MULTIPLE ACCESS PROTOCOLS: COLLISIONS Consider the figure below, which shows the arrival of 12 messages for transmission at different multiple access wireless nodes at times t = <0.1, 0.2, 1.6, 1.8, 1.9, 2.1, 2.5, 2.8, 3.2, 3.7, 3.9, 4.8> and each transmission requires exactly one time unit. t=0.0 Answer t=1.0 3 6 t=2.0 1 8 t=3.0 2 10 11 t=4.0 QUESTION 1 OF 2 Suppose all nodes are implementing the Slotted Aloha protocol. For each message, indicate the time at which each transmission begins. Separate each value with a comma and no spaces. t=5.0

MULTIPLE ACCESS PROTOCOLS: COLLISIONS Consider the figure below, which shows the arrival of 12 messages for transmission at different multiple access wireless nodes at times t = <0.1, 0.2, 1.6, 1.8, 1.9, 2.1, 2.5, 2.8, 3.2, 3.7, 3.9, 4.8> and each transmission requires exactly one time unit. t=0.0 Answer t=1.0 3 6 t=2.0 1 8 t=3.0 2 10 11 t=4.0 QUESTION 1 OF 2 Suppose all nodes are implementing the Slotted Aloha protocol. For each message, indicate the time at which each transmission begins. Separate each value with a comma and no spaces. t=5.0

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Total latency is equal to a summation of network delay contributors such as frame transmission time, queuing time, and propagation time. Use the assumptions listed below to answer the questions below. Assumptions: • Host A and Host B are connected to a network. Packets sent from Host A to Host B transit through two Routers, R1 and R2 (Host A ? Router 1? Router 2 -? Host B) • The links that connect the hosts and routers are Ethernet 1000B and are short distance and can be ignored in any further delay calculations • The link between the two routers is 8km long and are connected by a T-1 WAN link (line rate = 1.544Mbps) • a single packet (size = 1500bytes) is routed from Host A to Host B through the network. The two routers, R1 and R2, introduce queuing delay of 3 msec and 5 msec, respectively. • Assume the signal propagation velocity in the T-1 channel = Vp = 2 x 108 m/sec a. Calculate the latency (in msec) required to send the 1500byte packet from Host A to Host B
Suppose a single 802.11n client is connected to an 802.11n access point and there is no other client or access point in the neighborhood. The client senses the medium, then sends an 1,147-Byte frame, and waits for an 169-byte acknowledgement from the AP, and then repeats the process. The data rate on the wireless link is 400 Mbps. Assume DIFS=44 μs and SIFS =15 μs, no propagation delay and no error. Calculate the throughput for this client in Mbps. Calculate up to 1 decimal point.
Given what we know about transmission delay and the following: A web client and a web server separated by one intermediary router. • Each link carries data at 1Mbps with an MTU of 8192 bytes • Each link is 1000 km long with a propagation speed of 250000 km/s • Zero processing and queueing delays • Connection management packets (packets used for opening a connection, confirming a connection and acknowledging receipt of information) contain no data and all packets have 125 bytes of overhead on top of any data they may contain. • The web client makes an HTTP request to the server that is 250 bytes long. • The requested data is 4 kilobytes in size with 500 bytes of overhead for the HTTP status and headers What is the RTT to open the connection? а. b. How long would it take for a web client to complete the request? You can ignore any time needed to close the connection.
In this problem you will be doing some elementary calculations of transmission and propagation delays. Consider two hosts, A and B that are connected by a transmissions link of2.1 Mbps. Assume that packets are of length 2.0 Kb (Kilobits) and the length of the link is 100Km. Suppose now that that length of the link is doubled. What is the propagation delay from A to B now and what is the transmission time?
A router output port is being dimensioned to support a mean packet arrival load of 100 packets per second where the mean packet length is 500 bytes. Determine the minimum output link capacity such only 10% of packets experience a delay greater than 15 ms. Select one: O a. 1.2 Mb/s O b. 4 Mb/s Oc. 1 Mb/s O d. 0.5 Mb/s O e. 0.8 Mb/s
An Internet user would like to transfer a message from his computer (host A) to another computer (host B). The size of the message passed to the IP layer is 3800 bytes. The datagram(s) carrying the message will have to cross two routers (R1 and R2) and 3 networks (NET1, NET2, and NET3) as described in the above figure. Each of these networks has a specific MTU (for example the MTU of network 1 is 1500 bytes. MTU here stands for Maximum Transmission Unit, the largest data that a frame can carry). Fill the table with the IP datagram(s) needed right after passing through NET3 (no need to show your fragmentation for N1 or N2). Assume a 2-byte options in the header. Show all your details (for partial points in case your numbers are incorrect). NET1 MTU=1500 R1 NET2 MTU=640 R2 NET3 MTU 1500 V BIU Fragment # Format Offset Flag (3 bits) Data Length Total Length ...
Using packet tracer, implement a network that has the following components: 1- At least five routers 2- At least 7 subnets 3- At least 12 PCs 4- At least 4 switches 5- Use RIP routing protocol To assign IP addresses of the routers and PCs, use the IP address from your ID as follows Assume your id is 118zyxw, Consider the numbers z, y, x and w as deciemal You have the subnet 118.0.0.0/24 If your ID is 1181234 then the IP is 118.0.0.0/24 Use this subnet to get at least 7 subnets.
not handwritten A server sends packets to a client via satellite. The packets must traverse one or multiple satellites before they reach their destination. The satellites use store-and-forward packet switching, with a switching time of 100 μsec. If the packets travel a total distance of 29,700 km, how many satellites do the packets have to pass if 1% of the delay is caused by packet switching?