Pig iron is obtained by loading ore / flux / coke with the given compositions, since 550 kilograms of flux and 600 kilograms of coke are used to obtain 1 ton of raw material, please find the following... 1) The weight of the loaded ore 2) The weight and composition of the slag in%

Q: An alloy that is made up of Brass and Chromium has specific gravity of 12. What is the mass of Brass…

A: The specific gravity of alloy is obtained from the density of alloy and density of water. The…

Q: Sketch a graph of the cooling curve. The data points do not have to be in the exact positions…

A: Data of Time(sec) vs Temperature (0C) is given  Find the graph of the cooling curve and when it…

Q: 2. Usually weather data is collected by releasing He or H2 filled balloons carrying the required…

A: GIVEN Radius of Sphere= 1m TO CALCULATE Work done

Q: The molar volumes of solid and liquid lead at the normal melting temperature of lead are 18.92 cm3…

A:

Q: .A block of ice as a horizontal cylinder(height=Ddiameter%3D10CM) at OC is placed in an environment…

A: Whenever ice is kept in a surrounding with a temperature higher than 0oC, the ice block slowly…

Q: Paper is made from a suspension of fibers in water. The process begins by draining the fibers to a…

A: The type of dryer required to dry the paper is to be mentioned.

Q: Select all that apply for  saturated vapor:     It refers to a point on a T-v diagram on a specific…

A: The saturated vapor is a substance that exists completely as vapor at its saturation temperature. On…

Q: Fuel flows in to the burner and is burnt with air provided from an air blower. * true O False O Nan

A: It is to be determined whether fuel flowing into the burner is burnt with air provided from an air…

Q: provided below, the critical radius and the activation energy if the nucleation is homogeneous. The…

A: Solution :Step 1 - Given data are               (i)      r = 0.204 J/m2               (ii) ∆Hf =…

Q: Propane gas at room temperature is burned with enough air so that combustion is complete and gases…

A: We have to find the no. of moles of gas are available for drying per mole of propane burned. Given…

Q: It is estimated that 123,000 aluminumcans are recycled each minute. Assume that each canhas a mass…

A: Given Recycled Aluminium Can=123,000 per minute 1 Aluminium Can mass=14 g Find Total Aluminium Can…

Q: 1500 lb/h of a waste mixture of 40 percent benzene, 50 percent toluene, and 10 percent water is…

A:

Q: Crude oil, which is used to make many products in the oil and gas industry, is made up of carbon and…

A: Answer: (b) Boiling point

Q: the amount of excess combustion air is normally determined by analysis of stack_____ a) the fuel…

A: Excess air is the air which is used in excess for combustion of various fuels (solids, liquid, and…

Q: An aqueous solution of gold nitrate is electrolyzed with a current of 0.5 ampere until 1.5 g of gold…

A:

Q: How can I calculate the CO2eq in US tons? Knowing that 600ft2 of 1/4inch boards produce 407kgCO2eq…

A: 600 ft2 of 1/4 inch boards produce =407 Kg CO2 eq

Q: Aqueous solutions are sometimes used in crystallization procedures. In such cases, the water in the…

A: Crystallization is a process in which the crystals of solute are formed by evaporating or cooling…

Q: In the steel industry, one of the most important processes done is known as quenching. This process…

A: Given details, Mass of steel cube,ms=7 kg initial Temperature of steel,Ts1=700 C=700+273=973 K Mass…

Q: The air at a dry ball temperature of 80 oC and 4 % RH is passed over the cooling coil so that the…

A: From psychrometric chart at 80 oC dry bulb temperature and 4% relative humidity: Enthalpy: 138.4 kJ…

Q: 0.5 BTU/lb • °F to J/kg

A: The unit from BTU/lb.0F to J/kg.K with the value is to be converted.

Q: The viscosity of benzene varies with temperature as shown in the following table. Use t data to…

A:

Q: If the sample of material has a mass of m = 9.20 g, calculate the specific heat when this material…

A: Given data: The amount of heat added at 43.7 0C = 183 J Amount of heat added at 239 0C = 785 J…

Q: .Carburization process is applied to the surface of a steel containing 0.3% carbon.Methane gas (CH4)…

A: Given data: Initial concentration of carbon = 0.3 % Final concentration of carbon = 1.2 % Amount of…

Q: The following are streams in hydrotreating process. Identify which of the streams are feed or…

A: Hydrotreating Unit - This unit is used to remove impurities like sulfur, nitrogen etc.

Q: V1 Vapor 90 90 bpB 80 80 L2 70 70 V3 Liquid L3 60 60 50 L5 V5 L4 50 100% A 80 60 40 20 0% 0% 20 40…

A:

Q: A sample has initial mass of 10 grams. The quantity of water removed in the oven is 2 grams. The…

A: The initial mass of the sample, mi = 10 g Mass of moisture removed from the sample, mM = 2 g

Q: 10. The following figure shows an example of physically separating a recycle stream from a product.…

A: The objective of the question is to determine the percentage of the feed to the powdermaking unit…

Q: Calculate the POH of 2×10* M of hydrochloric acid solution.

A: The concentration of Hydrochloric acid (HCl) is 2* 10-3  Find POH of Hydrochloric acid (HCl) ??

Q: Evaluate the change in temperature from point A to E, with regard to heat.

A: In this graph, we can see that, At point A, phase is vapour or gas and temperature is decreasing…

Q: Water with mass of 293.07 grams and at 15oC. is heated at constant pressure. the water is completely…

A: for water isCP= 4.187 kJ/kgK, T1=15oC,T2=100oC Q=mCPT2-T1 Q=293.071000×4.187×100-15 KJ Q=104.3 KJ

Q: . If sa

A: First of all we have to convert this all into CaCO3 equivalent. let first writes all given details,…

Q: Q1// Calculate has the mass 3

A: Specific heat is defined as the amount of heat required to heat a unit mass of substance by 1 C…

Q: Dissolving 2 g of Lithium chloride in 50 g of water raises the water temperature by 5.1 °C Does…

A: LiCl + H2O ---------> LiOH + HCl mass of LiCl = 2 g mass of H2O= 50 g Room temperature = 25oC…

Q: The solid contain composition of each phase in a Cu-40% Ni alloy at 1250°C is: 1500 1400- 40 1300-…

A:

Q: Explain the following terms ➢ Drying process ➢ Moisture content of a material ➢ Rate of drying of a…

A: Given  Some terms   Drying process  Moisture content of a material Rate of drying of a granular…

Q: Determine: (a) the composition of the first solid to form upon cooling, making sure to draw the…

A: The temperature at which the metal in molten alloy state transforms into liquidus state is called…

Q: After passing 1000 L of raw hardwater in Zeolite softener, the bed got exhausted. 7.8 L of Brine…

A: By using unitary methods we calculate the hardness of water. Given, volume of raw hardwater in…

Q: If there is crude oil that contains 200 PPM of Vanadium if 5000 barrel is burned per day calculate…

A: Crude oil is a liquid found below the Earth's surface that can be separated into various useful…

Q: In the drying of a wet solid, if the air temperature is ĐA and the temperature of surface solid is…

A: Given, Temperature of wet solid is θS. Temperature of air is θA.   Drying is a process of transfer…

Q: Consider a Cu-60wt% Ni-40% alloy , determine the following: (a) The liquidus and solidus temperature…

A: