MIMI. Consider a solenoidal coil initially carrying a time-varying current i(t) wrapped around a second coil. If the current in the first solenoid is set to 2i(t), which of the following quantities would double in magnitude for the second solenoid (assuming these quantities are measured at the same instant in time)? 1. Mutual inductance II. Magnetic flux III. Induced EMF 20 OA. I only OB. II only O C. I and III OD. II and III

MIMI. Consider a solenoidal coil initially carrying a time-varying current i(t) wrapped around a second coil. If the current in the first solenoid is set to 2i(t), which of the following quantities would double in magnitude for the second solenoid (assuming these quantities are measured at the same instant in time)? 1. Mutual inductance II. Magnetic flux III. Induced EMF 20 OA. I only OB. II only O C. I and III OD. II and III

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 30P: A long solenoid with n= 10 turns per centimeter has a cross-sectional area of 5.0 cm2and carries a...

See similar textbooks

Similar questions

(a) A nonferrous screwdriver is being used in a 2.00 T magnetic field. What maximum emf can be induced along its 12.0 cm length when it moves at 6.00 m/s? (b) Is it likely that this emf will have any consequences or even be noticed?
(a) What is the speed of a supersonic aircraft with a 17.0-m wingspan, if it experiences a 1.60V Hall voltage between its wing lips when in level flight over the north magnetic pole, where the Earth's field strength is 8.00105T ? (b) Explain why very little current flows as a result of this Hall voltage.
The armature and field coils of a series-wound motor have a total resistance of 3.0 . When connected to a 120-V source and running at normal speed, the motor draws 4.0 A. (a) How large is tire back emf? (b) What current will the motor draw just after it is turned on? Can you suggest a way to avoid this large initial current?
(a) A car generator turns at 400 rpm when 1he engine is idling. Its 300-turn, 5.00 by 8.00 cm rectangular coil rotates in an adjustable magnetic field 50 that it can produce suf?cient voltage even at low rpms. What is the field strength needed to produce a 24.0 V peak emf? (b) Discuss how this required field strength compares to those available in permanent and electromagnets.
A long solenoid with 10 turns per centimeter is placed inside a copper ring such that both objects hove the same central axis. The radius of the ring is 10.0 cm. and the radius of the solenoid is 5.0 cm. (a) What is the emf induced in the ring when the current 2 through the solenoid is 5.0 A and changing at a rate of 100 A/s? (b) What is the emf induced in the ring when 1=2.0A and. dI/dt=100A/s ? (c) What is the electric field inside the ring for these two cases? id: Suppose the ring is moved so that its central axis and the central axis of the solenoid are still parallel but no longer coincide. (You should assume that the solenoid is still inside die ring.) New what is the emf induced in the ring? (el Can you calculate the electric field in die ring as you did in part (c)?
The square armature coil of an alternating current generator has 200 turns and is 20.0 cm on side. When it rotates at 3600 rpm, its peak output voltage is 120 V. (a) Wliat is the frequency' of the output voltage? (b) What is the strength of the magnetic field in which the coil is turning?
A 75-turn, 10.0 cm diameter coil rotates at an angular velocity of 8.00 radius in a 1.25 T field, starting with the plane of the coil parallel to the field. (a) What is the peak emf? (b) At what time is the peak emf first reached? (c) At what time is the emf first at its meet negative? (d) What is the period of the AC voltage output?
When the switch in Figure CQ31.8a is closed, a current is set up in the coil and the metal ring springs upward (Fig. CQ31.8b). Explain this behavior.
(a) By how many percent is the torque of a motor decreased if its permanent magnets lose 5.0% of their strength? (b) How many percent would the current need to be increased to return the torque to original values?
A 10-H inductor carries a current of 20 A. How much ice at 0ºC could be melted by the energy stored in the magnetic field of the inductor? (Hint: Use the value Lf= 334 J/g for ice.)
A flat coil of wire has an inductance of 40.0 mH and a resistance of 5.00 . It is connected to a 22.0-V battery at the instant t = 0. Consider the moment when the current is 3.00 A. (a) At what rate is energy bring delivered by the battery? (b) What is the power being delivered to the resistance of the coil? (c) At what rate is energy being stored in the magnetic field of the coil? (d) What is the relationship among these three power values? (e) Is the relationship described in part (d) true at other instants as well? (f) Explain the relationship at the moment immediately after t = 0 and at a moment several seconds later.
(a) By how many percent is the torque of a motor decreased if its permanent magnets lose 5.0% of their strength? (b) How many percent would the current need to be increased to return the torque to original values?