knowing that P = 18 Kips, determine the maximum stress when r = 0.45 in and r = 0.70 in

Q: The state of stress at a point in a member is shown on the rectangular stress element in (Eigure 6)…

A: So angle is clockwise and θ=-30°σx=31ksiσy=-38ksiτxy=0

Q: A couple of magnitude M is applied to a square bar of side a. For each of the orientations shown,…

A:

Q: Two solid bars support a load P as shown. Bar (1) has a cross-sectional area of A₁ = 3050 mm² and an…

A:

Q: Problem 4 The horizontal force of p 85 kN acts at the end of the plate. The plate has a thickness of…

A:

Q: The stresses shown act at a point on the free surface of a machine component. Normal and shear…

A: Using transformation equation

Q: Problem No.1. The normal stress on plane pq of a prismatic bar in tension (see figure) is found to…

A:

Q: The split ring shown has an inner radius ₁ = 0.6 in. and a circular cross section of diameter d =…

A:

Q: (2) A square member (400mm x 400mm) sustains an internal shear force of 150 kN and an internal…

A: Given: A square cross section of 400mm × 400mm Shear force = 150KN Bending moment = 250KN-m…

Q: The 2 D stress at a point is given by the matrix Txy 50 15 MPa. The maximum 15 10 6. II = Tyx yy…

A: To Find :The max shear stress ?

Q: Three solid bars, each with square cross sections, make up the axial assembly shown. Two loads of P…

A:

Q: Q2-) For the given 2D stress state [MPa); (Mega: x 10°, Pa: N/m2) a) Find the normal and shear…

A:

Q: Determine the principal stress, the maximum in-plane shear stress, and average normal stress.…

A: Principal stresses:  It is defined as normal stress and shear stress is considered as zero. The…

Q: The Curved beam in the figure has a circular cross section 50mm in diameter. The inside diameter of…

A: Given dataThe value of the force, The diameter of the circular cross-section, The inside diameter…

Q: Determine the average normal stress in each bar if the diameter of each bar is 20 mm. Set P = 40kN.…

A:

Q: 4. The normal stress on plane pq of a prismatic bar in tension (see figure) is found to be 7500 psi.…

A:

Q: Part AB of the bar has a circular cross section with 15-mm radius, and part BC has a circular cross…

A: Objective: To determine the normal stress on perpendicular planes to the bar's axis in part AB and…

Q: the width b₂ required for bar (2) if t

A:

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.