Part AEstimate the pressure needed to raise a column ofwater to the same height as a 46-m-tall pine tree.Express your answer to two significant figures andinclude the appropriate units.P=OμAValueUnits? Part AWhat is the difference in blood pressure (mm-Hg)between the bottom of the feet and the top of the headof a 1.83-m-tall person standing vertically?1 mm-Hg = 133 N/m². The density of blood is1050 kg/m³.Express your answer using three significant figures.ΔΡ||=VΑΣΦ?mm-Hg

Given that, The height of the pine tree is h=46m And we have to calculate the pressure required to…

Answered: Part A Estimate the pressure needed to…

Similar questions

Only A-C
When a garden hose with an output diameter of 20 mm is directed straight upward, the stream of water rises to a height of 0.16 m. You then use your thumb to partially cover the output opening and constrict it so that its diameter is reduced to 1.0 mm. Part A Calculate how high the water would rise. Express your answer with the appropriate units. ☐ ΜΑ ? h = Value Units Submit Request Answer
The drawing shows an intravenous feeding. With the distance shown, nutrient solution (p = 1020 kg/m³) can just barely enter the blood in the vein. What is the gauge pressure of the venous blood? Express your answer in millimeters of mercury. Atmospheric pressure 0.610 m Number i Units
9. A fountain shoots water 8 m straight up. a. What is the pressure at the point where the water exits the pipe at ground level and when it reaches it maximum height of 8 m? b. How fast must the water be moving when it exits the pipe at ground level?
A 5.8 cm diameter horizontal pipe gradually narrows to 4.1 cm. When water flows through this pipe at a certain rate, the gauge pressure in these two sections is 31.0 kPa and 22.2 kPa, respectively. Part A What is the volume rate of flow?
A piece of wood is 0.590 m long, 0.270 m wide, and 0.076 m thick. Its density is 700 kg/m³. Part A What volume of lead must be fastened underneath it to sink the wood in calm water so that its top is just even with the water level? Express your answer in cubic meters. V= —| ΑΣΦ| Submit Previous Answers Request Answer Part B X Incorrect; Try Again; 7 attempts remaining What is the mass of this volume of lead? Express your answer in kilograms. m= C | ΑΣΦ] 6 a ? ? m3 kg
please answer in m
Water flows with a constant speed through a pipe of constant cross-sectional area in the ground floor (y1=0m) of a house. The pipe rises (y2=5.0m) to reach a shower head on the second floor. The pressure at ground level is 140kPa. a) what is the pressure at the shower head? b) what is the maximum height that water from the ground level could reach?
The spring of the pressure gauge shown in the figure below has a force constant of 1 350 N/m, and the piston has a diameter of 1.40 cm. As the gauge is lowered into water in a lake, what change in depth causes the piston to move in by 0.700 cm? 4.635 X Your response differs from the correct answer by more than 10%. Double check your calculations. m Vacuum
6. A 100 cc block of Styrofoam (density 100 kg/m³) is held by a massless string, attaching the bottom of the block to the bottom of the vat, in a vat of water (density 1 gm/cc) as shown in the diagram. А. I Sketch and label the forces (with a brief description) on the free body diagram for the Styrofoam block? В. What is the tension in the string?
A very deep point of the Pacific Ocean is at a depth of 10,100 m below the surface. What is the gauge pressure in the water at that point? The density of seawater is 1025 kg/m3. Ignore the slight variations of g and ρ with depth. Assume g = 9.80m/s2. Assume 3 significant digits. A. 8.88 ×107 Pa B. 2.22 ×108 Pa C. 1.11 ×108 Pa D. 1.01 x108 Pa E. 3.33 ×108 Pa F. 5.55 ×107 Pa
A container filled with water and there are two holes, as shown in figure below. What is the ratio of x1 to x2? 20 cm 100 am 50 cmB X1 X2 13. Given frictionless flow of water at 125.6 ft'/s in a long, horizontal, conical pipe of diameter 2ft at one end and 6ft at the other. The pressure head at the smaller end is 18ft of water. Find the velocities at two ends and the pressure head at the larger end.

SEE MORE QUESTIONS

Part A Estimate the pressure needed to raise a column of water to the same height as a 46-m-tall pine tree. Express your answer to two significant figures and include the appropriate units.