Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a straight, horizontal piece h = 28.0 cm long, an elbow, and a straight vertical piece l = 152 cm long(figure below). A stud and a second-story floorboard hold the ends of this section of copper pipe stationary. Find the magnitude and direction of the displacement of the pipe elbow when thecoordinate system with it's origin at the elbow, the +x-axis to the right in line with the horizontalwater flow is turned on, raising the temperature of the pipe from 18.0°C to 43.6°C. (Assumepipe and the +y-axis going upward.)0.6568Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at leastfour-digit accuracy to minimize roundoff error. mm79.57magnitudedirection° (clockwise from the +x-axis)Need Help?Read It

Answered: Image /qna-images/answer/f8c16bf1-0cdf-4f6c-873c-156680b2e2c6.jpg

Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a straight, horizontal piece h = 28.0 cm long, an elbow, and a straight vertical piece l = 152 cm long (figure below). A stud and a second-story floorboard hold the ends of this section of copper pipe stationary. Find the magnitude and direction of the displacement of the pipe elbow when the water flow is turned on, raising the temperature of the pipe from 18.0°C to 43.6°C. (Assume a coordinate system with it's origin at the elbow, the +x-axis to the right in line with the horizontal pipe and the +y-axis going upward.) 0.6568 Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. mm 79.57 magnitude direction v • (clockwise from the +x-axis)

Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a straight, horizontal piece h = 28.0 cm long, an elbow, and a straight vertical piece l = 152 cm long (figure below). A stud and a second-story floorboard hold the ends of this section of copper pipe stationary. Find the magnitude and direction of the displacement of the pipe elbow when the water flow is turned on, raising the temperature of the pipe from 18.0°C to 43.6°C. (Assume a coordinate system with it's origin at the elbow, the +x-axis to the right in line with the horizontal pipe and the +y-axis going upward.) 0.6568 Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least four-digit accuracy to minimize roundoff error. mm 79.57 magnitude direction v • (clockwise from the +x-axis)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: An electric coffeemaker has a 610-W heating element. The specific heat of water is 4.19 × 103…

A: Given data: Power (P) = 610 W Specific heat capacity (c) = 4.19×103 J/kg.°C Initial temperature…

Q: A gold engagement ring has an inner diameter of 1.5 × 10−2 m and a temperature of 27 °C. The ring…

Q: A copper telephone wire has essentially no sag between poles 34.0 m apart on a winter day when the…

A: Given data: Original Length (L0) = 34.0 m Initial temperature (T0) = -20.0°C Final temperature (T)…

Q: You need to precisely measure the dimensions of a large wood panel for construction project. Your…

A: Due to hot atmosphere some expansion of metal tape will be there. Due to which u will get some error…

Q: A perfectly insulating cylindrical glass is partially full of water. At the top of the water is a…

Q: Problem 2: A 0.55-liter bottle is heated using a burner; see image (a). When the air inside the…

A: Given Data:Volume Temperature 1 Atmospheric pressure Temperature 2 It is known that:Gas constant To…

Q: A length of a cast iron piping is 50.0m when it carries hot water at 80 degress celcius . When the…

A: Original length, Lo = 50 m Initial temperature, Ti = 80° C Final temperature, Tf = 20° C Final…

Q: Light bulb 1 operates with a filament temperature of 2900 K, whereas light bulb 2 has a filament…

A: Step 1:Step 2:

Q: A student walking to class on a cold day (To = 1 °C) find a silver ring with an inner diameter of D…

A: Given data: Initial temperature is, To = 1 °C Initial inner diameter of the silver ring is, D = 1.75…

Q: Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a…

A: Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a…

Q: A hot air balloon is designed to support the basket, the cables, and a person, which corresponds to…

Q: Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a…

A: The thermal expansion be defined as, ∆L=Lα∆T Where, ΔL be defined as the changed length L be defined…

Q: a square hole 8.00 cm along each side is cut in a sheet of copper. (a) Calculate the change in the…

A: Given : ∆T=50∘C a=8 cm=0.08 m

Q: An electrician is wiring new electrical outlets in a house and has stored a 43.5-m length of copper…

A: Given data : Initial length Lo= 43.5 m T1=-11.90C T2=21.50C It is known that the coefficient of…

Q: You need to precisely measure the dimensions of a large wood panel for a construction project. Your…

Q: A hollow silver (?Ag = 1.050 ✕ 104 kg/m3) spherical shell of mass m = 0.9140 kg floats in…

Q: Light bulb 1 operates with a filament temperature of 2400 K, whereas light bulb 2 has a filament…

A: The expression for heat emitted by bulb 1 is ......…

Q: An electrician is wiring new electrical outlets in a house and has stored a 44.0-m length of copper…

A: Given data, the length of the copper wire is L = 44 m = 4400 cmThe outside temperature of the…

Q: A gold filament of length L = 12 cm when its temperature is 20° C is heated up to a temperature of…

Q: The column of mercury in a barometer (see Figure below) has a height of 0.780m when temperature is…

Q: A steel water pipe, of inside diameter 25 mm and outside diameter 30 mm, is rigidly attached at two…

Q: A copper telephone wire has essentially no sag between poles 36.0 m apart on a winter day when the…

A: Given data: Length (L) = 36.0 m Initial temperature (T0) = -20.0°C Final temperature (T) = 40.0°C…

Q: A copper rod has a length of 1.5m1.5m and a cross-sectional area of 4.0×10−4m24.0×10−4m2. One end…

Q: c). A conductor transfers heat of 1500 J across its length of 20cm in 6 seconds. Given that its…

A: Given: The heat transfer is 1500 J. The length of the conductor is 20 cm. Th time taken is 6 s. The…

Q: An extension cord that you would use for a lamp is much thinner than an extension cord recommended…

A: Heat generated in any resistance depends on the square of current and resistance of the circuit. H =…

Q: hollow silver (?Ag = 1.050 ✕ 104 kg/m3) spherical shell of mass m = 0.9840 kg floats in water with…

Concept explainers

Energy transfer

The flow of energy from one region to another region is referred to as energy transfer. Since energy is quantitative; it must be transferred to a body or a material to work or to heat the system.

Molar Specific Heat

Heat capacity is the amount of heat energy absorbed or released by a chemical substance per the change in temperature of that substance. The change in heat is also called enthalpy. The SI unit of heat capacity is Joules per Kelvin, which is (J K-1)

Thermal Properties of Matter

Thermal energy is described as one of the form of heat energy which flows from one body of higher temperature to the other with the lower temperature when these two bodies are placed in contact to each other. Heat is described as the form of energy which is transferred between the two systems or in between the systems and their surrounding by the virtue of difference in temperature. Calorimetry is that branch of science which helps in measuring the changes which are taking place in the heat energy of a given body.

Question

Inside the wall of a house, an L-shaped section of hot-water pipe consists of three parts: a straight, horizontal piece h = 28.0 cm long, an elbow, and a straight vertical piece l = 152 cm long
(figure below). A stud and a second-story floorboard hold the ends of this section of copper pipe stationary. Find the magnitude and direction of the displacement of the pipe elbow when the
coordinate system with it's origin at the elbow, the +x-axis to the right in line with the horizontal
water flow is turned on, raising the temperature of the pipe from 18.0°C to 43.6°C. (Assume
pipe and the +y-axis going upward.)
0.6568
Your response is within 10% of the correct value. This may be due to roundoff error, or you could have a mistake in your calculation. Carry out all intermediate results to at least
four-digit accuracy to minimize roundoff error. mm
79.57
magnitude
direction
° (clockwise from the +x-axis)
Need Help?
Read It

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A pot of water is boiling under one atmosphere of pressure. Assume that heat enters the pot only through its bottom, which is copper and rests on a heating element. In two minutes, the mass of water boiled away is m = 3.5 kg. The radius of the pot bottom is R = 7.5 cm and the thickness is L = 1.0 mm. What is the temperature of the heating element in contact with the pot?
The intensity of solar radiation reaching the Earth is 1,340 W/m2. If the sun has a radius of 7.000 × 108 m, is a perfect radiator and is located 1.500 × 1011 m from the Earth, then what is the temperature of the sun?
1 kg of coffee, originally at 95°C, is placed into a .3 kg aluminum cup. After some time, you pour 0.2 kg of milk, whose initial temperature was 5°C. What will be the final equilibrium temperatur of this system? Let: J Ccoffee = 4186 kg K J CAI = 500 kg K J CMilk = 3000 kg K
Light bulb 1 operates with a filament temperature of 2700 K, whereas light bulb 2 has a filament temperature of 1700 K. Both filaments have the same emissivity, and both bulbs radiate the same power. Find the ratio A1/A2 of the filament areas of the bulbs.
Many hot water heating systems have a reservoir tank connected directly to the pipeline, to allow for expansion when the water becomes hot. The heating system of a house has 76 m of a copper pipe whose inside radius is 9.5 x 10^ -3 m. When the water and pipe are heated from 24 Celcius to 78 Celcius, what must be the minimum volume of the reservoir tank to hold the overflow of water?
By how many degrees Celsius do you need to raise the temperature of a copper rod in order to increase its length by 5%? The linear expansion factor for copper is 17×10-6 /°C.
A student walking to class on a cold day (To = -1 °C) find a silver ring with an inner diameter of D = 1.7 cm. The silver has a coefficient of linear expansion of α = 19.5 × 10-6 1/C. What is the change in diameter in mm if Tb=37 C ?
At room temperature(25°C), a 5.000-mm-diameter tungsten pin is too large for a 4.999-mm-diameter hole in a nickel bar. To what temperature must these two parts be heated in order for the pinto just fit? (coefficient of thermal expansion for nickel = 12.7 × 10^-6 mm/mm°C, coefficient of thermal expansion for nickel = 4.5 × 10^-6 mm/mm°C)
The ends of a cylindrical copper rod are maintained at two different temperatures. The rod conducts heat from one end to the other at a rate of 41 J/s. At what rate would a copper rod three times as long and one-third the diameter conduct heat between the same two temperatures? O 4.6 J/s O 1.5 J/s O Same rate O 13.7 J/s O 123 J/s
Water is boiling in an aluminum pan placed on an electrical element on a stovetop. The sauce pan has a bottom that is 0.800 cm thick and 14.0 cm in diameter. The boiling water is evaporating at the rate of 1.00 g/s. What is the temperature difference across (through) the bottom of the pan?
The primary and secondary mirrors of a space telescope are assembled using zerodur spacers in an engineering laboratory in which the room temperature is 20 degrees C. In space the telescope will drop to -30 degrees C. If the distance between the mirrors is exactly 80 cm in the lab, how much would the length of the zerodur spacer change in space? The properties of the material zerodur can be found in the table. Coefficient of thermal expansion is 2x10^-8 K^-1 and specific heat is 3347.20 J/kg/K
The glowing filament in a lamp is radiating energy at a rate of 60 W. At the filament's temperature of 1500° C, the emissivity is 0.23. What is the surface area of the filament? Express your answer in meters squared. A = Submit Request Answer