On a circular conduit there are different diameters: diameter D1 = 2 m, changes into D2 = 3 The velocity in the entrance profile was measured: v1 = 3 m/s. Calculate the discharge and velocity at the outlet profile (see figure below). Determine also type of flow in both conduit profiles (whether the flow is laminar or turbulent) – temperature of water T = 12° C. (use Reynold's number Re), For laminar flow: Re<2320, For turbulent flow Re>2320, Kinematic viscosity of water of 12°C, v is equal to 1,24 10^-6 m2/s %3D VD, D2 Figure

Q: )Water 10°c flows down through a 53.13 deg, nclined, converging pipe section as shown. The fiow…

A:

Q: 1 QUESTION 1 Consider a desired pump operating condition which adds 35 psi at a flowrate of 500 gpm…

A: Given data  Flow rate = 500 gpm Pressure = 35 psi Density = 62 lbm/ft^3 Find the pump head

Q: From the theory, the equation governing the flow rate through a orifice meter is shown as follows:…

A: The inner diameter is The outer diameter is The difference in pressure is

Q: 7 WATER FLOWS IN A PIPE OF CONSTANT CROSS AREA 5 CM. THE PIPE IS BENT AT 90° AS SHOWN IN THE FIGURE…

A:

Q: A 200 kg chunk of lead falls from a height of 30 m and smashes into a rigid concrete floor.…

A: Disclaimer: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: A pipe handles a flow rate Q of 24 gpm. Find the minimum inside diameter D that will provide an…

A: Given: Volume flow rate, Q=24gpmAverage fluid velocity, v=20ft/s

Q: Take water density p = 998 kg/m° and dynamic viscosity u = 0.001 kg/(m.s). The total flow rate is…

A:

Q: he figure shown below is a series pipeline system used to draw a fluid from a lower source open tank…

A: Given       Volume flow rate: Q=0.015 m3/s                     Length: Ld=100 m Elevation…

Q: (Determination of Pi terms) The flowrate, Q, in an open canal or channel can be measured by placing…

A:

Q: A straight transfer pipe of length L = 10 m and D = 1 cm carries a liquid in highly turbulent flow…

A: When fluid flows in the pipe it has some losses due to that pressure drop occur in the flow. Due to…

Q: A hydraulic pump is shown in the following Figure, flow rate is 25 L/min, the diameter of suction…

A:

Q: Consider flow of water (μ = 0.001 Pa-s) in the 6-cm diameter cast-iron (ε = 0.26 mm) pipe shown in…

A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…

Q: C2. A circular pipe 1 of 535 mm diameter branches into two pipes (pipe 2 and pipe 3) of diameters…

A:

Q: On a circular conduit there are different diameters: diameter D1 = 2 m, changes into D2 = 3 m. The…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.