lowing through a solenoid of inductance 7.4 H.    Part(a): Determine the magnetic flux through the solenoid in Webers. Part(b): If the current starts increasing

Q: A long, cylindrical solenoid with 180 turns per centimeter has a radius of 5.5 cm. (a) Neglecting…

A:

Q: me h = 0.500 mm, w = 1.00 mm, and e = 3.00 mm. What is the mutual inductance (in pH) for this…

A: Assume h = 0.500 mm, w = 1.00 mm, and = 3.00 mm.   Consider a strip at a x distance from the wire…

Q: A solenoid with an inductance = 8.0*10^-3 H carries current of 1.0 A. The current in the solenoid…

A: Given, Inductance of solenoid L = 8 x 10-3 H Current I1 = 1A Current I2 = 0 A Time t = 0.1…

Q: Say that a large research solenoid has a self-inductance of L = 1.5 Henry (H). a. You observe a…

A: The objective of this question is to calculate the electromotive force (emf) that was set up by the…

Q: Your answer is partially correct. A long, current-carrying solenoid with an air core has 2200 turns…

A:

Q: Two solenoids are part of the spark coil of an automobile. When the current in one solenoid falls…

A: The mutual inductance between two solenoids can be related to the self-inductance of the two…

Q: A 4.10 x 10 -5 H solenoid is constructed by wrapping 77 turns of wire around a cylinder with a…

A:

Q: There is a tank of width and length of w and a height of 0.6 m. This tank is wrapped around with…

A:

Q: In experiment 8, the induced emf on the second solenoid is measured by a multimeter. What is the…

A: Given : Reading on the multimeter = 0.045 V

Q: A long, cylindrical solenoid with 180 turns per centimeter has a radius of 3.5 cm. (a) Neglecting…

A:

Q: A long solenoid has n=900 turns per meter and a current ? = 3.2 sin(??). Inside the solenoid with a=…

A: n= 900 turn , a= 0.5 m Nc= 100 turns, b= 0.2 m I= 3.2 sin wt

Q: b) An air cored long solenoid of length 8.0 cm and diameter of 10.0 cm is made of 35.0 turns. A…

A: Given data: The length of the solenoid is, L= 8 cm= 0.08 m The diameter of the solenoid is, d= 10…

Q: A 90.0 mH inductor is connected in a circuit. The current through the inductor is given by the…

A: When a conductor is placed inside a varying magnetic field an electromotive force of emf is…

Q: A 5.70 x 10 -5 H solenoid is constructed by wrapping 80 turns of wire around a cylinder with a…

A:

Q: An air-core solenoid has N = 195 turns, d = 0.505 m length, and cross sectional area A = 0.034 m2.…

A: The number of turns in the solenoid: The length of the solenoid: The cross-section area: The current…

Q: The magniotude of the emf induced in an inductor is 1.5V when the current in the inductor is…

A:

Q: A small loop of area 6.8 mm2 is placed inside a long solenoid that has 854 turns/cm and carries a…

A:

Q: A small solenoid with a radius of 11 cm and 115 turns is placed inside a long solenoid (n = 550…

A: Small solenoid radius r = 11 cm = 0.11 m Number of turns of small solenoid N = 115  Long solenoid…

Q: A long, cylindrical solenoid with 100 turns per centimeter has a radius of 1.5 cm. (a) Neglecting…

A: Given, The number of turns, n=100/cm =100×100/m=10000/m, Radius, r=1.5 cm=0.015 m, Current, I= 5.0…

Q: A solenoid of radius 2.30 cm has 480 turns and a length of 15.0 cm. (a) Find its inductance. Apply…

A:

Q: Current through an inductor(L= 0.1 H) is given by i = (t²-6t) A. Find the magnitude of the induced…

A:

Q: A toroidal solenoid has 550 turns, cross-sectional area 6.40 cm^2, and mean radius 4.60 cm. Part A…

A: Given information: Here, N is the number of turns of the toroidal solenoid, A is the…

Q: When the current through an inductor is decreasing at a constant rate of 0.5A/s, the magnitude of…

A:

Q: The figure below shows a circular conducting loop in the presence of an outward non-uniform magnetic…

A: Given: The magnetic field is 0.0006t3. The radius of the coil is 4.8 m. The resistance of the coil…

Q: 3) Figure shows a RL circuit and a conducting rod. RL circuit has ɛ = 30 V, R=10 N, and the time…

A: Value of resistance= 10 ohms Time constant= 1 sec Applied voltage, = 30 v

Q: In the L-C circuit in the figure, the ammeter reads a maximum cur­rent of I = 5.19 mA. The…

A:

Q: A conducting coil, with current i(t) = 5.40e -0.0250 sin(120mt), withi in amperes and t in seconds,…

A: The emf induced in a coil 2 due to a current carrying coil 1 is given by the formula, ε=-Mdidt…

Q: An ac electrical generator is made by turning a flat coil in a uniform constant magnetic field of…

A: Given: Magnetic Field (B)=0.229 TNumber of turns (N)=39Length of the winding (L)=11.0 cmIn…

Q: A 550-turn solenoid, 28 cmcm long, has a diameter of 2.3 cmcm . A 18-turn coil is wound tightly…

A:

Q: A long solenoid (cross-sectional area = 0.98 x 106 m², number of turns per unit length=2789 turns/m)…

A:

Q: Self inductance of an inductor with toroidal geometry is 231 nH. The total number of turns of this…

A: Given data, Inductance of toroidal geometry L=231 mH. Total number of turns N = 16. Current flowing…

Q: A 60.0-m length of insulated copper wire is wound to form a solenoid of radius 2.0 cm. The copper…

A: Since there are multiple sub-parts posted, we will answer the first three sub-parts for you. If you…

Q: A 50.0 mH inductor is connected to an acgenerator with e=30.0 V.What is the amplitude of the…

A: a) The equation for the current amplitude is given by,

Q: An ideal solenid of unknown length and cross-section has an inductance of 4.0mH. When current flows…

A: Given data *The given inductance of the inductor is L = 4.0 mH = 4.0 × 10-3 H *The given induced emf…

Q: A coil with a self-inductance of 2.0 H carries a current that varies with time according to /(t) =…

A: Given that-Current, It= 2.0ASin120πtInductance, L= 2HEMF induced in the coil of…

Q: Suppose a 0.3 m long solenoid with cross-sectional area of 12 cm 2, N 1 = 1400 turns and N 2 = 20…

A:

Q: A solenoid is made from a wire wound around a tube 36.0 cm long having a diameter of 8.00 cm. If…

A:

Q: A powdered iron (Bsat = 1 T) toroid core has µ = 25µ0 (µ0 = 4π × 10-7 H/m). The outside diameter is…

A: The inductance of the toroid be defined as, Where, r be defined as the toroid radius to centreline…

Q: A long solenoid (cross-sectional area = 1.5 x 106 m², number of turns per unit length = 3587…

A: The cross-section area of the solenoid: The number of turns per unit length: The radius of the…

Q: 4) A coil of N,=40 turns and radius 0.5 m surrounds a long solenoid of radius 0.1 m and n=800 turns…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.