Part A Pipe AB has a diameter of 40 mm. Water flows through it at a rate of 0.017 m³/s. The pipe and water within it have a total mass of 9 kg. (Figure 1) Determine the x-component of force that must be supported at A to hold the pipe in place. Express your answer to three significant figures and include the appropriate units. Ax = ON Figure A B Submit Previous Answers ✓ Correct Part B Determine the y-component of force that must be supported at A to hold the pipe in place. Express your answer to three significant figures and include the appropriate units. CμA ? 1 of 1 Ay = - 166.4 N Submit Previous Answers Request Answer × Incorrect; Try Again; 5 attempts remaining 2 m Provide Feedback

Part A Pipe AB has a diameter of 40 mm. Water flows through it at a rate of 0.017 m³/s. The pipe and water within it have a total mass of 9 kg. (Figure 1) Determine the x-component of force that must be supported at A to hold the pipe in place. Express your answer to three significant figures and include the appropriate units. Ax = ON Figure A B Submit Previous Answers ✓ Correct Part B Determine the y-component of force that must be supported at A to hold the pipe in place. Express your answer to three significant figures and include the appropriate units. CμA ? 1 of 1 Ay = - 166.4 N Submit Previous Answers Request Answer × Incorrect; Try Again; 5 attempts remaining 2 m Provide Feedback

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter7: Length And Length-related Variables In Engineering

Section: Chapter Questions

Problem 43P: A 10 cm long rectangular bar (when subjected to a tensile load) deforms by 0.1 mm. Calculate the...

See similar textbooks

Similar questions

A structural member with a rectangular cross section as shown in the accompanying figure is used to support a load of 2500 N. What type of material do you recommend be used to carry the load safely? Base your calculations on the yield strength and a factor of safety of 2.0.
Determine the specific gravity of the following materials: gold ( = 1208 lb/ft3), platinum ( = 1340 lb/ft3), silver ( = 654 lb/ft3), sand ( = 94.6 lb/ft3), freshly fallen snow ( = 31 lb/ft3), tar( = 75 lb/ft3), hard rubber ( = 74.4 lb/ft3).
Bourdon-type pressure gauges are used in thousands of applications. A deadweight tester is a device that is used to calibrate pressure gauges. Investigate the operation of a deadweight pressure tester. Write a brief report to discuss your findings.
The results of a tensile test are shown in Table 1.5.2. The test was performed on a metal specimen with a circular cross section. The diameter was 3 8 inch and the gage length (The length over which the elongation is measured) was 2 inches. a. Use the data in Table 1.5.2 to produce a table of stress and strain values. b. Plot the stress-strain data and draw a best-fit curve. c. Compute the, modulus of elasticity from the initial slope of the curve. d. Estimate the yield stress.
According to Figure 5-20, is ii possible to completely separate one of the four materials from the other three? Explain your answer.
An astronaut has a mass of 68 kg. What is the weight of the astronaut on Earth at sea level? What are the mass and the weight of the astronaut on the Moon, and on Mars? What is the ratio of the pressure exerted by the astronauts shoe on Earth to Mars?