In the process of drying carrots using a parallel flow drying system, the material with a moisture content of 85% enters the drying system at a rate of 500 Kg / hour to produce dry carrots with a moisture content of 20%. If it is known that hot air used as the drying medium has a humidity ratio of 0.006 Kg of water per Kg of dry air and the flow of hot air enters the system at a rate of 200 Kg of air for each dry matter produced, calculate the ratio of humidity to air leaving the system assuming that the system is under steady state conditions.

Q: Consider a Cu-60wt% Ni-40% alloy , determine the following: (a) The liquidus and solidus temperature…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Sheet material 0.5 cm thick containing 800 kg of dry stock/m³ of original wet stock is to be dried…

A:

Q: Air at dry ball temperature 90 ° C and RH 8% is passed over the cooling coil so that the air dry…

A: Given that, Initial dry bulb temperature T1 = 90oC Initial Relative humidity RH = 8% Dry bulb…

Q: Make a flow chart of the process, showing all the steps in the process and labeling all of the input…

A:

Q: Select all that apply for  saturated vapor:     It refers to a point on a T-v diagram on a specific…

A: The saturated vapor is a substance that exists completely as vapor at its saturation temperature. On…

Q: Air at a dry ball temperature of 75 ° C and RH 4% is passed over the cooling coil until the air ball…

A:

Q: Drying can be characterized as which of the mentioned? a. Unit process b. Unit operation c. Unit…

A: Unit operations and unit processes are the classification of chemical engineering. The set of unit…

Q: In the process of drying carrots using a parallel flow drying system, the material with a moisture…

A: Draw the diagram for the drying of carrots as follows:

Q: Which of the following is the unit operations used in Chemical processing a. Nitration b.…

A: In chemical industries the processes are divided into the following Unit OperationsUnit…

Q: the amount of excess combustion air is normally determined by analysis of stack_____ a) the fuel…

A: Excess air is the air which is used in excess for combustion of various fuels (solids, liquid, and…

Q: Which of the following unit operations in chemical engineering is primarily used for separating…

A: Your answer is Answer: B) Filtration

Q: Produce a scatter plot for windshield water distillation, Vapor temperature along y-axis and volume…

A: Given: Data for distillate volume (mL) and vapor temperature (°C) are as given below: Distillate…

Q: Analyze in the psychometric graph 2 states the first select according to the place where a…

A:

Q: A solution is made by putting 100 g of NaNO3 into 200 mL of water at 70 degrees C.If the solution…

A: Answer Salt precipitates out is NIL A solution is made by putting 100 g of NaNO3 into 200 mL of…

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.