A 6.5-cm-diameter horizontal pipe gradually narrows to 4.0 cm. When water flows through this pipe at a certain rate. the gauge pressure in these two sections is 31.0 kPa and 23.0 kPa, respectively. Part A What is the volume rate of flow? Express your answer using two significant figures. Q= ΜΕ ΑΣΦ [www] ? m³/s

A 6.5-cm-diameter horizontal pipe gradually narrows to 4.0 cm. When water flows through this pipe at a certain rate. the gauge pressure in these two sections is 31.0 kPa and 23.0 kPa, respectively. Part A What is the volume rate of flow? Express your answer using two significant figures. Q= ΜΕ ΑΣΦ [www] ? m³/s

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A piece of wood is 0.590 m long, 0.270 m wide, and 0.076 m thick. Its density is 700 kg/m³. Part A What volume of lead must be fastened underneath it to sink the wood in calm water so that its top is just even with the water level? Express your answer in cubic meters. V= —| ΑΣΦ| Submit Previous Answers Request Answer Part B X Incorrect; Try Again; 7 attempts remaining What is the mass of this volume of lead? Express your answer in kilograms. m= C | ΑΣΦ] 6 a ? ? m3 kg
A3.0 mL syringe has an inner diameter of 4.0 mm, a needle inner diameter of 0.29 mm, and a plunger pad diameter (where you place your finger) of 1.2 cm. A nurse uses the syringe to inject medicine into a patient whose blood pressure is 140/100. Assume the liquid is an ideal fluid. Part A What is the minimum force the nurse needs to apply to the syringe? Express your answer in newtons. |VG ΑΣΦ F = Submit Part B X Incorrect; Try Again; 5 attempts remaining Previous Answers Request Answer V= Submit The nurse empties the syringe in 3.8 s. What is the flow speed of the medicine through the needle? Express your answer in meters per second. [5] ΑΣΦ ? 3 Previous Answers Request Answer ? N X Incorrect; Try Again; 5 attempts remaining m/s
The gravitational force exerted on a solid object is 5.20 N as measured when the object is suspended from a spring scale as in Figure a. When the suspended object is submerged in water, the scale reads 3.08 N (Figure b). Find the density of the object. 3333.33 Your response differs from the correct answer by more than 10%. Double check your calculations. kg/m3 Scale B Mg a
For question A and B
The spring of the pressure gauge shown in the figure below has a force constant of 1 350 N/m, and the piston has a diameter of 1.40 cm. As the gauge is lowered into water in a lake, what change in depth causes the piston to move in by 0.700 cm? 4.635 X Your response differs from the correct answer by more than 10%. Double check your calculations. m Vacuum
Glycerin flows through a tube that expands from a 1.00 cm“ cross-section area at point 1 to a 4.00 cm cross-section area farther downstream at point 2. The pressure difference between points 1 and 2 is 9.45 kPa. Part A What is the speed of the glycerin at point 1? Assume that the glycerin flows as an ideal fluid. Express your answer with the appropriate units. v1 = Value Units Submit Request Answer Part B What is the speed of the glycerin at point 2? Assume that the glycerin flows as an ideal fluid. Express your answer with the appropriate units. ? V2 = Value Units Submit Request Answer Provide Feedback
▾ Part A What gauge pressure must a pump produce to pump water from the bottom of the Grand Canyon (elevation 730 m) to Indian Gardens (elevation 1370 m)? Express your result in pascals and in atmospheres. Pgauge 6.27x108 Pa Submit ✓ Correct Part B Pgauge= Previous Answers Submit VΓΙΑΣΦ Request Answer ? atm
A very deep point of the Pacific Ocean is at a depth of 10,100 m below the surface. What is the gauge pressure in the water at that point? The density of seawater is 1025 kg/m3. Ignore the slight variations of g and ρ with depth. Assume g = 9.80m/s2. Assume 3 significant digits. A. 8.88 ×107 Pa B. 2.22 ×108 Pa C. 1.11 ×108 Pa D. 1.01 x108 Pa E. 3.33 ×108 Pa F. 5.55 ×107 Pa
You have three objects of varying shapes and sizes: Object 1 is a rectangular block of tin. Object 2 is a cube of aluminum. Object 3 is a sphere of copper. a. the density of tin is 5.75g/cm2. What is the mass of object 1 in kg if the rectangular block has a volume of 1.34L? b. what is the volume in cubic inches of object 2 if the cube of aluminum 7.58 inches on a side? c. what is the mass in kg of object 2? the density of aluminum is 2.70g/cm3 d. what is the volume in cm3 of object 3 if the sphere of copper has a diameter 8.62cm? the volume of the sphere is 4 {pi}^3/3 e. what is the mass in kg of object 3? Copper has a density of 8.96g/cm3
Part A What volume of water has the same mass as 3.0 m³ of ethyl alcohol? Express your answer with the appropriate units. Vwater = Value Submit Part B Request Answer P = If this volume of water is in a cubic tank, what is the pressure at the bottom? Express your answer with the appropriate units. AI Value Units A Ć Units ? ?
Water flows from the pipe shown in (Figure 1) with a speed of 4.0 m/s. Figure 1 of 1 Part A What is the water pressure as it exits into the air? Express your answer using four significant figures. P� = kPakPa SubmitRequest Answer Part B What is the height hℎ of the standing column of water?
Part A How deep underwater should you dive to quadruple the atmospheric pressure at the surface? Note: 1 m = 3.28 ft. Express your answer in feet to one significant figure. Π. ΑΣΦ h=135.65 B Submit Previous Answers Request Answer Provide Feedback ? X Incorrect; Try Again; 5 attempts remaining ft P Pears