A piece of metal with a length of5mm, a cross-section area of0.5mm and the specific resistanceof the metal is 81.6, noting that thedensity of the material is 8.96kg/mand the atomic weight of the metalis 63.54. Calculate the movementof the electron and the averagefree time

Given-Length = 5mmCross section area= 0.5 mmSpecific resistance= 81.6 ohm-mDensity= 8.96 kg/mAtomic…

Answered: of the electron and the average

Engineering

Electrical Engineering

of the electron and the average

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: In PN Jn. the depletion region contains

A: Depletion region, also called depletion layer is an insulating region within a conductive, doped…

Q: For a diode, PIV stands for Answer:

A: PIV is the voltage appearing across the diode in reverse bias.

Q: How many eV's are necessay to move an electron with a frequency of 6.15 e 14HZ?

A: Given, Frequency of electron (f) = (6.15)×10^14 Hz Planks constant (h) =6.63×10^(-34) Joule-sec.…

Q: Diode model with large reverse resistance, Please choose one: a. it is a practical model b. is the…

A: Correct option is D) it is full model

Q: 7. What type ef biasing 8 wut fyge of bineing ? 9. I dantify the current rating oF this diode' code.…

A: In this question, We need to type of the biasing, And identify the type of the diode as per…

Q: Find the voltage(E) and current(I) of the diode in 3rd approximation with an internal resistance of…

A: Equivalent Circuit- Equivalent Circuits are those whose construction is different from the main…

Q: 6 kn 12 V Si 3 kn

Q: It 57 Nolb o.6 Volb 2A 6A 0.69Volt 0171 Volf Volf Vorb 0745 Vo16 ou748 Volt toA 0:72 20A- 224

Q: Repeat problem if RL = 470 Ohms Rs Determine: a. If the diode is "ON" b. IL, Is, Iz C. Pz 2202 Vi Vz…

A: Zener diode turns on when open circuit voltage across RL is greater than zener voltage Vz. Based on…

Q: Determine the output voltage VO and the current flowing through the diode for the circuit shown…

Q: In a semiconductor, the concept of an energy gap is used to show the difference between Please…

A: Correct option is C) Conduction band electrons and valance electrons. The definition of energy gap…

Q: Solve the voltage across germanium diode of the given circuit below. 32 V lo2 AGe Si Vo 6.8 kohms 4…

A: Here two anti parallel Si and Ge diode Ge diode is reverse bia and si diode is forward bias cut in…

Q: Determine the variation in the diode voltage if v(t) = 8 +0.2 sin(wt) 4.7K ID v(t) (~ m

A: Given: A circuit, where, v(t)=8+0.2 sinωt, To find: Variation in the diode voltage.

Q: İNGİLİZCE TÜRKÇE RUSÇA What is a diode with a negative resistance region in its characteristic…

A: Diode is an electronic device in which there is unidirectional flow of current. There are various…

Q: For what voltage will the reverse current in a Germanium diode reach 55% of the reverse saturation…

Q: Determine the required PIV ratings of the diodes of Fig. in terms of the peak secondary voltage V…

A: To determine the PIV rating required of the diodes

Q: For the circuit shown below, if the diode is ideal then the magnitude of the average DC current is…

A: so from the given question dc current need to be calculated

Q: A transistor is used as a switch and the waveforms are shown below. The parameters are given as…

A: Given Transistor as switch and waveforms as shown Vcc=200 vVCE(sat)=1 vICS=100 AICEO=1 mArise time…

Q: The number of these in the outer valence band determines whether a material is a conductor,…

A: The valence band is filled with electrons. These electrons are the electrons present in the outer…

Q: What is the dynamic resistance of a diode if its ID = 1.87 mA?

A: At room temperature the dynamic resistance of diode is given as rd=( 26mV/ID) , for Ge and rd=…

Q: 1. Determine the energy gap for Silicon and Germanium at 56°C.

Q: Find the number of electrons and neutrons in the following: 79Se-2 Electrons Neutrons

A: To find the number of electrons and neutrons

Q: fm Q5: A carrier signal of frequency 91 MHz is frequency modulated by a sine signal of amplitude 10…

A: We need to find out the bandwidth for FM signal .

Q: What is GMD in power system, explain in breif.

A: GMD is defined as the geometrical mean distance, it is used for calculating the capacitance and the…

Q: 1. Find the value of Vo

Q: What is the value of reverse recovery charge developed in diode having the rate of fall of diode…

A: Rate of fall of diode is given And recovery time given Find the recovery charge?

Q: 10. The figure below shows a circuit for charging a 12-V battery. If V, is a sinusoid with 24-V peak…

A: The given circuit is, vs=24sinθ

Q: In Fig. 27-33, calculate a. Voutĺpk) b. Ve c. L. d. Idiode e. PIV for any diode. f. fout 120 Vac 60…

A: Given Data:A full wave uncontrolled rectifier coupled with a transformer having,Primary Voltage…

Q: What is the peak output voltage during positive cycle? Use ideal diode H

Q: In PN Jn. The depletion region contains

A: A depletion region or depletion layer is a locale in a P-N intersection diode where no portable…

Q: What is the value of reverse recovery charge developed in diode having the rate of fall of diode…

A: Find the reverse recovery charge of the diode. If the rate of fall of diode is given and recovery…

Q: 100 V 560 N

Q: A 1-phase half wave diode rectifier with R load, has input voltage of 240 V. The input power factor…

A: Given data, Input voltage Vs=240 V

Q: At a thermal voltage of 26mV, find the absolute temperature of a common component like a diode in an…

A: The solution is given below

Q: + R + Vin Vout 5 V =

Q: In testing a diode, if the red probe of an analog ohmmeter is tapped at the cathode while the black…

A: Diode: It is a semiconductor device. This will flow current in forwarding biased condition and does…

Q: What is the speed of an inductor motor of 7 poles if the slip is 2.1%

Q: The minority carriers in n-type semiconductors are Select one: protons holes electrons neutrons

A: In n-type semiconductor majority carriers are electrons. P-type majority carriers are holes

Q: Illustrate the process of forming the diode

Q: -• Deter mine the current'I' for each of the configerae Cons Osing the approxi matde equivalent…

A: The solution can be achieved as follows.

Question

A piece of metal with a length of
5mm, a cross-section area of
0.5mm and the specific resistance
of the metal is 81.6, noting that the
density of the material is 8.96kg/m
and the atomic weight of the metal
is 63.54. Calculate the movement
of the electron and the average
free time

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please answer both subparts
For the an input waveform of +9.21 V to the given circuit, what is the peak value (in V) of the output waveform? Use Germanium diode. 1.png
Question:1 A diode whose internal resistance (forward biased) is 20 2 is to supply power to a 1000 2 load from a 110 V,m.s source of supply. Calculate: i. The peak load current ii. The D.C. load current iii. The A.C. load current iv. The D.C. diode voltage The total input power to the circuit V. R-20Ω 110 V R 10002 r.m.s.
determine the current I for the configuration shown below using approximate equivalent model for the diode
1. Draw the forward and reverse characteristic of the diode on the same paper.
A given BJT, B = 400. What is the value of a for the device? 1.0025 0.9975 0.002 1.00
What is the value of reverse recovery charge developed in diode which is having the rate of fall of diode current 43.6 A/µs and trr is equal to 3.5 µs. a. 763.00 µC b. 534.10 µC c. 122.50 µC d. 267.05 µC
Solve it quickly please
Compute for current (I) for this diode configuration.
10. The figure below shows a circuit for charging a 12-V battery. If V, is a sinusoid with 24-V peak amplitude, the fraction of each cycle during which the diode conducts is 100 n 12 V a) One quarter of a cycle b) One-third of a cycle c) One half of the cycle d) Three quarters of a cycle
Determine the current through each diode if E, E, 0V D1 Si E - 02 S oVo E20 R 1kn 10V O A. 9.3 mA O B. 8.6 mA OCOA O D.4.65 mA OE.0.7 mA
Draw the circuit using only ideal diodes, resistors and voltage sources to obtain the Vo-Vi relationship whose characteristic is given below (the values shown on the characteristic are slope values).