Part A: Step Down Transformer Primary Primary Secondary Secondary Coil Winding Vp Np Trans Coil Vs Ns Rat (inner) Voltage Winding (VP) (outer) Voltage (Vs) (write as a ratio) (write as a ratio) (writ (NP) (Ns) nur 240 5 240 120 80 240 10 240 15 240 20 60 240 25 48 240 30 5 40 240 35 34.29 Part B: Step Up Transformer Primary Primary Secondary Secondary Coil Vp Np Trans (inner) Coil (nuter) Vs Ns Rat 5

Q: A 50.0-µF capacitor has an initial charge of 500.0 µC. 1) If a resistance of 60.0 Q is connected…

A: capacitance (C) = 50μFcharge (Q) = 500μC

Q: A 0 0 0 0 1 1 1 1 A B B 0 0 1 1 0 0 1 1 B + C C 0 1 0 1 0 1 0 1 B+C A(B+C)potion A(B+C)

A:

Q: 0.0012 g/mL m' %3D d. m erro 8.0 g/mL = MP (8) (g/mL) (8) (%) da water 2.0000 1.00 m'(1-4) Mp. Q1…

A:

Q: tree is 2 metres tall when it is planted it grows at a rate of 11 % pre year   determine an…

A: Solution

Q: Calculate the x-component of the forces. R =175 cos 60° +130 cos 160° %3D R =-34.66 gm %3D Calculate…

A: A force is a vector quantity that is applied to an object of mass m which results in a change in…

Q: convert 5 gallons of water to liters using dimensional analysis

A: convert 5 gallons of water to liters using dimensional analysis

Q: Similar situation to the previous question, but now the object s mass is 25.8 kg and you initially…

A:

Q: An applied force of 20 N accelerates a block across a level, frictionless surface from rest to a…

A: Appled force is Initially object is at rest, that is, Final velocity is Time is Note:Find:Work done…

Q: Define units of volume.

A: All matter occupies space. This space is known as the volume of that matter. Almost all physical…

Q: 11. A 2-kg block starts from rest at the top of a 10-m long ramp inclined at 45 deg to the…

A: The coefficient of friction between the block and the ramp is 0.42

Q: Speed

A: Given: For Trial 1, time is t1=5.50 s and distance is d1=23.2 m For Trial 2, time is t2=6.70 s and…

Q: A box proceeds along the x-axis and the figure below shows a record of its velocity as a function of…

A: Given. Every gridline along vertical axis corresponds to (3.5m/s) and along horizontal axis to (1…

Q: Typed solution and diagram plz

A: The objective of the question is to find the focal length of the contact lens and the distance…

Q: A 0.98-kg beaker containing 1.98 kg of oil (density = 916.0 kg/m3) rests on a scale. A 1.99-kg block…

A:

Q: Help me fill out the rest of the table

A: Ohm's Law: Ohm's law states that the voltage across the conductor is directly proportional to the…

Q: A cubic boxing stains 268 G of water what is the length of one side of the box and meters

A: given quantity of water in cubic box =268 g=0.268 kg Required Length of box

Q: If 1 ft 0.3048 m and 1 lb 4.448 N, convert the following units. a) 270. KN-um into N-m %3D b) 112.8…

A:

Q: 3) Consider two long, straight, parallel, current-carrying wires, separated by a distance d = 1.5…

A: Visualize the Problem:

Q: 1) In an oscillating LC circuit, L = 1.10 mH and C= 4.00 uF. The maximum charge is 5 µC. Find the…

A:

Q: A generation is about one-third of a lifetime. Approximately how many generations have passed during…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.