Part AFor the heat engine shown in the figure, Q1 = 20 J and Q2 = 72 J. (Figure 1)What is Wut for the heat engine shown in the figure?Express your answer to two significant figures and include the appropriate units.HẢ?Wout =ValueUnitsSubmitRequest AnswerPart BWhat is Qu for the heat engine shown in the figure?Express your answer to two significant figures and include the appropriate units.HAQH =ValueUnitsSubmitRequest AnswerFigure< 1 of 1Part Cp (kPa)What is the thermal efficiency for the heat engine shown in the figure?Express your answer using two significant figures.400200V (cm³)200SubmitRequest Answer100

Given Q1 = 20 JQ2 = 72 JFind the Wout , QH and η.

Answered: Part A For the heat engine shown in the…

Similar questions

Problem solving - Questions given in the image below
Solve using the given problem in the picture i) If an electric heat pump is used to supply this energy, determine the minimum theoretical work input for one day of operation, in kJ/day.* a. 4.70 x 10^5 kJ/day b. 2.76 x 10^2 kJ/day c. 3.98 x 10^5 kJ/day d. 3.26 x 10^2 kJ/day
Pls solve this question correctly instantly in 5 min i will give u 3 like for sure
Parts 1-3 have been answered I need 3-6 answered
Thermodynamics Question! Please and thank you for all your help! Please make sure the answer is valid and in the correct units!
Don't use chat gpt plz Solve correctly
Given in the writing answer
This is not a exam problem I need help on this homework question. I woul like help on a step by step solution so I can see and understand the problem. Can you please show all of work. Problem 2 A house is to be heated by a heat pump. The house loses 500 KW of heat while 200 KW of heat is generated by people and appliances inside the home. The house needs to be maintained at 22°C and the outdoor temperature is 12°C. 270 kW of heat is extracted from the outdoors. (a) what is the power required to drive the heat pump (b) Determine the entropy change of the two reservoirs and state if the heat pump satisfies the increase of entropy principle
Could I receive a detailed response
An ideal gas is heated from 25.0°C to 335°C under a constant pressure of 2.81 kPa. i. If its initial volumeis 1.45m?, what is its final volume? ii. If the change in internal energy is 5.84kJ, how much heat is added to the gas? Assume any kinetic and potential energies are negligible. ii. What type of a process is this? Given: • Energy balance on a closed system at steady state AU + AE + AE, = Q – W, where U stands for internal energy, E for kinetic energy, E, for potential energy, Q for heat flow and W for work done by the system. PV = nRT, R = 8.314 = 8.314: T(K) = T(°C) + 273.15; 1N = 1 m: 1 Pa = 1. m³Pa mol K mol K %3D Constant P: W = P(V; - V.); Constant T: W = NRTIN
Work, Energy & Power Directions: Illustrate and solve the following problems places then box your final answer. Use g=9.81 m/s^2. Since this is a problem solving, a mistake in a preceding step will render the answers in the next step wrong. a clean sheet of paper. Express your answer in two decimal 2. How many particles are present in a closed container if the energy it contains is 93523.83 J, and the diatomic oxygen gas is moving at a velocity of 53.34 m/s? Use only the whole number for the value of atomic mass unit. Express your answer in proper scientific notation.
What is the difference between thermodynamic and mechanical work? Should they show equal values in the experiment? If yes, what possible errors could have caused the difference in their values? The given, instructions for experiment, and calculations are all indicated in the picture