Answered: joists 93 mm wide by 220 mm high,… | bartleby

Related questions

Question

Floor joists 93 mm wide by 220 mm high, simply supported on a 5 m span, carry a floor loaded at 5.6 kPa. What safe floor load in
kPa could be carried on a center-line spacing of 0.4 meters if the allowable bending stress is 6.1 MPa?
Add your answer

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Between each pair of vertebrae in the spinal column is a cylindrical disc of cartilage. Suppose that such a particular disc of cartilage has a a radius of 3.118 cm (100cm = 1 meter) and a thickness of 6.877 mm (1000mm= 1meter). The shear modulus of cartilage is 1.2 × 107 N/m2. Suppose that a shearing force of magnitude 9 N is applied parallel to the top surface of the disc while the bottom surface remains fixed in place. How far does the top surface move relative to the bottom surface in microns (1 meter = 106 microns)?
A vertical solid steel post of diameter d = 26 cm and length L = 2.70 m is required to support a load of mass m = 8400 kg. You can ignore the weight of the post. What is the stress in the post? Express your answer in pascals. What is the strain in the post?
Two wooden members, each having a width of b = 2.4 in. and a depth of d = 0.8 in., are joined by a simple glued scarf joint. Assume B = 47°. If the allowable shear stress for the glue used in the joint is 94 psi, what is the largest axial load P that may be applied? Answer: P = i ! Ib
A plate situated at distance of 7 mm from a fixed plate is moving at velocity of 4 m/s. The gap between the plates is filled with oil with density of 800 kg/m³ and kinematic viscosity of 1,25-10-4 m²/s. What is the shear stress on the surfaces? Round off the answer to an integer in Pa, but enter the answer without the unit. Answer:
Suppose a person’s femoral diaphysis is idealized as a solid circular cylinder with a diameter of 2 cm. The ultimate stress in tension is 120×106 pa. Calculate the maximal tension force the femoral diaphysis can sustain.
The total cross-sectional area of the load-bearing calcified portion of the two forearm bones (radius and ulna) is approximately 2.3 cm2. During a car crash, the forearm is slammed against the dashboard. The arm comes to rest from an initial speed of 80 km/h in 5.1 ms. If the arm has an effective mass of 3.0 kg, what is the compressional stress that the arm withstands during the crash? Pa
A structural steel bar with a 3.6 in. x 0.890 in. rectangular cross section is subjected to a tensile axial load of 54 kips. Determine the maximum normal and shear stresses in the bar. Answer: Omax i ! ksi %3D Tmax = i ksi