Consider a concrete (n = 0.014) wide rectangular channel that discharges 2.7 m^3/s per unit width of flow. The channel bottom slope is 0.0002. There is a step rise of 0.15 m. Determine the flow depth downstream of the step assuming no transition losses. Does the water rise or fall at the step?

Q: Water is flowing in trapezoidal channel with 2V:3H at a discharge of Q=3.5m^3/s. If the channel top…

A: Solution:

Q: You must determine the depth of the water over the obstacle presented in figure 4 considering that…

A: ###Depth of water over the obstacle placed in channel flow####

Q: In a rectangular canal with energy height E= 3,5 m, the floor width is given as B= 5,6 m. Neglecting…

A: As per guidelines we need to answer only first 3 subparts

Q: At the foot of a spillyway, water flows at a depth of 23 cm with a velocity of 8.1 m/s, as shown in…

A:

Q: 2.3 Considering the flow upstream of a sluice gate, the gate closes suddenly. The initial flow…

A: 2.3 Considering the flow upstream of a sluice gate, the gate closes suddenly. The initial flow…

Q: Q1- Water flows in a rectangular channel of 5 m width and flow rate of 15 m³/s with F= 2.75 and…

A:

Q: depth of water = 10 cm velocity of water = 6 meters/sec *The water flows in a rectangular-shaped…

A: Given rectangular channel Depth of water y1 = 0.1 m Velocity of water V1 = 6 m/sec Whether it is…

Q: The channel is made of wood and has a downward slope of 0.0020. Determine the depth of flow y that…

A: Given:- The downward slope of the channel = 0.0020  The value of n = 0.012 To determine:- The depth…

Q: A trapezoidal canal has one side vertical and the other sloping 1:1. The discharge is known to be 20…

A:

Q: Variation of water depth (y) in a gradually varied open channel flow is given by the first order…

A:

Q: A 8-meter-wide concrete rectangular channel with bed slope of 0.0008 mm/mm has a steady discharge of…

A:

Q: Water flows at a depth of y1=0.4ft in a concrete channel which is 10ft wide. The discharge per unit…

A: Let y1 be the height of the pre-jump. Let y2 be the height of the post hump.  y1 = 0.4 ft q = 10…

Q: 2.1. A trapezoidal channel conveys 15 m³/s of water on a bed slope of 1 in 300. The base width of…

A:

Q: For the irregular channel shown, determine: (a) the area of flow, A [m], (b) the wetted perimeter, P…

A:

Q: the incoming flow rate is 100m3/s on a rectangular channel with: depth = 3m width = 4 meters Then, a…

A: Using conjugate alternate depth formula

Q: find the depth

A: In this type of flow ,the hydraulic gradient line coincides with the free surface.Flow in…

Q: A rectangular open channel, with a constant discharge of 32m3/s32, has a smooth expansion from (1)…

A: We have to explain what engineering techniques you could use in order for the flow to change regime…

Q: trapezoidal concrete canal with slope 3H to 4V and bottom width 2m, the depth of flow is 2m and the…

A: Given Data:Slope = 3H to 4VBottom width = 2mdepth of flow = 2mslope = 3m/2kmn= 0.013

Q: Problem 1 Consider the one-dimensional flow on a sloped impermeable bed. By reference to the sketch…

A:

Q: B. Water flows at 15 ft/s through a 6 ft wide rectangular channel as shown in the figure. The pth of…

A: Given: B=6ft,Q=15ft3/s

Q: 3.1. A trapezoidal channel convey 15 m³/s of water on a bed slope of 1 in 200. The base width of the…

A: As per our guidelines we are supposed to answer only one question. Kindly repost the other questions…

Q: nel the following information is given: Discharge, m, b = 10 m, Manning roughness coefficient n =…

A:

Q: 35p-Q.2) Water flows in a rectangular channel shown below. The bump has a maximum value, AZmax,…

A:

Q: 1. A channel of width 5m has a sluice gate as shown below, which forces the upstream flow to a deep…

A: step 1-

Q: A trapezoidal channel has a bottom width of B=5 m, sidewall slope of 1V:1H, and bed slope of…

A: Botom width of channel, Bed slope, Side slope, Mean diameter, Manning coefficient for side walls,…

Q: mber In a lined rectangular canal, the Froude hl of incoming flow is 3.0. A hydraulic jump forms…

A:

Q: The base of the artificial channel has a bottom width of 3m and sides with a slope of 1 vertical to…

A:

Q: A pipe of length L = 500 m, diameter D = 300 mm and absolute roughness k = 0.02 mm transports a flow…

A: Given: The length of the pipe is 500 m. The diameter of the pipe is 300 mm. The absolute roughness…

Q: In a lined rectangular canal, the Froude number of incoming flow is 3.0. A hydraulic jump forms when…

A:

Q: The figure shows the cross section of a channel carrying water. Determine h, b and that minimize the…

A:

Q: The following figure shows and inclined aquifer at 100 to the horizontal. The difference in water…

A: The discharge is the amount of water in the aquifer can transmit the water with particular amount of…

Q: The incoming flow rate is 200 m3/s on a rectangular channel with: depth = 3 meters width = 4…

A:

Q: Water discharges in too wide rectangular channel slope =0.01 Just apstream the weir where the water…

A: channel slope =0.01 water depth is 2.5mflow rate is 5m ^ 3/s  n = 0.015Find1. Find the normal depth,…

Q: A triangular channel has a vertex angle equal to 90°. If the discharge uniformly flowing in the…

A:

Q: SITUATION: A rectangular channel conveying water enters a transition region. The depth of flow in…

A: Given data in question  Rectangular channel  Depth before and after jump To find out  Head loss

Open Channel Flow

Open channel flow is a branch of fluid mechanics. It deals with the flow of fluid in an open conduit or free surface. In an open channel flow, gravity induces the flow of water whose surface is open to the air. This flow is free-falling rather than confined in rigid body conduits. The open channel flow depends upon two parameters that are the cross-section of the conduit and the velocity profile. Practical examples of open channel flow are streams, rivers, canals, and other drainage systems.In open channel flow, the cross-sectional area of at least one of the sides is exposed to air, and the surface of water faces atmospheric pressure. This flow is also known as free gravity flow. The cross-sectional area of the conduit can be either man-made or a natural channel. For instance, the flow in rivers and streams are natural conduits, and the flow in a canal and sanitary systems are man-made or engineered channels.