Perform the following conversions. a. 1.51 X 1015 atoms of Si to mol of Si b. 4.25 x 10-2 mol of H2SO4 to molecules of H2SO4 c. 8.95 x 1025 molecules of CC14 to mol of CCI4 d. 5.90 mol of Ca to atoms of Ca

Perform the following conversions. a. 1.51 X 1015 atoms of Si to mol of Si b. 4.25 x 10-2 mol of H2SO4 to molecules of H2SO4 c. 8.95 x 1025 molecules of CC14 to mol of CCI4 d. 5.90 mol of Ca to atoms of Ca

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter10: The Mole

Section: Chapter Questions

Problem 5STP

See similar textbooks

Similar questions

Considering your answer to Exercise 79, which type of formula, empirical or molecular, can be obtained from elemental analysis that gives percent composition?
Consider the following diagram, where atom X is represented by a square and atom Y is represented by a circle. (a) Write the equation for the reaction represented by the diagram. (b) If each circle stands for a mole of Y and each square a mole of X, how many moles of X did one start with? How many moles of Y? (c) Using the same representation described in part (b), how many moles of product are formed? How many moles of X and Y are left unreacted?
Calculate the molarity of solutions prepared by dilution or calculate the quantities needed to carry out a dilution to prepare a solution of a specified concentration.
A 0.755-g sample of hydrated copper(II) sulfate CuSo4xH2O was heated carefully until it had changed completely to anhydrous copper(II) sulfate (CuSO4 ) with a mass of 0.4183 g. Determine the value of x. [This number is called the number of waters of hydration of copper(II) sulfate. It specifies the number of water molecules per formula unit ofCuSO4 in the hydrated crystal.]
The aspirin substitute, acetaminophen (C8H9O2N), is produced by the following three-step synthesis: I.C6H5O3(s)+3H2(g)+HCl(aq)C6H8ONCl(s)+2H2O(l)II.C6H8ONCl(s)+NaOH(aq)C6H7ON(s)+H2O(l)+Nacl(aq)III.C6H7ON(s)+C4H6O3(l)C8H9O2N(s)+HC2H3O2(l) The first two reactions have percent yields of 87% and 98% by mass, respectively. The overall reaction yields 3 moles of acetaminophen product for every 4 moles of C6H5O3N reacted. a. What is the percent yield by mass for the overall process? b. What is the percent yield by mass of Step III?
In Example 4.2, you found that a particular mixture of CO and H2 could produce 407 g CH3OH. CO(g) + 2H2(g) CH3OH (l) If only 332 g of CH3OH is actually produced, what is the percent yield of the compound?
In a laboratory experiment, the reaction of 3.0 mol of H2 with 2.0 mol of I2 produced 1.0 mol of HI. Determine the theoretical yield in grams and the percent yield for this reaction.
Many cereals are made with high moisture content so that the cereal can be formed into various shapes before it is dried. A cereal product containing 58% H2O by mass is produced at the rate of 1000. kg/h. What mass of water must be evaporated per hour if the final product contains only 20.% water?
Write the balanced chemical equation for the complete combustion of heptene, C7H14. In combustion, hcpLcnc reacts with oxygen to produce carbon dioxide and water. What is the mole ratio that would enable you to calculate the number of moles of oxygen needed to react exactly with a given number of moles of heptene? What mole ratios would you use to calculate how many moles of each product form from a given number of moles of heptene?
In an experiment designed to produce calcium oxide by the chemical reaction 2Ca + O2 2CaO 177.2 g of CaO was obtained out of a possible 203.9 g ofCaO. a. What is the theoretical yield of CaO? b. What is the actual yield of CaO? c. What is the percent yield of CaO?
Convert 1.5 x 1023 molecules SO2 to moles.
12. To convert between mass and number of moles. The conversion factor between mass and number of moles is called molar mass. By consulting the periodic table , we can determine that the molar mass of NaClNaCl is 23.0 g/mole+35.5 g/mole=58.5 g/mole23.0 g/mole+35.5 g/mole=58.5 g/mole This number tells us that 1 molemole of NaClNaCl has a mass of 58.5 gg . The conversion factors are 58.5 g1 mole58.5 g1 mole and 1 mole58.5 g1 mole58.5 g Here is an example of the conversion of 12.0 molesmoles of NaClNaCl to grams using the first conversion factor: 12.0 moles×58.5 g1 mole=702 g A. What is the mass of 8.00 molesmoles of magnesium chloride, MgCl2MgCl2? Express your answer with the appropriate units. B. How many moles of nitrogen, NN, are in 78.0 gg of nitrous oxide, N2ON2O? Express your answer with the appropriate units.