n open channel is V-shaped, each side being inclined at 45 degrees to the vertical. If the flow rate is 3 m3 /s when the depth of water at the centre is 0.52 m, calculate the slope of the bed of the channel. Use Manning’s coefficient n = 0.013.

n open channel is V-shaped, each side being inclined at 45 degrees to the vertical. If the flow rate is 3 m3 /s when the depth of water at the centre is 0.52 m, calculate the slope of the bed of the channel. Use Manning’s coefficient n = 0.013.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: You must determine the depth of the water over the obstacle presented in figure 4 considering that…

A: ###Depth of water over the obstacle placed in channel flow####

Q: The discharge Q of an open channel can be measured using a V-notch weir which is a vertical plate…

Q: Consider a wide rectangular water channel with a per-unit-width ﬂow rate of 5m3/s⋅m and a Manning…

Q: A triangular open channel carries 4 m3/s of water. If the both sides are sloping at 60o from the…

Q: A uniform flow occurs at a depth of 3.15m in a rectangular channel 6.75m wide with n=0.015 laid on a…

A: Given data Uniform flow depth y1 = 3.15 m Width of channel b = 6.75 m manning's coefficient n =…

Q: The discharge Q of an open channel can be measured using a V-notch weir which is a vertical plate…

Q: Example. The discharge in a channel with bottom width 3 m is 12 m s. If Manning's n is 0.013 and the…

A: Given that: Bottom width, B=3m Discharge in the channel, Q=12 m3/s…

Q: ater flows through an open channel that has a cross-sec own in the figure. Flow is uniform and the…

Q: Water is flowing uniformly in an open channel (triangular shap has a 1:2 (v:h) side slope and a…

Q: Water flows in a 1.5-m wide rectangular channel with a constant bed slope So = 0.144 (see figure…

Q: Consider a concrete (n = 0.014) wide rectangular channel that discharges 2.7 m^3/s per unit width of…

A: Data given n = 0.014 Q = 2.7 m3/s / unit width S = 0.0002 Step rise, △z = 0.15 m Find: Flow depth…

Q: A drainage canal in the shape of trapezoid with a bottom width of 2,3m and a side slope of 1…

A: B=2.3m y=2.8m n=0.012 S=0.0004

Q: Q. No 1). Determine the discharge through a trapezoidal channel having Xm base width, Side slope is…

A: Given data Depth of flow Manings roughness coefficient Bes slope Side slope Find? Discharge

Q: find the depth

A: In this type of flow ,the hydraulic gradient line coincides with the free surface.Flow in…

Q: A rectangular channel is 6.3 m wide and has depth of flow of 1.7m. The slope of the channel bed is…

A: Given- Width of rectangular channel (b) =6.3 m depth of flow (d) = 1.7m. The slope of the channel…

Q: A rectangular channel 1.25m wide and 30m long with a flat bottom carries a flow of 0.5m3/s. The…

A: [1] Solution Q= 0.5 m3/sB=1.25 mL=30 mDischarge per unit width (q)=QB…

Q: trapezoidal concrete canal with slope 3H to 4V and bottom width 2m, the depth of flow is 2m and the…

A: Given Data:Slope = 3H to 4VBottom width = 2mdepth of flow = 2mslope = 3m/2kmn= 0.013

Q: The flow rate through the rectangular canal of 1.5 m depth is 0.9 m/s as shown in the Figure. If…

Q: Water is flowing at a rate of 4.5 m³/s in a trapezoidal channel whose bottom width is 2.4 m and side…

A: given-discharge Q=4.5 m3sbotom width b=2.4 mside slope n=2 H:1 V=2channel slope S=0.0001

Q: A rectangular channel 4.0 m wide is laid a bed slope of 0.0008. A discharge of 15.0 m₽/ flows in the…

Q: A steep wide rectangular channel takes off from a reservoir having an elevation of 101.2 m. At the…

Q: a) Determine the water heights at a distance of Ax=10000m upstream of the dam using Bakhmeteff…

A: Width of channel(b)=8.2 m Manning's coefficient(n)=0.014 Bottom slope(So)=0.0001 Discharge(Q)=73…

Q: Determine the bed slope of a rectangular channel 5 m wide and 2 m deep. The discharge is recorded as…

A: Given: Width of channel, b = 5 m Depth of channel, d = 2 m Discharge, Q = 20 m3/s Chezy's constant,…

Q: For a 2-D flow field, the stream function y is 3 given as y==(y² - x²). 2 The magnitude of discharge…

A: Given- 2-D flow field stream function- ψ=32y2-x2points (0,3) & (3,4).

Q: The water velocity in the channel shown in the figure has a velocity distribution across the…

Q: Determine the slope of the bed of a rectangular channel of width 6 m and depth of flow 3 m. Assume…

A: The hydraulic radius is given by,

Q: An open channel has a rectangular section 3 m wide. The flow rate is 1.4 m/s and the depth is 0.8 m.…

A: Discharge through a Open Channel is Given as:Q=1nAR23S12.A=Area of Flow (m2)P=Wetted…

Q: Question 4: Water flows at a rate of (20+b) m³/s with 2 m depth and (5+a) m wide rectangular…

Q: Find the discharge through a trapezoidal channel of 8 m wide and side slopes of 1 horizontal to 3…

Q: An open channel has a vee shaped cross section with sides inclined at an angle of 60° to the…

A: Given :

Q: The base of the artificial channel has a bottom width of 3m and sides with a slope of 1 vertical to…

Q: A right angled V notch is used to measure the flow rate in an open channel which carries water at…

Q: Consider a rectangular channel of width b=7.5 m, in which the hydraulic jump occurs and one of its…

Question

An open channel is V-shaped, each side being inclined at 45 degrees to the
vertical. If the flow rate is 3 m3
/s when the depth of water at the centre is 0.52
m, calculate the slope of the bed of the channel. Use Manning’s coefficient n =
0.013.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Given data

VIEW

Step 2 Concept to be used

VIEW

Step 3 putting various values

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

PLEASE ANSWER QUESTION #3
C1
Sol 4.
Water is flowing in a rectangular channel that has a width b-3 m. If the depth of flow y = 2 m and Froud Number NF33, then the flow rate (Q) in the channel is
Water flows in a 8-m-wide rectangular channel that has a longitudinal slope of 0.01%. The channel has an equivalent sand roughness of 2 mm. Calculate the uniform-flow depth in m when the flow rate is 12 m3/s. Use the Darcy–Weisbach equation.
Problem 3 Determine the slope of the bed of a rectangular channel of width 6 m and depth of flow 3 m. Assume the rate of flow as (20+X) m³/s and Chezy's constant 'C' as (50+X).
The cross-section of a navigation channel is shown in figure. A I J B/ 4m D E F 30 m 30m'6m 6m 8'm *20m 150 m 20m Channel section Determine the discharge through the channel if the depth of flow is 12 m. The channel has a slope of 1 in 2000 and the Chezy's constant C is 45.
The ratio between maximum discharge and top width of a rectangular channel is 1.82. Calculate the water depth if the bed slope is 1 in 3000. Use Chezy equation and C = 50 a. y=1.24m O b. y=2m Ос. у-2.9m O C. O d. y=0.73m
Q2/Béd width of an open channel is B = 40 (m), depth of water in the channel is y = 2 (m), longitudinal bed level slope is So = 0.001 and Manning's coefficient is n= 0.025 { m(l)/s}. Calculate the value of water flow rate in the channel. Find the Type of flow in the channel.
Q: Water is flowing through an inclined aquifer (a=15°) as shown in the following figure. The depth of aquifer is H₁-3m. Two observation wells are constructed at 55m apart (S-55m) to reach the top of the aquifer. It is found that the head difference between the points, observation wells were constructed, is h=3m. (i) Find the flow rate in m³/s/m length (at right angles to the cross section shown) if k-0.05 cm/s. (ii) Find the percentage rate of change in flow rate if the head difference is increased to 4m (h-5m). H Impervious layerPermeable layer Direction of flow
e10
Discharge in a concrete channel with bottom width of 3m is 10 cumecs. Bed slope of a given channel is equal to 1 in 664 . Find the normal, critical and hydraulic depths of flow if: 1. the channel has vertical sides 2. the channel is trapezoidal with 3H:2V 3. the channel is triangular with apex angle equal to 1000