Moving to another question will save this response. Quèstion 30 Determine the total current on a circular wire of radius 2mm and J =500a, A/m2 1.57 mA 5.137 mA 6.28 mA 25.132 mA P Type here to search

Q: Va O 13V i3 20 2A (4

A:

Q: Question: In commutation method the charged capacitor momentarily reverse biases the conducting SCR…

A: In this question we will write about voltage commutation....

Q: Electric field ends at None of these Negative charge Positive charge Both Positive and Negative…

A: Electric field always making a closed loop.

Q: Dielectric resistance between two surfaces depends on Dielectric permittivity Dielectric…

A: Right Answer option Dielectric Conductivity

Q: > Apiece of silver wire has aresistanceof 4.2,0h Lili be the resistanc third the Length and one…

A: We have given the following problem A piece of silver wire has resistance  of 1 ohm what will be the…

Q: A right triangle has an angle of 32 degrees and the side opposite measures 12, what is the length of…

A:

Q: Refer to Figure 5 (image attached) : Why does LED turned on quickly and turned off gradually, when…

A:

Q: There is an electron moving to the right undeflected by both the electric field in between the…

A: The given figure is: Here, E=8 N/CB=4 T It is given that the electron is moving un-deflected by…

Q: 2A R1 R2 100 R3 R4 12V Figure 7

A:

Q: Questions: 1. How does the area of the alumirum foil affect the capact ance if the paper capacit or?…

A: C=ξAdThus C∝A So, if area of aluminum is increased then capacitance will also increase.

Q: * For the Photoflash unit, R1=5KQ, C=1500 uf R2= 120. The time required for the capacitor to fully…

A:

Q: I need to convert the drawing of drawing by hand to print a line on your computer please 4

A: I need to draw the circuit in the computer.

Q: RB=2k0?

A: We need to tell about the meaning of given resistance

Q: (c) Measure the voltages of the resistor and capacitor and calculate the current using Ohm's Law…

A: Given:A circuit, we need to find:(c) Measure the voltages of the resistor and capacitor and…

Q: When an electric field is applied across a semiconductor

A: (1) when light ray incident on metal surface, then emission of free electron from the metal surface…

Q: need part a, b and c asap i willl give you upvote

A: a) The switch has just been closed. The given circuit can be redrawn as shown below, The capacitor…

Q: 10 nC -5 nC How much work must you do to move an electron from A to B? The rectangle is 16.6 cm high…

A: Work done to move a electron from A point to B point.  Work done W= q∆V ∆V= VA - VB

Q: Question 18 The charge on Capacitor C3 is 41 HC. Determine the value of Vs. 10 uF C2 = 20 uF C3= 10…

A: Redrawing the circuit with the given points:

Q: How many 40 W cool white fluorescent lamps would be required to have an initial lamp output of 9,600…

A: Given:Power. P=40WOutput=9600 lumens

Q: SPheres hauesta conducting charges .147 pC an T.851 pC sthy are two Hentiaal Conduc tiy Brought Ynto…

A: In this question we are given two charges . And when they came in contact , the charge is…

Q: Le the total current on

A:

Q: * The resonance frequency of cavity resonator depends on mode O dielectric O Dimensions of cavity,…

A: Only one individual question is to be answered. 1. The cavity resonator is a device or a system…

Q: For a clamper circuit, if the input is the blue waveform and the output is the red one. Scale…

A: Given that: A clamper circuit waveform is shown below. Scale is 5 V/Div means that one block refers…

Q: 3.) Find the percent overshoot, settling time and peak time for T(s) == 0.04 $240.002s +0.04

A: We need to find out  peak time and peak overshoot and settling time .

Q: Calculate no for germanium at T = 300K when the Fermi energy is 0.55 eV below the conduction energy…

A:

Q: Item 8 of 10 Most ac-supplies are in the form of Select the correct response: sine-wave…

A: This is a basic problem of sinusoidal and phasor. The solution is given in the next step

Q: According to the right hand rule, if electrons are flowing into this page, the magnetic field...…

A: according to the right hand rule if electrons are flowing into this page, the magnetic field is: a)…

Q: Question 1 What would be the maximum current through the resistor? Express your answer in amperes…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: 252 2요 + Is 141 22 +.

A: Applying KCL at nodes, Node 1 V1-1412+V12+V1-V22=032V1-12V2=14121.5V1-0.5V2=70.5V1=70.5+0.5V21.5

Q: QUESTION 5 The smaller water droplets in thunderclouds store O negative charge positive charge o no…

A: Note: Since you have not specified any question to be answered, as per our honor code, we are…

Q: On the second part, you did 60-60 because the charge didn't change. Is that correct?

A: Yes you are correct. The current through capacitor is the ratio of  as change in charge to the…

Q: Set up explains brief each bullet points phygics angument that. • Any wive has a non Zero res…

A: NO every wire have some resistance since wire have length and cross section area therefore wire must…

Q: A PT-100 RTD is used for crude oil temperature measurement and it indicates 132Ω. Find the oil…

A:

Q: Question 3 Answer the safety questions accurately below. You should never [Select] [Select] You…

A: The question is about properties of inductor and capacitor.

Q: You will calculate the time constant for the circuit shown in the illustration below using Equation…

A: The circuit diagram,

Q: What is current in a 50 µF capacitor if the source voltage is 100sin(100t) V? -500sin(100t+90°) mA…

A: To find the current through capacitor

Q: 0610908-Introduction to Electrical Phase 1 6 of 20 Which DMM measurement would you expect based upon…

A: In this question,  We need to choose the correct options What is reading of the DMM?  We know…

Q: They are completely diamagnetic. Type I Superconductors O Type II Superconductors Type III…

A: It is known that superconductors are classified into 2 broad categories based on their behavior and…

Q: QUESTION 3 A 0.06 nF parallel-plate capacitor with air between them has a separation between plates…

A: Given Data: Capacitance of Parallel Plate Capacitor is C= 0.06nF C= 0.06×10-9F Separation between…

Q: In DC resistivity Current lines and equipotential lines intersect each other at a) 100 degrees b) 30…

A: Equipotential lines are those lines which connect all the point of equal potentials at a surface of…

Q: An ideal rectifying contact is formed by depositing tungsten on n-type silicon doped at 1017 cm-³.…

A: Given :ni=1017cm-3" data-mce-tabindex="0">The width of the depletion region determines the…

Q: Ability Of Source To Produce Light In Each Direction is measured in terms of- a. CANDELA b. FOOT…

A: The ability of souce to produce the light in given direction is called as luminious intensity.

Q: Question 5 Consider the crcuit shown in the figure The crcut is kept nunning for a very long time…

A: Given

Q: What is the current in the inductor ILO in continuity mode before opening the switch. R₁ Select one:…

A: In the given R-L circuit, we need to determine the current through the inductor when the switch is…

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.