friction: 41Fsmax=98.411. You are pushing a 2.3-kg crate across the floor with a force of 9.5 N. If the coefficient of kinetic frictionbetween the crate and the floor is 0.32, what is the frictional force between the crate and the floor? Justifyyour answer.12. An experiment was performed where a 123-N block resting on a horizontal table was pulled by a stringwith an increasing amount of force. The figure shows a graph of the frictional force exerted on the block vsthe horizontal force pulling on the block.f(N)(a) According to the graph, what in the maximumstatic friction between the block and the table? 75NStatic(b) Use values from the graph to find thecoefficient of static friction between the block,and the table. Justify your answer. 75N=Ns X123123[23061 = N₂75.050.025.00(f) Suprtor(c) According to the graph, how much kinetic friction was there between the block and the table?tx=NK • FN- PO25.0 50.0 75.0 100.0 125.0 150.0(d) Use values from the graph to determine the coefficient of kinetic friction between the block and the tJustify your answer.ond 123-N block was placed onock, and the experiment was repeated.e graph of frictional force vs. the horizontallook like, including values for maximumriction and kinetic placed appropriately on the graph.the block started from rest and was pulled with 51.0 N of force, how much friction would there beetween the block and the table? Justify your answer.

Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…

Answered: no.41 Fsmax-98.4 11. You are pushing a…

Similar questions

A block weighing 38 kg is on an incline with a slope of 17o. If the block is at the verge of sliding down the incline, what is the static frictional force of resistance? A block weighing 25 kg is on an incline with a slope of 28o. If the block is at the verge of sliding down the incline, what is the static friction coefficient?
A 5kg crate is simultaneously acted upon by a force of 60N acting to the right that is parallel to the surface, and a force of 10N acting to the left, which makes a 30 degree angle with the horizontal. If the coefficient of kinetic friction is 0.15, then the magnitude of the acceleration of the crate is about _____ m/s2.
A wooden block experiences a frictional force, f, as it slides across a table. If a block of the same material with half the height and twice the length were to slide across the table, what would be the frictional force it experienced?A. (1/2)fB. fC. 2fD. 4f
A person pushes horizontally with a force of 200. N on a 56.0 kg crate to move it across a level floor. The coefficient of kinetic friction is 0.19. (a) What is the magnitude of the frictional force? (b) What is the magnitude of the crate's acceleration?
A crate starts from rest and slides 8.05 m down a ramp. When it reaches the bottom it is traveling at a speed of 5.55 m/s. If the ramp makes an angle of 23.0o with the horizontal, what is the coefficient of friction between the crate and the ramp?
The coefficient of static friction between a rubber tire and dry pavement is about 0.800. Assume that a car's engine only turns the two rear wheels and that the weight of the car is uniformly distributed over all four wheels. What limit does the coefficient of static friction place on the time fmin required for a car to accelerate from rest to 50.0 mph (22.4 m/s)? Imin = How can friction accelerate a car forward when friction opposes motion?
A sled is on a horizontal surface and a rope with tension T is pulling on it at an angle e above the horizontal. The sled had mass M and does not move due to the frictional force. In this case the coefficient of friction is ug. In terms of the variables given and g, what is the magnitude of the frictional force in this case? Select one: O a. Tcose O b. H, Mgsin0 Ос. Tsin® O d. H, Mgcose
A supermarket pushcart is being pushed at 45 degrees with respect to the horizontal from the starting point to the cashier, which is 25 feet away. The cart is 5kg, it contains 2 boxes of 10-1b flour and seven packs of half-kilogram sugar. The coefficient of friction between the wheels and the floor is 0.03. a. What force is required? b. How much force is required?
While loading furniture into a truck, you push a 1.56 kg chair up a 14.7 degree ramp, with a horizontal force of 12.1 N. How long does it take to reach a speed of 4 m/s, starting from rest? The coefficient of kinetic friction chair - ramp is 0.345.
Problem 3: A 38.8-kg crate is being pushed at a constant speed by a force of 311 N at an angle of 29 degrees below the horizontal, as shown. Part (a) What is the coefficient of kinetic friction between the crate and the floor? Numeric : A numeric value is expected and not an expression. Uk = Part (b) If the force is pulling at 29 degrees above the horizontal instead of below, as shown, what is the acceleration of the crate in m/s2, assuming the coefficient of friction is the same as in the previous part? Numeric : A numeric value is expected and not an expression. a =
Antman must supply a force of 8.25x10-3N to a small computer chip to lower it at a constant velocity over a distance of 11.5cm down a slope into a waiting circuit board. If the computer chip has a mass of 5.50g and the slope makes an angle of 23.0° with respect to the horizontal. What is the coefficient of kinetic friction between the computer chip and the slope?
An object with a mass of 4kg lies on a rough plane inclined at 20 degrees to horizontal. A force of 35N is applied parallel and up the plane. The object accelerates at 2.5m/s^2. What is the Uk between the object and plane

SEE MORE QUESTIONS