Answered: A structural steel bar with a 3.6 in. ×… | bartleby

Related questions

Question

A structural steel bar with a 3.6 in. x 0.890 in. rectangular cross section is subjected to a tensile axial load of 54 kips. Determine the
maximum normal and shear stresses in the bar.
Answer:
Omax
i
!
ksi
%3D
Tmax =
i
ksi

Expert Solution

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A wooden timber is employed as a column under formwork. The timber is nominally 6x8 inches (actual dimensions 5 ½ x 7 %"). If the allowable axial design stress based on this species and grade of wood is 600 psi what is the maximum load that could be safely applied to a short length of this timber used as a column? (You can ignore slenderness criteria). Maximum axial load (include units).
A hollow cortical bone has a maximum compressive stress of 185 MPa. This bone has an area of 6.4 cm². What is the maximum force this bone can withstand in compression, in Newtons?
Member BC has a square cross section. The diameter of the pins at A and B are 3 cm and 2 cm respectively. If the allowable normal stress for member BC is allow = 25 MPa and the allowable shear stress for the pins iS Tallow = 12 MPa, calculate the maximum force intensity w (in N/m). 4 cm В 50° 3 m A W
Two wooden members, each having a width of b = 2.4 in. and a depth of d = 0.8 in., are joined by a simple glued scarf joint. Assume B = 47°. If the allowable shear stress for the glue used in the joint is 94 psi, what is the largest axial load P that may be applied? Answer: P = i ! Ib
The total cross-sectional area of the load-bearing calcified portion of the two forearm bones (radius and ulna) is approximately 2.3 cm2. During a car crash, the forearm is slammed against the dashboard. The arm comes to rest from an initial speed of 80 km/h in 5.1 ms. If the arm has an effective mass of 3.0 kg, what is the compressional stress that the arm withstands during the crash? Pa
OC 0.2 0.3 6 A cube of material is subjected to a compressive stress on each side of its faces. If the Poisson's ratio is 0,25 and the modulus of elasticity is 250 GPa. Calculate the value of the stress if the volume of the cube is reduced by 0.15%. 250MPa 350 MPa 200 MPa 300 MPa 7 A 5-m rod having a uniform cross sectional area of 1000 square mm is secured between two walls 5 meters apart. The load on the rod is zero at 27 deg.Celsius E = 200 GPa and the linear 28°C At H