PART III. Servo Motor Use tinkercad for circuit and coding Controlling Servo motor rotation using CounterClockWise(CCW) pushbutton and  ClockWise(CW) pushbutton with serial monitor.  Short press will turn the Servo motor by 1 degree and then stop, while long press(hold) will turn the servo motor continuously. Once the servo motor reaches 180 degrees, the CCW pushbutton will no longer work(disabled) only the CW pushbutton is enabled.  The same scenario for 0 degree, CW pushbutton is disabled while CCW pushbutton is enabled.

Q: Explain how an S-R latch operates.

A: S-R stands for SET RESET latch Latch has no clock signal whereas flipflop has signal  flip flop is…

Q: ABC to 7 segment display project using nor gate 3 input and show that SAC-1027 in display.The input…

A: SUMMARY: -Hence, We discussed all the points.

Q: Q3-A Write down the truth table of XOR logic gate 1 Add file Q3- B Sketch the waveform of the output…

A: Truth table and result waveform of xor gate.

Q: For each of the following circuits, find the output and design a simpler circuit that has the same…

A: According to the information given:- We have to find the output and design simpler circuit of the…

Q: 7. It is considered to be a voltage amplifying device that is designed to be used with external…

A: Here, Fill in the blank is given.

Q: Power (or acceleration) control for separately excited dc motor with using matlab MATLAB software i…

A: Simulink is a MATLAB-based graphical programming environment for modeling, simulating and analyzing…

Q: The input waveform shown in the figure below is applied to an inverter, which is used to operate a…

A: Below I have provided handwritten solution of the given question

Q: will be stopped no matter which direction it turns. During engine operation (right or left) If the…

A: Stepper motor control using ULN2003 IC in 16F877 microcontroller will be carried out. In the…

Q: When using Verilog code, what may happen if more than one of the "AN" inputs is activated?  Please…

A: A text-based language called Verilog is used to describe electronic circuits and systems. Verilog is…

Q: Q4/ The BPSK signal has +V volts and -V volts respectively to represent Oa) 1 and 0 logic levels Ob)…

A: The BPSK signal has +ve volts to represent 1 logic level and  -ve volts to represent 0 logic level.

Q: should stay off for 3 seconds and then the LED should blink 10 times at a rate of 1 Hz (on and off

A: byte i; void setup()  {   pinMode(3,OUTPUT); } void loop() {   digitalWrite(3,HIGH);…

Q: IC in a DAC acts as an amplifier to amplify the analog output voltage.

A: High current voltage is the output that can be received from DAC.

Q: Design a 4-bit arithmetic and logic unit using the and or gate and multiplexers

A: Note: Logisim software is not availble. Refer the given ciruit and convert it using logisim

Q: module CircuitQ4(a, b, c, f, g); input a, b, c; output reg f, g; always@ (posedge Clk, posedge Rst)…

A: The Verilog code in Figure Q4(a) describes an asynchronous circuit with two outputs, "f" and "g".…

Q: chronous countdown from

A: Design a 7 asynchronous countdown from 16 to 9

Q: Design a password protected door lock system

A: ANSWER: Password Based Door Lock System:

Q: To control the operation of the decoder there may be one or more enable inputs select inputs output…

A: The answer is given below step.

Q: asynchronous countdown from

A: Design a 7 asynchronous countdown from 16 to 9

Q: A type of motor that whose position can be accurately controlled by a microcontroller without any…

A: Explanation of options : Option A (Synchronous motor): not correct  explanation: Synchronous…

Q: Write a program that starts out by flashing an LED connected to pin7 at 2Hz. On a button press…

A: Given :- Write a program that starts out by flashing an LED connected to pin7 at 2Hz. On a button…

Q: What is the logic system for Gamma Area Monitor?

A: The answer is given below step.

Q: please create the schematic on KiCad software for this circuit

A:

Q: 8051 Assembling program: design a program Count down from 9000 to 8000, show it on 7-segment LED,…

A:

Q: (b) Describe the state diagram below in detail. Hint: This state machine describes the operation of…

A: The educational objective of this laboratory is to investigate the creation of custom IP to…

Q: In a given system, if the damping factor is observed to be equal to "0" then the system is…

A: SOLUTION :-  Undamped

Q: Define Admission Control.

A: The above question that is what is admission control is answered in below step

Q: In one hand, the .circuit is specified by a time sequence of inputs, outputs, and internal states.…

A: Sequential Circuits: - This circuit is specified by a time sequence of inputs, outputs and internal…

Q: a) Draw the truth table describing the functionality of this digital logic block. b) Find the…

A: (a) Truth Table : Input variables : A, B, C, D Output variable : Y   INPUTS OUTPUT   A B…

Q: Design and upload a circuit where each time PB1 is pressed and released, data file D0020 in

A: However, when the pushbutton PB! switch is pressed, power is transmitted to the PLC's X1 input. Any…

Q: Find the resistor value to create a timer for 100 second using 0.002 F CapacitorMulti Line Text.

A: var seconds_inputs =  document.getElementsByClassName('deal_left_seconds');     var total_timers =…

Q: 10. Consider the following state diagram of control unit, that has four states and two inputs x and…

A:

Q: Problem_#01] The input shown signal shown below is applied to an inverter. Draw a timing diagram…

A:

Q: diagra escribes operation of a servo motor (scans three angles 0°, ± 90º) based on the pushbutton…

A: what is servo motor? The servo motor is used for servo system. The servo system is a control system…

Q: Controller considers as Synchronous Sequential circuit. False True

A: Given:

Q: The serial data input waveform and data selectors are shown in Fig. (8-6). Determine the data-output…

A: The truth table which determines the outputs of 1-to-4-line demultiplexer is as follows:

Q: Program using NXT or EV3 Activate the servo motor to drive the vehicle forward for 10 SEC Turn…

A: #include //Servo library Servo servo_test; //initialize a servo object for the…

Q: A multiplexer with 32 data inputs has control input(s) and output(s) ) 5 ... 32 32 .. 5 O 1... 32…

A: MULTIPLEXER: A multiplexer, also called a data selector, is a system that selects one of many…

Q: a description of how the clock works

A: Clock: A clock is a microprocessor that controls the time and speed of all computer processes.

Q: A circuit has a pushbutton switch connected to pin PD0 and a servomotor connected to PC0 of AVR…

A: #define F_CPU 1000000UL #include<avr/io.h> #include<util/delay.h> void main() {…

Q: 1. Design the ladder logic for turning ON an output (OUT 1) when normally open pushbutton (IN 1) and…

A: output (OUT_1) -normally open pushbutton (IN_1) and switch (IN_6) are closed. OUT_1 is always on…

Power System

A power system is a network that distributes the electric power produced by the generating plants to the loads using the distribution network. The network is mostly an alternating current (AC) network. The power system mainly consists of generators, loads, transformers, transmission networks, and switchgear (protection equipment).