6. A rod slides along conducting rails which are connected to a resistor (R=2 N). The length of the bar is 0.5 m and a uniform magnetic field of 1.45 T is applied perpendicular, pointing outward. A force is pulling the bar at 6 m/s. F R a) What is the induced emf in the loop? b) What is the current induced in the bar? Give value and direction (counterclockwise/ clockwise) c) What force is required to move the bar?

6. A rod slides along conducting rails which are connected to a resistor (R=2 N). The length of the bar is 0.5 m and a uniform magnetic field of 1.45 T is applied perpendicular, pointing outward. A force is pulling the bar at 6 m/s. F R a) What is the induced emf in the loop? b) What is the current induced in the bar? Give value and direction (counterclockwise/ clockwise) c) What force is required to move the bar?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 26-turn circular coil of wire has diameter 1.05 m. It is placed with its axis along the direction of the Earth's magnetic field of 53.0 µT and then in 0.200 s is flipped 180°. An average emf of what magnitude is generated in the coil? mv Need Help? Read It Watch It
The figure below shows a flexible loop of metal wire with a radius of 15.0 cm. It lies in a magnetic field pointing into the page with a magnitude of 0.130 T. An engineer grabs the loop at points A and B and rapidly pulls in opposite directions until the loop folds up, such that its area becomes zero. The change in area occurs in a span of 0.220 s. A В What is the average induced emf (in mV) in the loop over this time span? mV
HW Q4
A conductive rod with a length of 50 cm has an intensity of 2T with a velocity v. A vertical magnetic field as shown in the figure. It acts in a manner. Electric motor acting on the rod force, since emf ε=3 V; a)What is the speed of the rod? b)If the total resistance of the rod is considered to be 1.5 Ω If so, what happens to the induction current on the rod? c)What is the force acting on the rod due to this current?
A circular loop with a radius of 2.5 m rests horizontally inside a uniform magnetic field of 0.9 T in a down direction. What is the induced emf when the magnetic field drops to zero in 0.75 s? O a. 9.40 V O b. 23.6 V O c. 34.2 V O d. 17.5 V
A 65 turn, 10.0 cm diameter coil rotates at an angular velocity of 8.00 rad/s in a 1.30 T field, starting with the normal of the plane of the coil perpendicular to the field. Assume that the positive max emf is reached first. a. What (in V) is the peak emf? b. At what time (in s) is the peak emf first reached? c. At what time (in s) is the emf first at its most negative? d. What is the period (in s) of the AC voltage output?
The flexible loop in Figure has a radius of 34.8 cm and is in a magnetic field of magnitude 0.150 T. The loop is grasped at points A and B and stretched until its area is nearly zero. If it takes 0.200 s to close the loop, what is the magnitude of the average induced emf ( in units of mV) in it during this time interval? A В
the loop is A ab The figure below shows a rectangular loop with a resistance of 6.7 2. The area of 0.0026 m². The magnetic field throughout the region is A = 48 T/s. How much current is induced in the loop, AB increasing at a rate of in units of milli-Amps (mA)? 24,96,91,88 X X Your Answer: Answer x X CO x X X * X X x X B
A rectangular coil 27 cm by 39 cm has 140 turns. This coil produces a maximum emf of 66 V, when it rotates with an angular speed of 200 rad/s in a magnetic field of strength B. Y Part A Find the value of B. Express your answer using two significant figures. B = 17 ΑΣΦ OWC ? mT
R OF е Fapp Figure P20.18 2003 Thomson Brooks Cole (c20p18) Consider the arrangement shown in Figure P20.18. Assume that R = 7.00 £2 and I = 1.00 m, and that a uniform 1.60-T magnetic field is directed into the page. At what speed should the bar be moved to produce a current of 0.400-A in the resistor?
In the figure, the red circle represents the loop of a wire. An external constant magnetic field is applied, with the direction shown-into the screen. What will be the direction of the induced current on the loop of wire? Figure for Problem 3 X X X X X xBx X X X X X X X a. Clockwise O b. Counterclockwise O C. Information is insufficient. d. No current will be induced in the loop of wire.
plane of the coil is and (b) horizontal? A coil consisting of 10 turns of wire each in an area of 0.025 m² is rotating in a magnetic. 7. field that is decreasing at the rate of 0.32 T/s. What is the emf induced in the coil? The armature of a generator consists of 5 circular coils with radius 1.5 cm. The coils rotate in a constant magnetic field of 1.25 T. What must be the angular speed and frequency of rotation to produce a maximum voltage of 2.5 V? 8.