... is the opposition of the line conductors to the flow of current through them.Select one:a. Capacitanceb. Inductive reactanceC. ResistanceO d. Inductance

The property of resistance is that it opposes flow of electron in a material. When voltage applied…

Answered: is the opposition of the line…

is the opposition of the line conductors to the flow of current through them. Select one: O a. Capacitance O b. Inductive reactance O C. Resistance O d. Inductance

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter29: Dc Generators

Section: Chapter Questions

Problem 5RQ: What are interpoles, and what is their purpose?

See similar textbooks

Related questions

Q: Two coils wound on a common core have L1=0.2 H, L2=0.5 H, and M=0.1 H. The currents are…

A: Given data, The value of inductor L1 = 0.2 H. The value of inductor L2 = 0.5 H. The value for…

Q: onsider a three winding transformer with the following particulars: = 50-40° A. Assume that V₂ is 1=…

A: Solution- THREE WINDING TRANSFORMER Given, Z1=Z2=Z3 = 0.02+j0.08 ohmV2 = 400 VI2 = 60∠-30° AI3…

Q: What is practical application of PWM?

A: PWM stands for pulse width modulation. In this the signal is varied by varying the width of the…

Q: b. three The allowable ampacity of a 4 AWG THHN conductor is 95 amperes. If we have four 4 AWG THHN…

Q: A flux of 0.0016 Wb flows in a silicon sheet steel coil/core. The arrangement appears as shown below…

Q: Give the suitable solution for the following The non-conventional sources of energy are... The…

A: Non conventional energy sourcesLocation considerations of Diesel power station.D.C resistance…

Q: 150 kv single core cable has a radius of cable of 5cm. The insulation martial has two layers. The…

A: Given Data; 33 kV,Single core cable Radius of cable=5cm minimum electric stress of , first layer=30…

Concept explainers

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.

Question

... is the opposition of the line conductors to the flow of current through them.
Select one:
a. Capacitance
b. Inductive reactance
C. Resistance
O d. Inductance

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

I need the answer as soon as possible
Q.4/ choose true or false: 1. The reluctance of any core is proportional directly with the length of it and inversely with both the permeability and the cross-section area of it. 2. The number of parallel paths in wave windings is equal to twice of the number of poles. 3. In dc machines with same values of Z, N, Ø, the emf for wave winding type is more than emf of lab winding type. 4. If we insert a current in such a conductor subjected to a constant magnetic field, a movement will achieved giving the principle of electric generator.
GENERAL RLC CIRCUITS: Solve and show your solution completely. Make sure your answers are in 4 decimals places. The ohmic resistance of a large magnetic contactor is measured to be 20 ohms. A 230 V 60 Hzis impressed upon the contactor and the current is taken as 3.2 amperes. Neglecting core loss,determine the inductance of the contactor in mH.
A ferromagnetic core with a relative permeability of 1500 is shown in the Figure. The dimensions are shown in the diagram, and the depth of the core is 5cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. Because of the fringing effects, the effective area of the air gaps is 5 percent larger than their physical size. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what are the flux values for the left, center, and right legs of the core? What is the magnetic field in each air gap? |7 cm 7 cm 7 cm to 30 cm 30 cm 7 cm 30 cm 0.07 cm 300 turns 0.05 cm 7 cm Core depth = 5 cm
Give the suitable solution for the following The non-conventional sources of energy are........ The diesel power station cannot be located at any place (T or F) The d.c resistance of various types of conductors at specified temperature (T) is found by...... The self-GMD of a conductor depends upon the ...... ...... and ..................of the conductor The voltage drop is increased if the length of transmission line is increased (T or F) The skin effect depends upon the.............. ........ and ********* , and..... …........
constant. 15 cm core depth = 15 cm Problem 2 A ferromagnetic core with a relative permeability of 2000 is shown in Figure. The dimensions are as shown in the diagram, and the depth of the core is 7 cm. The air gaps on the left and right sides of the core are 0.050 and 0.070 cm, respectively. If there are 300 turns in the coil wrapped around the center leg of the core and if the current in the coil is 1.0 A, what is the flux in each of the left, center, and right legs of the core? What is the flux density in each air gap? |7 cm 30 cm 7 cm 7 cm 30 cm 7 cm 30 cm -0,05 cm 300 turns 0.07 cm 7 cm 1|Page
What are interpoles, and what is their purpose?
A ferromagnetic core is shown below. The depth of the core is 5 cm. The other dimensions of the core are as shown in the figure. Find the value of the current that will produce a flux of 0.003 Wb. With this current, what is the flux density at the top of the core? What is the flux density at the right side of the core? Assume that the relative permeability of the core is 1000. 1. - 10 cm--- - 20 cm - 15 cm 500 tums 15 cm 15 cm [1.21 A, 0.4 T, 1.2 T]
3. Find the capacitance per unit length of the single-phase line shown below. Conductors a, b, c are of 0.2 cm radius, and conductors d and e are of 0.4 cm radius. Oa 4m Oe 6ide X Side Y
In short explain the dependency of the energy storage in the inductor on the dimension and the flux density. OR In short state the relation between the inductor energy and the dimension of condcutor and their flux density. Both are same question.
The core of a transformer operating at 50 Hz has an eddy current loss of 100 W/m3 and the corelaminations have a thickness of 0.50 mm. The core is redesigned so as to operate with the same eddycurrent loss but at a different voltage and at a frequency of 250 Hz. Assuming that at the new voltage themaximum flux density is one-third of its original value and the resistivity of the core remains unaltered,determine the necessary new thickness of the laminations. Clear and detailed solution.
A ring of ferromagnetic material has a rectangular section. The inner diameter is 15 cm.The outer diameter is 24 cm. And the thickness is 5 cm. There is a coil of 500 turns wound onthe ring. When the coil has a current of 10 A, the flux in the core is 0.0007 Wb. Theaverage length of the ring is Ln=0.66m Determine:a) The magnetomotive force.b) The intensity of the magnetic field and the flux density.c) Reluctance, permeability and relative permeability.