL* of solution is plated on solid media, and 223 colonies of bacteria grow on the petri dish. Assuming each colony came from a single bacterium, how many bacteria are in a single mL of the original culture? Express your answer to two decimal places using exponential notation. Since only 0.1 mL is put on the plate, this counts as an extra dilution!!! Any time less than 1 mL is transfered, a dilution is being performed. Any time more than 1 mL is transfered, a concentration is being performed.