What is the change in enthalpy (in Joule) ofthis process? Nitrogen gas has a heat capacity of 20.8 and29.1 J/mol-C at constant volume andconstant pressure respectively. How muchheat (in J) is required to raise the temperaturefrom 50 K to 100 K at constant pressure?

Given: Cp = 20.8 J/mol-C Cv = 29.1 J/mol-C T1 = 50K T2 = 100K

Answered: Nitrogen gas has a heat capacity of…

Introduction to Chemical Engineering Thermodynamics

8th Edition

ISBN:9781259696527

Author:J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Publisher:J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Chapter1: Introduction

Section: Chapter Questions

Problem 1.1P

See similar textbooks

Similar questions

To a sample of water at 22.6 °C in a constant- pressure calorimeter of negligible heat capacity is added a 10.4 g piece of aluminum whose temperature is 68.7 °C. If the final temperature of water is 24.9 °C, calculate the mass of the water in the calorimeter. (sAl= 0.900 J/g.°C; s water= 4.184 J/g.°C ) [, 42.6 g 33.6 g 21.3 g 55.4 g 46.4 g
2. Saturated steam at 100°C is heated to 350°C. Use the steam tables to determine (a) the required heat input (J/s) if a continuous stream flowing at 100 kg/s undergoes the process at constant pressure and (b) the required heat input (J) if 100 kg undergoes the process in a constant-volume container. What is the physical significance of the difference between the numerical values of these two quantities?
When air is in a sealed container that is unchangeable and was heated from 20°C to 95°C, a) will the heat(q) and work(w) of the system be greater than zero, lesser than zero, or equal to zero? b) how about the change in internal energy(deltaU) and the change in enthalpy(deltaH), will it be >0,
Please Answer in 2 decimal places
The specific volume of superheated Refrigerant 134-a at 1.4 MPa and 110°C is 0.019597 m³/kg in the steam tables, determine the specific volume also using : (a) The ideal-gas equation. (b) The generalized compressibility chart. (c) Can we consider the superheated vapor to behave as an ideal gas under the given temperature and pressure? Why?
What is the change of energy (L. atm) of a system that absorbed 16.5 L.atm of heat and had its volume changed from 5.2 L to 10.9 L against a pressure of 1.5 atm? O AE = 16.5 + [1.5(10.9 + 5.2)] O AE = -16.5 + [1.5(10.9 - 5.2)] AE = -16.5 + [-1.5(10.9 - 5.2)] AE = 16.5 +[- 1.5(10.9 - 5.2)]
The molar heat capacity at constant pressure for CO2 is 36.61 J mol-1 K-1. How much heat in J is to be released in order to lower the temperature of a 35.99 g sample by 20.71 K. Atomic Mass of CO2: 44.01 g/mol. A) 620.03 J B) 27,287 J c) -27,287 J D) -620.03 J
Q 2. Air at 400°C and 1.7 bar flows through a horizontal 8.2-cm ID pipe at a velocity of 50.0 m/s. I. Calculate Ėk (W)? Assuming ideal gas behavior and Mol.Wt (Air)=29 g/mol. II. If the air is cooled to 250°C at constant pressure, what is AÉ? III. Why would it be incorrect to say that the rate of transfer of heat to the gas must equal the rate of change of kinetic energy?
A food product containing 75% moisture content is being frozen. Estimate the specific heat of the product at -4 ° C when 82% of the water is frozen. The specific heat of the dry product is 2.5 kJ / (kg ° C). It is assumed that the specific heat of water at -10 ° C is the same as the specific heat of water at 0 ° C, and that the specific heat of ice follows the function Cp es = 0.0062 Tbeku + 2.0649. Cp frozen products = kJ / kg ° C.
Saturated Steam ait an abseluben of 5 bar is Used 0 heat a Stream of Nitroyen- Nibroyen enters a heas exchanger 9t 0°c° und an absolute pressure of l01 bar at q rabe of loom/min: 18'is then heated 45 Constant Pressure to loa°ć- The steam Conden ses and leaves the exchanger 54°c.The specif.c enthalpy of nibrogen at the given pressure is -0:73h/mut at°ouc and e as q Saturate liquid 9o 2.19K/ol 9b lo0°C.
A problem indicates that the enthalpy of a compound can be predicted by an empirical equation Ĥ(J/g) = -30.2 + 4.25T + 0.001 T2 where T is in kelvin. What is a relation for the heat capacity at constant pressure for the compound?
The heat capacity equation for CO2 gas in the temperature range 0 to 1500 K is cp = 8.41+2.43 x10^-5 T with Cp expressed in J/(g mol)(K) and T in kelvin. Convert this equation into a form so that the heat capacity will be expressed over the entire temperature range in Btu/(lb mol)(R°)

SEE MORE QUESTIONS

Recommended textbooks for you

Introduction to Chemical Engineering Thermodynami…

Chemical Engineering

ISBN:

9781259696527

Author:

J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Publisher:

McGraw-Hill Education

Elementary Principles of Chemical Processes, Bind…

Chemical Engineering

ISBN:

9781118431221

Author:

Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard

Publisher:

WILEY

Elements of Chemical Reaction Engineering (5th Ed…

Chemical Engineering

ISBN:

9780133887518

Author:

H. Scott Fogler

Publisher:

Prentice Hall

Introduction to Chemical Engineering Thermodynami…

Chemical Engineering

ISBN:

9781259696527

Author:

J.M. Smith Termodinamica en ingenieria quimica, Hendrick C Van Ness, Michael Abbott, Mark Swihart

Publisher:

McGraw-Hill Education

Elementary Principles of Chemical Processes, Bind…

Chemical Engineering

ISBN:

9781118431221

Author:

Richard M. Felder, Ronald W. Rousseau, Lisa G. Bullard

Publisher:

WILEY

Elements of Chemical Reaction Engineering (5th Ed…

Chemical Engineering

ISBN:

9780133887518

Author:

H. Scott Fogler

Publisher:

Prentice Hall

Process Dynamics and Control, 4e

Chemical Engineering

ISBN:

9781119285915

Author:

Seborg

Publisher:

WILEY

Industrial Plastics: Theory and Applications

Chemical Engineering

ISBN:

9781285061238

Author:

Lokensgard, Erik

Publisher:

Delmar Cengage Learning

Unit Operations of Chemical Engineering

Chemical Engineering

ISBN:

9780072848236

Author:

Warren McCabe, Julian C. Smith, Peter Harriott

Publisher:

McGraw-Hill Companies, The

SEE MORE TEXTBOOKS

Nitrogen gas has a heat capacity of 20.8 and 29.1 J/mol-C at constant volume and constant pressure respectively. How much heat (in J) is required to raise the temperature from 50 K to 100 K at constant pressure?