List and briefly describe the three types of tolerances used on prints.

Q: Which among the following is a forming process in which thickness of the metal plate is decreased by…

A: Rolling: In this handle, the workpiece within the frame of slab or plate is compressed between two…

Q: 4X .250-20 UNC-2B 1.260±.010 .984±.010 2.600 ø2.012 2.008 Ø 3.350

A: the position tolerance for the diameter hole  2.012/2.008 and the diameter stud 2.006/2.002 position…

Q: 1. A tension-controlled concrete member is one in which the tensile strain in the steel reaches at…

A: (1) According to he ACI code the tensile train in the steel must be reached to the value of at least…

Q: e b a What is the degree of freedom of the mechanism? а. 3 O b. 0 Ос. 1 d. 4 е. 2

A: Degree of freedom is given by the following relation, F=3(l-1)-2j-h Where l=no.of link=4 j=no.of…

Q: Refer to the 1.914 dimension. B) What is its tolerance ? ________________________________ C) What…

A: Tolerance for the given dimension is 0.01. now as tolerance = upper limit - lower limit. and we also…

Q: (USCS units) A GO/NO-GO plug gage is needed to inspect a 1.000 ± 0.020 in diameter hole. A wear…

A:

Q: I need answers for problems 10, 11, and 12 pertaining to the print provided.

A: 10.In general, the reference dimension is used for information purpose only. It doesn’t have any…

Q: 15. On the produced part below, show a simple sketch on how the flatness on the part m verified and…

A: Flatness:- It is defined as the minimum distance between two planes within which all the points on…

Q: Three blocks A, B, and C and a grooved blockD have dimensions a, b, c, and d as follows: a = 37.500…

A:

Q: Find the centroid Y of unsymmetrical I- section shown below with respect to its base

A: Solution:

Q: When the total indicator reading or movement (TIR or TIM) of the dials shown in Figures (a &b) are…

A: The tolerances are measured with the help of a Total indicator reading(TIR) especially  for the…

Q: To which of the following geometric tolerance families does perpendicularly belong?     Form…

A: Orientation tolerance are used to determine the orientation with respect to reference i.e  an datum…

Q: What is the orientation geometric tolerance that is applied to this feature?:  __________ Does the…

A: Given:

Limits, Fits, and Tolerances

The maximum or minimum allowable sizes within which the size of component lies are known as limits. The limits are classified into two types: