not exceed 1118 -ter of the driven

Q: Draw shear & bending moment diagrams for the shown beams. 2 kN/m 50 kN · m A В -5 m 5 m

A:

Q: O MPa and an axial stress of 325 MPa that act on an element imposes a bending stress of 250 MPa and…

A: Tangential stress is .Axial stress is .Bending stress is .Torsional stress is .

Q: A glue-laminated timber beam is reinforced by carbon fiber reinforced plastic (CFRP) material bonded…

A:

Q: ease consider steam at 500 kPa and 300 C. Please determine a. a and g in kJ/kg. b. vR in ce/gm.

A:

Q: 3. In the given 15.0 meter slab and inclined 5 °with the horizontal, the ends are resting on…

A:

Q: A hollow steel tube with an inside diameter of 110 mm must carry a tensile load of 480 kN. Determine…

A:

Q: A uniform solid cylinder of mass m and radius R is set in rotation about its axis and lowered with…

A:

Q: For the truss loaded as shown, determine the equation for the line of action of the stand-alone…

A: Given,

Q: If 5.5m³ of nitrogen at 30°C and 5.1kPa abs is permitted to expand isothermally to 7.4m3, what is…

A: For isothermal process P1V1 = P2V2  here, P1 = 5.1 kpa V1 = 5.5 m3 V2 = 7.4 m3

Q: A two-tier system to repair bridges is supported by two steel cables for each platform. Lengths of…

A: Given:- lA=55in lD=180in Workers load=160lb ∆L=0.01in To find:- Diameter of cable A, B, C and D

Q: Problem 3 A 10 m' onyaen tark is at 15°C and S00 kPa. The vahe is opened, and some onyaen is…

A:

Q: The stress tensor at a point in a body is given by the following matrix with reference to x-y-z…

A:

Q: Aluminium with a mass of 100 kg and an initial temperature of 20, 6\deg C is to be melted in an…

A: The mass of the aluminum, The initial temperature of aluminum, The melting point of aluminum, The…

Q: A man exerts a force Fon the handle of the stationary wheelbarrow at A. The weight of the…

A:

Q: Water is the working fluid in a regenerative Rankine cycle with one closed feedwater heater and one…

A: INTRODUCTION :The regeneration is a procedure in which the turbine exhaust is used to raise the…

Q: Example For the parallel Multiple pipe loop system. of Fig. P6.116, all pipes are 8-cm-diameter…

A: Very small variation in final answer from given answer because I took 4 digit accuracy.

Q: Four people are attempting to move a stage platform across the floor. If they exert the horizontal…

A:

Q: 1) A compressor is delivering air at a pressure of 8 bar gauge at the rate of 10 m3/min f.a.d.…

A: A compressor is a mechanical device that reduces the volume of gas in order to increase its…

Q: Four people are attempting to move a stage platform across the floor. If they exert the horizontal…

A: Given  F1 = 77 lb, F2 = 76 lb, F3 = 48 lb , F4 = 75 lb, a = 81 in. , b =64 in. ,  θ = 43o   To…

Q: An iron bar 2.0 cm x 3.0 cm x 10.0 cm at a temperature of 95 °C is dropped into a barrel of water at…

A: The rate at which an exposed body changes temperature through radiation is approximately…

Q: If the Quality Cost increases by 2.5% and the Production Index increases by 2.5%, then by how much…

A: Product index = ratio of quality costs to the total costs

Q: Refrigerant 134a expands in a piston-cylinder assembly from p₁ = 160 lb/in2 and T₁ = 140°F to p2 =…

A:

Q: 5. A gas undergoes two processes: 1-2: polytropic compression from P₁ to P₂ with a polytropic…

A:

Q: An electric motor operates at 600 rpm and displaces a piston of a hydraulic pump by 200 cm³ per…

A:

Q: Q3: a: A centrifugal pump used to take water from reservoir to another through 800 m length and 0.15…

A:

Q: A weight is hanging on the structure. The weight exerts a force of F1 (5.65x10^2) kN %D Determine…

A:

Q: An insulated mixer takes in a 1st stream of air at 1139.54 K with mass flow rate of 1 kg/s and a 2nd…

A:

Q: Question: Doberty rate tariff is applied for Option 1: loads Option 2: medium consumers Option 3:…

A: Doherty Rate Tariff : the tariff which is paid by the customer. The amount is additional to the…

Q: Using W760X134 as the section for the beam, determine the value (kN) of the nominal collapse load…

A:

Q: An experimental device imparts a force of magnitude F = 41 lb to the front edge of the rim at A to…

A:

Q: 4.) A 3-m-internal-diameter spherical tank made of 1-cm-thick stainless steel steel is used to store…

A:

Q: in 5 minutes please Diameter=38 L

A:

Q: A specialty coffeehouse sells Colombian coffee at a fair rate of 300 kilograms annually. the beans…

A:

Q: Q3: Find the magnitude, location and slope of the resultant of the force system shown below.

A:

Q: Determine the magnitude of the forces. In the given figure, V = 300 N, V2 = 1.6 m, and V3 = 11 m.…

A: V1=300NV2=1.6 mV3=11mconsidering FBD of joint Cconsidering force qulibirium along x dirction…

Q: . Determine the gage pressure at point A (Figure P4.44) in kilopascals and in pounds per square…

A: As per the guidelines we are subjected to solve only one question at a time. Please repost the same…

Q: 1. The homogeneous bar shown in Fig. P-106 is supported by a smooth pin at C and a cable that runs…

A: Given  Weight, W = 40 kN  Diameter, d = 25 mm                     = 0.025 m Length, AB = 4 m…

Q: The maximum pressure of air in a 20-in cylinder (double-acting air compressor) is 125 psig. What…

A: Given data: P=125 psigN=1.75T=1000°F Need to determine the diameter of the piston rod.

Q: 1.) Consider a sealed 20-cm-high electronic box whose base dimensions are 40 cm x40 cm placed in a…

A:

Q: The ring at Bis supported in equilibrium by spring AB, a cable running through the frictionless…

A: The force value are The angle is The dimension are The unstrected length of spring is

Q: ANSWER THIS IN 5 DECIMAL PLACES SHOW COMPLETE SOLUTION THANKYOU !!

A: The objective of this question is to calculate the net force on the nozzle of a concentric reducer…

Q: 9.) Consider a cold aluminum canned drink that is initially at a uniform temperature of 3°C. The can…

A: We have given

Q: The ears of a rabbit can be thought of as two rectangular fins that dissipate heat. The dimensions…

A:

Q: An insulated mixer takes in a 1st stream of air at 1139.54 K with mass flow rate of 1 kg/s and a 2nd…

A: Given:-T1=1139.54 KT2=384.599 KT3=635.426 Km1=1 kg/sTo find:-m2

Q: Compute the moment (positive if counterclockwise, negative if clockwise) of the 0.54-lb force about…

A: Given date:- Force (F) = 0.54 lb

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.