Mg + 2HCl → MgCl2 + H2 This experiment was performed two times. All values are valid to one decimal place. If the decimal place is not shown, add a ".0" Experiment Mass of Mg (mg) Starting Temperature (°C) Final Temperature (°C) 1 2 19.6 20.7 19.5 20.7 33 33.5 The previous page contained data from two experimental runs for the reaction between magnesium and hydrochloric acid. Mg+ 2HC! MgCl2 + H2 First, how many moles (n) of Mg reacted with the HCI? Use the average value of the two masses from your provided data set. Answer: 0.001658 I -> Mg+ 2HCI MgCl2 + H2 Next, what is the amount of heat absorbed by the water (qsurr) in the experiment? Use the average AT from your data to calculate a single value for q. Report your answer in J. Remember to consult the lab manual and/or the video for any values you might need. Answer: Mg+ 2HC! MgCl2 + H2 Finally, calculate A,H for this reaction and report your answer in kJ/mol. Answer:

Mg + 2HCl → MgCl2 + H2 This experiment was performed two times. All values are valid to one decimal place. If the decimal place is not shown, add a ".0" Experiment Mass of Mg (mg) Starting Temperature (°C) Final Temperature (°C) 1 2 19.6 20.7 19.5 20.7 33 33.5 The previous page contained data from two experimental runs for the reaction between magnesium and hydrochloric acid. Mg+ 2HC! MgCl2 + H2 First, how many moles (n) of Mg reacted with the HCI? Use the average value of the two masses from your provided data set. Answer: 0.001658 I -> Mg+ 2HCI MgCl2 + H2 Next, what is the amount of heat absorbed by the water (qsurr) in the experiment? Use the average AT from your data to calculate a single value for q. Report your answer in J. Remember to consult the lab manual and/or the video for any values you might need. Answer: Mg+ 2HC! MgCl2 + H2 Finally, calculate A,H for this reaction and report your answer in kJ/mol. Answer:

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

In experiment #7, you observed the formation of carbon dioxide by reacting baking soda with vinegar. Why was it not possible to relight the candle? A. Carbon dioxide is heavier than air so it stays in the beaker preventing the candle from relighting. B. Carbon dioxide is lighter than air so it escaped from the beaker and the candle should have relit. C. Carbon dioxide is heavier than air so it stays in the beaker and the candle should have relit. D. Carbon dioxide is lighter than air so it escaped from the beaker preventing the candle from relighting.
6. Below you will find experimental data for a magnesium sulfate salt. Use the data to answer the questions. Show all work! Mass of empty crucible and cover Mass of crucible, cover and hydrate Mass of crucible, cover and anhydrate (after 44.36 g 46.79g 45.56 g 45.56 g step 5) Mass of crucible, cover, and anhydrate after 2nd or 3rd heating (after step 6) a) Calculate the mass of anhydrous magnesium sulfate. b) Calculate the moles of anhydrous magnesium sulfate using the molar mass of magnesium sulfate. riven off from the hydrate
Name Lab Partner Section # Date Pre-Lab Assignment: Stoichiometry Lab 1. In a lab experiment similar to the one you are going to do, a student slowly added hy- drochloric acid (HCI) to an evaporating dish containing magnesium carbonate MgCO3. a. Complete and balance the following equation for the reaction between magnesium carbonate and hydrochloric acid. MgCO3 (s) + HCl (aq) → (aq) + H₂CO3(aq) (When writing the formula for the missing product did you consider the charges of the ions?) b. When carbonic acid is formed in a chemical reaction, it is unstable and immedi- ately decomposes into carbon dioxide and water. Rewrite the equation above to show the final products using this information.
Heroin and morphine (shown below) are odorless solids. Drug-sniffing dogs can sometimes locate heroin that has been exposed to the elements because of a strong odor that is present in small quantities. What compound causes the odor and suggest what reaction is responsible for the compound's formation. H3C. но reaction? odor compound? 'N. CHз CHз H3C но herion morphine
Complete the following table, making sure to include your units! Concentration of Concentration of acetic acid Water level on measuring cylinder before reaction 98 mL 91 mL 95 mL 0.5% 0.2% 0.1% ● sodium bicarbonate 0.5 M 0.5 M 0.5 M From the results above, which reactant do you consider to be the limiting reagent? Why? ● Water level on measuring cylinder after reaction 8 mL 49 mL 81 mL Consider the reaction where the concentration of acetic acid was 0.5% and the concentration of sodium bicarbonate was 0.5 M. Complete the table on page 5 to calculate the theoretical yield of CO2 with these concentrations. The following bullet points may help: You have already calculated the amount of sodium bicarbonate in 100 mL In a 100 mL solution of acetic acid at 0.1% there will be 0.1 mL of acetic acid. ● Volume of gas produced The density of acetic acid is 1.05 g/mL. You can use this value to calculate the mass of acetic acid used in the reaction.
Paraffin wax vapor reacts with oxygen gas to form carbon dioxide gas and water vapor. Paraffin wax is a mixture of hydrocarbons having a general chemical formula of CnH2n+2 where n is at least 16. Assume that for this wax n=30 1. Write the symbolic form of this chemical reaction. 2. Classify this chemical reaction and write the general form of this type of reaction. 3. If the wax is a solid at room temperature, why does the reaction state that it is a gas? 4. Explain why the reaction stopped after the glass was placed over the candle. 5. Explain what was on the inside surface of the glass and where it came from.
When answering this problem, report the answer with the appropriate number of significant figures. When entering units, use proper abbreviated units with proper capitalization. A student followed the procedure in this experiment, using 48.92 mL of 1.00 molar HCl and 51.08 mL of 1.00 molar NaOH. Analysis of the collected data resulted in a heat transfer of 2808 J during reaction. Use this information to determine the heat of neutralization for this reaction in kJ/mol. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: ___________*10___ Units______
Mass of crucible and cover 12.73g 2. Mass of crucible, cover, and sample 24.11g 3. Mass of original sample 24.11- 12.73g= 11.97g 4. Mass of crucible, cover, and sample after 1st heating 20.01g 6. Mass of crucible, cover, and sample after 2nd heating (assume that this step was done) 19.98 g 7. Total mass lost by sample during heating what is the percentage of water in the sample? and what is the total mass lost by the sample?
Consider a hypothetical chemical reaction: (In this equation , , and stand for some unknown chemical formulas.) Here is an energy diagram for the reaction: 100 200 300 400 0 Consider a hypothetical chemical reaction: (In this equation , , and stand for some unknown chemical formulas.) Here is an energy diagram for the reaction: 100 200 300 400 0
Convert the word into formula equations, add states, balance and classify Solid copper(II) chloride with elemental hydrogen → solid copper and hydrogen chloride gas: classify: _________ Solid aluminum with (aq) copper(II) nitrate → (aq) aluminum nitrate and solid copper classify: _________ Classify these and all other reactions below by changes in composition (COM, DEC, and/or SDP, or DDP), and as redox (R/O) and combustion (CMB), if applicable.
There are two different reactions you will study in this experiment: a heat of neutralization and a heat of solution reaction. a. Write the balanced chemical equation for the neutralization reaction. Be sure to include charges and phase changes (if appropriate). b. Write the balanced chemical equation for the heat of solution reaction. Be sure to include charges and phase changes (if appropriate). Equation: NH3(g) + HCl(g) → NH4Cl(s)+ Heat per my instructor:(Question 2 isn't looking for the math behind the reactions, just what the balanced chemical equation will look like. So just write out what chemicals/ions will come together to make the ammonium chloride (use your answer to Q1 as a reference for this). 2a is looking for the balanced chemical equation for ammonia and water and 2b is looking for a balanced chemical equation with ammonia and hydrochloric acid.)
Predict the products (if any) that will be formed by the reaction below. If no reaction occurs, write NR after the reaction arrow. Be sure to include the proper phases for all species within the reaction. a.) Al(s) + HCl(aq) → b.) 2 HClO₄(aq) + Co(s) → c.) Ca(s) + LiCl(aq) → d.) FeSO₄(aq) + Zn(s) →