Given information Mass flow rate =8600 kg/s, V= 11 m/s, Find, Extracted energy,

Part A A wind turbine works by slowing the air that passes its blades and converting much of the extracted kinetic energy to electric energy. A large wind turbine has 45-m-radius blades. In typical conditions, 86,000 kg of air moves past the blades every second. passes the blades and the wind turbine extracts 40% of this kinetic energy, how much If the air is moving at 11 m/s before energy is extracted every second? Express your answer with the appropriate units. ? E = Value Units Submit Request Answer

Part A A wind turbine works by slowing the air that passes its blades and converting much of the extracted kinetic energy to electric energy. A large wind turbine has 45-m-radius blades. In typical conditions, 86,000 kg of air moves past the blades every second. passes the blades and the wind turbine extracts 40% of this kinetic energy, how much If the air is moving at 11 m/s before energy is extracted every second? Express your answer with the appropriate units. ? E = Value Units Submit Request Answer

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

QUIZ 1. A compressor draws in 0.25 m³/s of air whose density is 1.26 kg/m³ and discharges it with a density of 4.87 kg/m³. At the suction, P1 = 103.4 kPaa; at the discharge, P2 = 551.4 kPaa. The increase in the specific internal energy is 78.63 kJ/kg, and the heat from the air by cooling is 30.24 kJ/kg. Neglecting changes of potential and kinetic energy, determine the work on air in kW, BTU/min, and Hp. 2. Consider an underground water source whose free surface is 60 m below ground level. The water is to be raised 5 m above the ground by a pump. The diameter of the pipe is 10 cm at the inlet and 15 cm at the exit. Neglecting any heat interaction with the surrounds and frictional heating effects, determine the power input to the pump required for steady flow of work at a rate of 15 liters per second. 3. A piston cylinder arrangement contains 100 liters of saturated water and 900 liters of saturated steam in equilibrium at 1 MPaa (t,at = 179.91°C, V1 = 1.273x10° m³/kg and vạ1 =194.44x103…
The steam turbine shown below has a single inlet and two exit streams. It is assumed that the turbine is well insulated and the change in potential energy is negligible. The energy equation governing the turbine based on these assumptions is: Turbine inlet W. C.V. C.V. I 2.
10. High pressure steam enters a turbine with a velocity of 38 meters/sec and leaves the exhaust trunk with a velocity of 305 meters/sec. Calculate the kinetic energy of the steam at the exhaust trunk in N-m/kg.
In a certain community, they are using steam-powered turbines to produce electricity. Steam flows adiabatically in a turbine through a 3" pipe at a velocity of 10 ft/s. It exits through the exhaust with a standard 10" pipeline. Calculate the power output in Btu/s of the turbine. Condition of steam at the entrance: 200 psi, 600°F; at the exit: 4 psi, 160°F. [Hint: Power is the product of work and mass flow rate.]
A steam catapult is used to assist the acceleration of aircraft from standstill to flight speed in a very short distance. Steam is admitted to the cylinder and steam pressure acts on a piston sliding in a cylinder. The force produced is transmitted to the aircraft by means of a suitable linkage. a) Determine the work done by the steam on the piston if steam is admitted to the cylinder at 20 bar throughout the 25 m stroke. The piston diameter is 500 mm. It may be assumed that the process is reversible. (Ans: W = 9.817 MNm or MJ) m %3D b) In some instances steam is admitted for part of the stroke only and thereafter the fixed mass of steam in the cylinder expands to a reduced pressure. If steam is admitted at 20 bar for 60% of the stroke, the pressure falling linearly to 4 bar over the remainder of the stroke, sketch a diagram of steam pressure against volume and determine the new work done. (Ans: W = 8.24 MJ)
Now suppose, instead of being lifted straight up, the (100 Kg) rock is elevated to 10 meters by rolling it up a ramp. If the rock is released and allowed to roll down the ramp, what will its kinetic energy be at the bottom of the ramp?
Shown below is a motor rising a 5 kg mass. If the solar panel shown receives solar energy at a rate of 900 W/m?, if its area is 2 m², the voltage that it produces is 12 V and its efficiency is 15 %. (a) How much current is the solar panel producing? . (b) What is the rate of heat dissipation? (c) How fast is the motor dissipating heat? (d) At what velocity will the mass shown rise. Assume that the temperatures remain the same all through the system and that the angular velocity of the motor is constant. Area = 2 m² AV = 12 V O = ? G = 900 W/m? n = 15 % n = 85 % IR = 0.2 m i = ? Motor Q = ? m = 5 kg in
QUESTION 1 (COLLAB) A new design of Saturn 17 rocket with mass 1.48 x106 kg has a propulsion engine that can eject gases at a constant speed of 241.89 m/s (vGas) by burning fuel at a rate of 2.11 x10 5 kg/s (dmdT). In full tank, the rocket can carry a fuel of mass 40.51 x10 6 If this design exceeds the velocity of 11,200 m/s it can can successfully escape Earth's gravity. Determine if this is so. Find its maximum velocity (velyz). (Pitch Angle = 0) kg.
2. A turbine operates under steady flow conditions receiving steam at the following state: pressure 1200 kilo pascal, temperature 188 degrees celsius, Enthalpy 2785 kilojoule per kilogram, speed 33.3 meter per second and elevation 3 m the steam leaves the turbine at the following state; pressure 20 kilo pascal, enthalpy 2512 kilojoule per kilogram, speed 100 m per second and elevation 0 m. Heat is lost to the surroundings at the rate of 0.29 kilojoule per second. if the rate of steam flow through the turbine is 0.42 kg per second. What is the work in kJ/kg and what is the power output of the turbine in kw?
The wind velocity on the upstream side of a wind turbine is 4 m/s. If the turbine extracts 26% of the available kinetic energy, what is the wind velocity on the downstream side of the turbine in m/s? Please include one decimal place in your answer.
Nhand,A 75 N ma = 3 kg %D VA = 8 m/s Block Block Block Block B A Hx = 0.4 %3D 2 m Ax Note: Diagram is not drawn to scale A hand pushes block A (m,= 3 kg) with a constant force Nand. A= 75 N for a distance Ax 2 m along a (mostly) frictionless table such that it speeds up from rest and is traveling at a speed of 8 m/s after it slides over a rough section of the table (H = 0.4). Block A then collides with a more massive block B (mg = 6 kg) that is initially at rest. Find the speed of block A after it has been released by the hand and just before the rough section of the table. A) 10 m/s B) 20 m/s C) 30 m/s D) 40 m/s E) 50 m/s O A O B O D O E
QUESTION 3 A Pelton wheel with a needle-controlled nozzle develops 1 050 kW against a gross head of 300 m. The loss of head due to friction in the pipeline and the nozzle is 60 x V, where V is the flow rate in m/s. Assuming that the overall efficiency of the wheel remains constant at 83%, determine the percentage reduction in flow rate required when the power developed is reduced to 710 kW by closing a valve on the pipeline partially.